Introduction: The aim of this systematic review and meta-analysis was to compare the performance of first-line contact aspiration (ASP) and stent retriever (SR) in acute ischemic stroke caused by proximal large vessel occlusion.
Methods: Cochrane databases, MEDLINE and EMBASE were systematically searched for literatures reporting outcomes on thrombectomy with both first-line aspiration and first-line stent retriever in proximal occlusion.
Results: Thirteen studies with a total of 1614 patients were included.
The catalytic hairpin DNA assembly-programmed active Mg(2+)-dependent DNAzyme was proposed for dual-signal amplified detection toward protein and DNA. The protein detection was implemented with the further combination of an additional terminal protection strategy. The detection limit toward avidin and target DNA could be achieved as 2 pM and 0.
View Article and Find Full Text PDFBecause of the intrinsic importance of nucleic acid as bio-targets, the simple and sensitive detection of nucleic acid is very essential for biological studies and medical diagnostics. Herein, a simple, isothermal and highly sensitive fluorescence detection of target DNA was developed with the combination of exonuclease III (Exo III)-assisted cascade target recycling and DNAzyme amplification. A hairpin DNA probe was designed, which contained the 3'-protruding DNA fragment as target recognition unit, the caged DNA fragment in the stem region as target analogue, and the caged 8-17 DNAzyme sequence in the loop region as signal response unit.
View Article and Find Full Text PDFHomogenous electrochemical biosensor has attracted substantial attention owing to its simplicity, rapid response, and improved recognition efficiency compared with heterogeneous biosensor, but the relatively low detection sensitivity and the limited detection analytes prohibit its potential applications. To address these issues, herein, a simple, rapid, isothermal, and ultrasensitive homogeneous electrochemical DNA biosensing platform for target DNA and protein detection has been developed on the basis of an exonuclease III (Exo III)-aided autocatalytic target recycling strategy. A ferrocene-labeled hairpin probe (HP1) is ingeniously designed, which contains a protruding DNA fragment at 3'-termini as the recognition unit for target DNA.
View Article and Find Full Text PDFHybridization chain reaction (HCR) strategy has been well developed for the fabrication of various biosensing platforms for signal amplification. Herein, a novel enzyme-free and label-free ultrasensitive electrochemical DNA biosensing platform for the detection of target DNA and adenosine triphosphate (ATP) was firstly proposed, in which three auxiliary DNA probes were ingeniously designed to construct the dendritic DNA concatamer via HCR strategy and used as hexaammineruthenium(III) chloride (RuHex) carrier for signal amplification. With the developed dendritic DNA concatamer-based signal amplification strategy, the DNA biosensor could achieve an ultrasensitive electrochemical detection of DNA and ATP with a superior detection limit as low as 5 aM and 20 fM, respectively, and also demonstrate a high selectivity for DNA and ATP detection.
View Article and Find Full Text PDFIn current study, a dual strategy for sensitive detection of T4 polynucleotide kinase (T4 PNK) activity was proposed, which combined split DNAzyme-based background reduction with ligation-triggered DNAzyme cascade for signal amplification. The 8-17 DNAzyme is split into two separate oligonucleotide fragments, which can be separately hybridized to the template DNA to form a ligatable nick after one of the fragments is phosphorylated at the 5at the yl by T4 PNK. With the further addition of Escherichia coli DNA ligase, the two oligonucleotides can be ligated to produce the activated 8-17 DNAzyme, the amount of which is positively related to the activity of T4 PNK.
View Article and Find Full Text PDFAn isothermal, enzyme-free and ultrasensitive protocol for electrochemical detection of DNA is proposed based on the ingenious combination of target catalyzed hairpin assembly and hybridization chain reaction (HCR) strategies for two-step signal amplification. The DNA hairpin assembly on the electrode is triggered by target DNA, accompanied by the release of target DNA for the successive hybridization and assembly process. The newly emerging DNA fragment on the electrode after hairpin assembly is further used to propagate the HCR between methylene blue-labeled signal probe and auxiliary probe, inducing a remarkably amplified electrochemical signal.
View Article and Find Full Text PDF