Evaluation of solar photovoltaic carport canopy with electric vehicle charging potential.

While sustainable mobility and decarbonization of transportation sector are among the most comprehensive solutions to the problem of climate change, electric vehicles (EV) are becoming increasingly popular as the future mode of transport. In this study, the integration of a solar carport canopy to a potential EV charging station is analyzed using various operating conditions. A detailed analysis has been provided for the carport located in southern Taiwan, Kaohsiung city, where electricity generation, emission impacts, and financial analysis of the solar EV charging station are discussed.

Novel design of amine and metal hydroxide functional group modified onto sludge biochar for arsenic removal.

This study involved novel-designed sludge biochar (SB) adsorbed for arsenic removal with lower operating costs and higher adsorption efficiency properties. Generally, biochar only relies on micropores for pollutant adsorption, but physical adsorption is not highly efficient for arsenic removal. Therefore, in order to improve the removal efficiency of arsenic by SB, diethylenetriamine (DETA) and FeCl were used in this study to modify the surface of SB by an immersion method.

Preparation of Metal Modified onto Biochar from Hazardous Waste for Arsenic Removal.

Use of urban sludge, hospital sludge, and aquatic product sludge as a biochar adsorbent from wastewater treatment plants was investigated. Microwave carbonization was used to carbonize the sludge and then chemically activated at high temperatures to increase porosity and surface area. Effective of arsenic adsorption in water presents a newly designed metal doped to biochar.

A breakthrough dynamic-osmotic membrane bioreactor/nanofiltration hybrid system for real municipal wastewater treatment and reuse.

This study designed a Dynamic-Osmotic membrane bioreactor/nanofiltration (OsMBR/NF) system for municipal wastewater treatment and reuse. Results indicated that a continuously rotating FO module with 60 RPM in Dynamic-OsMBR system could enhance shear stress and reduce cake layer of foulants, leading to higher flux (50%) compared to Traditional-OsMBR during a 40-operation day. A negligible specific reverse salt flux (0.

Adsorption Configurations of Iron Complexes on As(III) Adsorption Over Sludge Biochar Surface.

Waste recycling and reuse will result in significant material and energy savings. In this research, usage of hospital sludge as a biochar adsorbent for wastewater treatment plants was investigated. Microwave carbonization was used to carbonize the sludge and then chemically activated with ZnCl₂to increase surface area and porosity.

Aqueous Oxytetracycline and Norfloxacin Sonocatalytic Degradation in the Presence of Peroxydisulfate with Multilayer Sheet-Like Zinc Oxide.

Multilayer ZnO sheet-like flakes were synthesized by a simple method of precipitation and characterized by the techniques of X-Ray Diffraction (XRD) and Scanning Electron Microscopy (SEM). The findings are proven that the SEM images show the overall morphology of a single sheet-like ZnO nanostructure made from uniformly thick nano-sheets. In an aqueous environment, the acoustic ability of the prepared material was assessed using ultrasound (US) radiation to degrade oxytetracycline (OTC) and norfloxacin (NF).

Augmentation of Photocatalytic Degradation of Oxytetracycline by Cu-CdS and Deciphering the Contribution of Reactive Oxygen Species.

Production of Copper (Cu) modified Cadmium sulfide (CdS) nanomaterial, named as Cu-CdS, was successfully synthesized through hydrothermal and photo deposition method to degrade oxytetracycline (OTC) antibiotics in aqueous solution. Uniform surface loading of copper was observed on CdS using Scanning Electron Microscopy-mapping (SEM-mapping). The Cu induced improvement in the visible light absorption was observed using UV-vis absorption spectrum.

Feasibility Study of Activated Sludge/Contact Aeration Combined System Treating Oil-Containing Domestic Sewage.

Both activated sludge/contact aeration (AS/CA) and AS-only systems for treating oil-containing domestic sewage were tested. The results of these tests indicate that the oil and grease removal ratios of the AS/CA system exceeded those of the AS-only system. When the influent oil and grease concentration reached 60 mg/L, the effluent concentration of the AS system was 13 mg/L, which exceed 10 mg/L, the Taiwan Effluent Standard for oil and grease.

Regeneration and reuse of leachate from a municipal solid waste landfill.

Landfill leachate is deep brown in color with extremely complex composition and difficult to treat in order to meet the effluent standards. The leachate of Keelung City Tien Wai Tien landfill has an average flow of 350 CMD. In the present study following serially connected devices: Activated sludge/contact aeration (AS/CA) combined system, reverse osmosis (RO) and an ammonia stripping tower were used to treat the leachate.

Catalytic decomposition of CF4 over iron promoted mesoporous catalysts.

A series of mesoporous catalysts (MCM-41) promoted by iron nanoparticles were prepared by the co-precipitation method and tested for the decomposition of carbon tetrafluoride (CF4). The addition of iron oxide nanoparticles to MCM-41 led to an improvement in the catalytic activity for CF4 decomposition. The catalyst was the most active around 5 wt% iron added to MCM-41.

Study on the degradation of the dye wastewater with polyaniline on titanium nanotubes.

Polyaniline/titanium nanotube composite (PANI/TNT) photocatalysts were prepared by 'in situ'chemical oxidative polymerization of aniline. Transmission electron microscopy (TEM), X-ray diffraction (XRD), Fourier transform IR spectra (FTIR) and UV-Visible spectroscopy measurements were used to characterize the obtained photocatalysts, and their photocatalytic activities were investigated by degrading Reactive Green19 (RG19) under near visible light irradiation (lambda = 365 nm). The content of PANI, pH, dosage, and concentration of RG19 were also investigated.

Photocatalytic degradation of reactive red 141 in the presence of Cr(VI) using TiO2 nanotubes.

TiO2 nanotubes were prepared by hydrothermal process, then characterized using Brunauer-Emmett-Teller (BET), transmission electron microscopy (TEM), X-ray diffraction (XRD) and UV-Visible spectroscopy measurements. The photodegradation performance assessment of Reactive Red 141 (RR141) with near visible light irradiation (lambda = 380 nm) was carried out under different catalyst doses, dye concentrations, pH and initial Cr(VI) concentrations by TiO2 powder and nanotubes. The results showed that the specific surface area of TiO2 nanotubes were 152 m2 g(-1), about three times larger than that of TiO2 powder which was roughly 51 m2 g(-1).