Optimisation of ICP-MS collision/reaction cell conditions for the determination of elements likely to be interfered (V, Cr, Fe, Co, Ni, As and Se) in foodstuffs.

A strategy for the accurate determination in foodstuffs of seven elements liable to be interfered with (V, Cr, Fe, Co, Ni, As and Se), was successfully applied. Firstly, to reduce spectroscopic interferences, four influential factors (hexapole and quadrupole bias, helium and hydrogen flows) of the collision/reaction cell device were optimised through the experimental design methodology. Secondly, non-spectroscopic interferences, which may severely disturb the analysis of matrices containing large amounts of non-target elements, were significantly reduced by a limited decrease in the flow rate of the optimum initial nebuliser rather than with a specific time-consuming dilution.

Determination of 20 trace elements in fish and other seafood from the French market.

The levels of 20 essential or toxic trace elements in 159 fish, other seafood and seafood products on the French coastal market collected between January and April 2005 were measured by ICP-MS. The concentration ranges (mg/kg of fresh mass) for the elements determined were compared with previous studies. The contents of Co, Cu, Fe, Li, Mn, Se, Zn and Pb found in fish are close to or often lower than previous studies.

Pb, Hg, Cd, As, Sb and Al levels in foodstuffs from the 2nd French total diet study.

In 2006, the French Food Safety Agency (AFSSA) conducted the second French total diet study (TDS) to estimate dietary exposures of main minerals and trace elements from 1319 samples of foods habitually consumed by the French population. The foodstuffs were analysed by ICP-MS after microwave-assisted digestion. Contamination data for lead, mercury, cadmium, arsenic, antimony and aluminium were reported and compared with results from the previous French total diet study.

Determination of calcium, magnesium, sodium, and potassium in foodstuffs by using a microsampling flame atomic absorption spectrometric method after closed-vessel microwave digestion: method validation.

This paper describes a validation process in compliance with the NFIEN ISO/IEC 17025 standard for the determination of the macrominerals calcium, magnesium, sodium, and potassium in foodstuffs by microsampling with flame atomic absorption spectrometry after closed-vessel microwave digestion. The French Standards Commission (Agence Francaise de Normalisation) standards NF V03-110, NF EN V03-115, and XP T-90-210 were used to evaluate this method. The method was validated in the context of an analysis of the 1322 food samples of the second French Total Diet Study (TDS).

Simultaneous analysis of cadmium, lead, mercury, and arsenic content in foodstuffs of animal origin by inductively coupled plasma/mass spectrometry after closed vessel microwave digestion: method validation.

A method validation of the total analysis of cadmium (Cd), lead (Pb), arsenic (As), and mercury (Hg) in foodstuffs by inductively coupled plasma/mass spectrometry (ICP/MS) after closed vessel microwave digestion is presented. Due to the lack of reference method for ICP/MS techniques in food and, based on the project of the European Committee of Normalization (CEN/TC 275/WG 10), the Agence Française de Normalisation (AFNOR) guidelines NF V03-110 were used for the evaluation of this method based on 2 steps, sample preparation and multielement detection. Several criteria considered as compulsory (linearity, specificity, precision under repeatability conditions, and trueness) have been estimated and discussed, in addition to intermediate precision reproducibility, the limit of detection, and the limit of quantification.