Mixed chloridometallate(ii) ionic liquids with tunable color and optical response for potential ammonia sensors.

Eight d-metal-containing -butylpyridinium ionic liquids (ILs) with the nominal composition (CPy)[NiMCl] or (CPy)[ZnMCl] (M = Cu, Co, Mn, Ni, Zn; CPy = -butylpyridinium) were synthesized, characterized, and investigated for their optical properties. Single crystal and powder X-ray analysis shows that the compounds are isostructural to existing examples based on other d-metal ions. Inductively coupled plasma optical emission spectroscopy measurements confirm that the metal/metal ratio is around 50 : 50.

Photothermomechanical Nanopump: A Flow-Through Plasmonic Sensor at the Fiber Tip.

Optical fibers equipped with plasmonic flow sensors at their tips are fabricated and investigated as photothermomechanical nanopumps for the active transport of target analytes to the sensor surface. The nanopumps are prepared using a bottom-up strategy: i.e.

Microscopic Understanding of Reaction Rates Observed in Plasmon Chemistry of Nanoparticle-Ligand Systems.

Surface-enhanced Raman scattering (SERS) is an effective and widely used technique to study chemical reactions induced or catalyzed by plasmonic substrates, since the experimental setup allows us to trigger and track the reaction simultaneously and identify the products. However, on substrates with plasmonic hotspots, the total signal mainly originates from these nanoscopic volumes with high reactivity and the information about the overall consumption remains obscure in SERS measurements. This has important implications; for example, the apparent reaction order in SERS measurements does not correlate with the real reaction order, whereas the apparent reaction rates are proportional to the real reaction rates as demonstrated by finite-difference time-domain (FDTD) simulations.

The disappearance and return of nanoparticles upon low energy ion irradiation.

Ion irradiation of bulk and thin film materials is tightly connected to well described effects such as sputtering or/and ion beam mixing. However, when a nanoparticle is ion irradiated and the ion range is comparable to the nanoparticle size, these effects are to be reconsidered essentially. This study investigates the morphology changes of silver nanoparticles on top of silicon substrates, being irradiated with Gaions in an energy range from 1 to 30 keV.

Plasmonic Nanohole Arrays on Top of Porous Silicon Sensors: A Win-Win Situation.

Label-free optical sensors are attractive candidates, for example, for detecting toxic substances and monitoring biomolecular interactions. Their performance can be pushed by the design of the sensor through clever material choices and integration of components. In this work, two porous materials, namely, porous silicon and plasmonic nanohole arrays, are combined in order to obtain increased sensitivity and dual-mode sensing capabilities.

Plasmonic biosensors fabricated by galvanic displacement reactions for monitoring biomolecular interactions in real time.

Optical sensors are prepared by reduction of gold ions using freshly etched hydride-terminated porous silicon, and their ability to specifically detect binding between protein A/rabbit IgG and asialofetuin/Erythrina cristagalli lectin is studied. The fabrication process is simple, fast, and reproducible, and does not require complicated lab equipment. The resulting nanostructured gold layer on silicon shows an optical response in the visible range based on the excitation of localized surface plasmon resonance.

One Spot-Two Sensors: Porous Silicon Interferometers in Combination With Gold Nanostructures Showing Localized Surface Plasmon Resonance.

Sensors composed of a porous silicon monolayer covered with a film of nanostructured gold layer, which provide two optical signal transduction methods, are fabricated and thoroughly characterized concerning their sensing performance. For this purpose, silicon substrates were electrochemically etched in order to obtain porous silicon monolayers, which were subsequently immersed in gold salt solution facilitating the formation of a porous gold nanoparticle layer on top of the porous silicon. The deposition process was monitored by reflectance spectroscopy, and the appearance of a dip in the interference pattern of the porous silicon layer was observed.

Fiber optic plasmonic sensors: Providing sensitive biosensor platforms with minimal lab equipment.

