Evaluation of the Efficiency of Ethanol Precipitation and Ultrafiltration on the Purification and Characteristics of Exopolysaccharides Produced by Three Lactic Acid Bacteria.

Exopolysaccharides (EPS) produced by three Lactic Acid Bacteria strains, SLT10, C7, and B3, were isolated using two methods: ethanol precipitation (EPS-ETOH) and ultrafiltration (EPS-UF) through a 10 KDa cut-off membrane. EPS recovery by ultrafiltration was higher than ethanol precipitation for SLT10 and C7. However, it was similar with both methods for B3.

Identification of polysaccharides extracted from pea pod by-products and evaluation of their biological and functional properties.

A three-variable Box-Behnken design was employed to obtain the best possible combination of extraction time, ratio (raw material/water) and extraction temperature to allow maximum extraction yield of polysaccharides from pea pod (PPP). The preferred extraction conditions were: extraction time 195 min, extraction temperature 70 °C and ratio of raw material/water 1/40. Under these conditions, the experimental yield was 16.

Structural, functional, and biological properties of potato peel oligosaccharides.

Enzymatic hydrolysis of water-soluble polysaccharides from potato peel waste (PPPW) generates low molecular weight oligosaccharides with a yield of 63%. The oligosaccharides generated from potato peel polysaccharides (OPPP) were purified by Superdex-30 column. The results showed the presence of 8 peaks (OPPP1-OPPP8).

Water-soluble polysaccharides and hemicelluloses from almond gum: Functional and prebiotic properties.

This paper describes the extraction of polysaccharides (AGP) and hemicelluloses (AGH) from almond gum by hot water and alkaline solution, respectively. Structural and functional properties of the extracted polymers were then determined. For this purpose, infrared spectroscopy was first used to characterize functional groups of both polymers.

Optimization of polysaccharides extraction from watermelon rinds: Structure, functional and biological activities.

In the present work, optimization of hot water extraction, structural characteristics, functional properties, and biological activities of polysaccharides extracted from watermelon rinds (WMRP) were investigated. The physicochemical characteristics and the monosaccharide composition of these polysaccharides were then determined using chemical composition analysis, Fourier transform infrared (FT-IR) spectroscopy, scanning electron microscopy (SEM) and gas chromatography-flame ionization detection (GC-FID). SEM images showed that extracted polysaccharides had a rough surface with many cavities.

Structural, functional, and antioxidant properties of water-soluble polysaccharides from potatoes peels.

Water-soluble polysaccharides were extracted from potato peel waste (PPW). The structure of the polysaccharides from PPW (PPPW) was examined by means of Fourier transform-infrared spectroscopy (FT-IR) analysis, X-ray diffractometry (XRD) and gas chromatography-mass spectrometry (GC-MS). The results suggest that the extracted polysaccharides form a semi-crystalline polymer constituted essentially of the functional groups CO, CH and OH.

Healing efficiency of oligosaccharides generated from almond gum (Prunus amygdalus) on dermal wounds of adult rats.

Almond gum is a naturally occurring polymer produced by almond trees and shrubs. Its abundance, as well as its low cost production makes it a potential feedstock for use in food and pharmaceuticals. In this regard, almond gum oligosaccharides were enzymatically generated, purified and their monosaccharide composition assessed using gas chromatography-flame ionization detector.

Structural data and biological properties of almond gum oligosaccharide: application to beef meat preservation.

Enzymatic hydrolysis of almond gum generates low molecular weight oligosaccharides (OAG) with a yield of 33.5%. The generated oligosaccharides were purified and identified.