A New Method for Compression Testing of Reinforced Polymers.

Compressive testing of specimens taken from relatively thin composite plates is difficult, especially due to the occurrence of buckling. To prevent buckling, the central portion of the specimens used for the compression test has smaller dimensions, and the specimens can be guided along their entire length. For these reasons, optical methods, such as digital image correlation (DIC), cannot be used for the compression test and strain rosettes cannot be glued onto the samples to determine Poisson's ratio.

Analysis of the Effect of Fiber Orientation on Mechanical and Elastic Characteristics at Axial Stresses of GFRP Used in Wind Turbine Blades.

Due to its physical and mechanical properties, glass-fiber-reinforced polymer (GFRP) is utilized in wind turbine blades. The loads given to the blades of wind turbines, particularly those operating offshore, are relatively significant. In addition to the typical static stresses, there are also large dynamic stresses, which are mostly induced by wind-direction changes.

Evaluation of the Fatigue Behavior and Failure Mechanisms of 4340 Steel Coated with WIP-C1 (Ni/CrC) by Cold Spray.

Fatigue behavior of standardized 4340 steel samples uniformly coated with WIP-C1 (Ni/CrC) by cold spray was investigated. In particular, when a crack appeared at the interface between the base material and the coating, the cause of it as well as its shape and size were investigated. Fatigue loading was applied by alternating symmetrical cycles.

Structural Testing by Torsion of Scalable Wind Turbine Blades.

In life service, the wind turbine blades are subjected to compound loading: torsion, bending, and traction, all these resulting in the occurrence of normal and tangential stresses. At some points, the equivalent stresses, due to overlapping effects provided by normal and shear stresses, can have high values, close to those for which the structure can reach to the failure point. If the effects of erosion and clashes with foreign bodies are added, the structure of the blade may lose its integrity.

Evaluation of the Fatigue Behaviour and Failure Mechanisms of 52100 Steel Coated with WIP-C1 (Ni/CrC) by Cold Spray.

Cold spray technique has been major improved in the last decades, for studying new properties for metals and alloys of aluminum, copper, nickel, and titanium, as well as steels, stainless steel and other types of alloys. Cold sprayed Ni/CrC coatings have the potential to provide a barrier as well as improved protection to steels. Fatigue characteristics of 52100 steel coated with Ni/Chrome-Carbide (Ni/CrC) powder mixture by using cold gas dynamic spray are investigated.