A simple, convenient, and inexpensive method to fabricate optical fiber based biosensors which utilize periodic hole arrays in gold films for signal transduction is reported. The process of hole array formation mainly relies on self-assembly of hydrogel microgels in combination with chemical gold film deposition and subsequent transfer of the perforated film onto an optical fiber tip. In the fabrication process solely chemical wet lab techniques are used, avoiding cost-intensive instrumentation or clean room facilities.

In Vitro Monitoring Conformational Changes of Polypeptide Monolayers Using Infrared Plasmonic Nanoantennas.

Proteins and peptides play a predominant role in biochemical reactions of living cells. In these complex environments, not only the constitution of the molecules but also their three-dimensional configuration defines their functionality. This so-called secondary structure of proteins is crucial for understanding their function in living matter.

Dynamics of nanoparticle morphology under low energy ion irradiation.

If nanostructures are irradiated with energetic ions, the mechanism of sputtering becomes important when the ion range matches about the size of the nanoparticle. Gold nanoparticles with diameters of ∼50 nm on top of silicon substrates with a native oxide layer were irradiated by gallium ions with energies ranging from 1 to 30 keV in a focused ion beam system. High resolution in situ scanning electron microscopy imaging permits detailed insights in the dynamics of the morphology change and sputter yield.

Bottom-Up Fabrication of Hybrid Plasmonic Sensors: Gold-Capped Hydrogel Microspheres Embedded in Periodic Metal Hole Arrays.

The high potential of bottom-up fabrication strategies for realizing sophisticated optical sensors combining the high sensitivity of a surface plasmon resonance with the exceptional properties of stimuli-responsive hydrogel is demonstrated. The sensor is composed of a periodic hole array in a gold film whose holes are filled with gold-capped poly(N-isoproyl-acrylamide) (polyNIPAM) microspheres. The production of this sensor relies on a pure chemical approach enabling simple, time-efficient, and cost-efficient preparation of sensor platforms covering areas of cm.

Devising Self-Assembled-Monolayers for Surface-Enhanced Infrared Spectroscopy of pH-Driven Poly-l-lysine Conformational Changes.

Surface-enhanced infrared absorption spectroscopy (SEIRA) is applied to study protein conformational changes. In general, the appropriate functionalization of metal surfaces with biomolecules remains a challenge if the conformation and activity of the biomolecule shall be preserved. Here we present a SEIRA study to monitor pH-induced conformational changes of poly-l-lysine (PLL) covalently bound to a thin gold layer via self-assembled monolayers (SAMs).

Enhanced sputter yields of ion irradiated Au nano particles: energy and size dependence.

Hexagonally arranged Au nanoparticles exhibiting a broad Gaussian-shaped size distribution ranging from 30 nm to 80 nm were deposited on Si substrates and irradiated with Ar(+) and Ga(+) ions with various energies from 20 to 350 keV and 1 to 30 keV, respectively. The size and energy dependence of the sputter yield were measured using high-resolution scanning electron microscopy image analysis. These results were compared to simulation results obtained by iradina, a Monte Carlo code, which takes the specifics of the nano geometry into account.

Bottom-up fabrication of nanohole arrays loaded with gold nanoparticles: extraordinary plasmonic sensors.

A chemical route to periodic hole arrays in gold films whose holes are loaded with single gold nanoparticles is presented, paving the road to mass production of highly sensitive plasmonic sensors on large areas.

Optical characterization of porous silicon monolayers decorated with hydrogel microspheres.

Unlabelled: The optical response of porous silicon (pSi) films, covered with a quasi-hexagonal array of hydrogel microspheres, to immersion in ethanol/water mixtures was investigated. For this study, pSi monolayers were fabricated by electrochemical etching, stabilized by thermal oxidation, and decorated with hydrogel microspheres using spin coating. Reflectance spectra of pSi samples with and without deposited hydrogel microspheres were taken at normal incidence.

Top-up fabrication of gold nanorings.

A simple method for the fabrication of gold nanorings with reliable material composition and reproducible morphology that relies on a combination of top-down and bottom-up techniques is presented. Here, lithographically defined hole arrays are used as templates for the deposition of gold nanoparticles. The resulting gold nanoparticle rings are joined by electroless deposition of gold, thereby leading to the formation of gold nanoring arrays that show plasmonic resonance in their optical spectra at theoretically predicted wavelengths.

Real-time monitoring of electrochemical controlled protein adsorption by a plasmonic nanowire based sensor.

A plasmonic sensor composed of a vertically aligned gold nanowire array was fabricated and employed for the optical detection of protein adsorption induced by an electric field.

Contact line motion on nanorough surfaces: a thermally activated process.

The motion of a solid-liquid-liquid contact line over nanorough surfaces is investigated. The surface nanodefects are varied in size, density, and shape. The dynamics of the three-phase contact line on all nanorough substrates studied is thermally activated.

Photonic crystal sensors based on porous silicon.

Porous silicon has been established as an excellent sensing platform for the optical detection of hazardous chemicals and biomolecular interactions such as DNA hybridization, antigen/antibody binding, and enzymatic reactions. Its porous nature provides a high surface area within a small volume, which can be easily controlled by changing the pore sizes. As the porosity and consequently the refractive index of an etched porous silicon layer depends on the electrochemial etching conditions photonic crystals composed of multilayered porous silicon films with well-resolved and narrow optical reflectivity features can easily be obtained.

Fabrication of porous silicon by metal-assisted etching using highly ordered gold nanoparticle arrays.

A simple method for the fabrication of porous silicon (Si) by metal-assisted etching was developed using gold nanoparticles as catalytic sites. The etching masks were prepared by spin-coating of colloidal gold nanoparticles onto Si. An appropriate functionalization of the gold nanoparticle surface prior to the deposition step enabled the formation of quasi-hexagonally ordered arrays by self-assembly which were translated into an array of pores by subsequent etching in HF solution containing H2O2.

Antireflective subwavelength structures on microlens arrays-comparison of various manufacturing techniques.

Antireflective subwavelength structures (ARS) resembling nanostructures found on the cornea of night-active insects reduce the reflection of light by providing a gradual change in the refractive index at the interface. These artificial ARS have mainly been fabricated by a combination of conventional lithography and reactive ion etching, which constrains their application to planar substrates. We report on the fabrication of ARS using three different techniques including bottom-up and top-down methods as well as their combination on microlens arrays (MLAs) made of fused silica.

Fabrication of multi-parametric platforms based on nanocone arrays for determination of cellular response.

Cellular response to both surface topography and surface chemistry has been studied for several years. However, most of the studies focus on only one of the two parameters and do not consider their possible synergistic effects. Here, we report on a fabrication method for nanostructured surfaces composed of highly ordered arrays of silica nanocones with gold tips.

Self-assembled plasmonic core-shell clusters with an isotropic magnetic dipole response in the visible range.

We theoretically analyze, fabricate, and characterize a three-dimensional plasmonic nanostructure that exhibits a strong and isotropic magnetic response in the visible spectral domain. Using two different bottom-up approaches that rely on self-organization and colloidal nanochemistry, we fabricate clusters consisting of dielectric core spheres, which are smaller than the wavelength of the incident radiation and are decorated by a large number of metallic nanospheres. Hence, despite having a complicated inner geometry, such a core-shell particle is sufficiently small to be perceived as an individual object in the far field.

Nanopatterning by block copolymer micelle nanolithography and bioinspired applications.

This comprehensive overview of block copolymer micelle nanolithography (BCMN) will discuss the synthesis of inorganic nanoparticle arrays by means of micellar diblock copolymer approach and the resulting experimental control of individual structural parameters of the nanopattern, e.g., particle density and particle size.

Simulating different manufactured antireflective sub-wavelength structures considering the influence of local topographic variations.

Laterally structured antireflective sub-wavelength structures show unique properties with respect to broadband performance, damage threshold and thermal stability. Thus they are superior to classical layer based antireflective coatings for a number of applications. Dependent on the selected fabrication technology the local topography of the periodic structure may deviate from the perfect repetition of a sub-wavelength unit cell.