Detection of diheptacendiyl diradical intermediate in the cycloreversion of diheptacene to heptacene.

Cycloreversion of diheptacenes, the covalently bound dimers of heptacene, in the solid state produces heptacene. In addition, diheptacendiyl diradical can be detected by ESR spectroscopy. The diradical has a small singlet-triplet energy gap of -0.

Gas Phase Ionization Energy of Heptacene.

The ionization energy is a fundamental property that is relevant to charge transport in organic semiconductors. We report adiabatic ionization energies (AIEs) of heptacene at 6.21 and 7.

Direct laser induced writing of high precision gold nanosphere SERS patterns.

The high sensitivity and molecular fingerprint capability of Surface-Enhanced Raman Spectroscopy (SERS) have lead to a wide variety of applications ranging from classical physics, chemistry over biology to medicine. Equally, there are numerous methods to fabricate samples owing to the desired properties and to create the localized surface plasmon resonances (LSPRS). However, for many applications the LSPRs must be specifically localized on micrometer sized areas and multiple steps of lithography are needed to achieve the desired substrates.

Influence of Backbone Ladderization and Side Chain Variation on the Orientation of Diketopyrrolopyrrole-Based Donor-Acceptor Copolymers.

Ladder polymers with poly(diketopyrrolopyrrole) (DPP) moieties have recently attracted enormous interest for a large variety of opto-electronic applications. Since the rigidity of the backbone increases with ladderization, a strong influence on the self-organization of thin films is expected. We study the molecular orientation of DPP-based ladder polymers in about 50 nm thin films using polarization modulation-infrared reflection-absorption spectroscopy (PM-IRRAS).

Orientation, electronic decoupling and band dispersion of heptacene on modified and nanopatterned copper surfaces.

The adsorption of heptacene (7 A) on Cu(110) and Cu(110)-(2 × 1)-O was studied with scanning tunneling microscopy, photoemission orbital tomography and density functional calculations to reveal the influence of surface passivation on the molecular geometry and electronic states. We found that the charge transfer into the 7 A molecules on Cu(110) is completely suppressed for the oxygen-modified Cu surface. The molecules are aligned along the Cu-O rows and uncharged.

Zwitterionic Carbazole Ligands Enhance the Stability and Performance of Perovskite Nanocrystals in Light-Emitting Diodes.

We introduce a new carbazole-based zwitterionic ligand (DCzGPC) synthesized via Yamaguchi esterification which enhances the efficiency of lead halide perovskite (LHP) nanocrystals (NCs) in light-emitting diodes (LED). A facile ligand exchange of the native ligand shell, monitored by nuclear magnetic resonance (NMR), ultraviolet-visible (UV-vis), and photoluminescence (PL) spectroscopy, enables more stable and efficient LHP NCs. The improved stability is demonstrated in solution and solid-state LEDs, where the NCs exhibit prolonged luminescence lifetimes and improved luminance, respectively.

The Influence of the Side Chain Structure on the Photostability of Low Band Gap Polymers.

Side chains play an important role in the photo-oxidation process of low band gap (LBG) polymers. For example, it has been shown that their photostability can be increased by the introduction of aromatic-oxy-alkyl links. We studied the photostability of prototypical LBG polymers with alkyl and oxyalkyl side chains during irradiation with white light (AM 1.

Nanometer Sized Direct Laser-Induced Gold Printing for Precise 2D-Electronic Device Fabrication.

Flexible electronics manufacturing technologies are essential and highly favored for future integrated photonic and electronic devices. Direct laser induced writing (DIW) of metals has shown potential as a fast and highly variable method in adaptable electronics. However, most of the DIW procedures use silver structures, which tend to oxidize and are limited to the micrometer regime.

Mitigating the photodegradation of all-inorganic mixed-halide perovskite nanocrystals by ligand exchange.

We show that the decomposition of caesium lead halide perovskite nanocrystals under continuous X-ray illumination depends on the surface ligand. For oleic acid/oleylamine, we observe a fast decay accompanied by the formation of elemental lead and halogen. Upon surface functionalization with a metal porphyrin derivative, the decay is markedly slower and involves the disproportionation of lead to Pb and Pb.

Hexacene on Cu(110) and Ag(110): Influence of the Substrate on Molecular Orientation and Interfacial Charge Transfer.

Hexacene, composed of six linearly fused benzene rings, is an organic semiconductor material with superior electronic properties. The fundamental understanding of the electronic and chemical properties is prerequisite to any possible application in devices. We investigate the orientation and interface properties of highly ordered hexacene monolayers on Ag(110) and Cu(110) with X-ray photoemission spectroscopy (XPS), photoemission orbital tomography (POT), X-ray absorption spectroscopy (XAS), low-energy electron diffraction (LEED), scanning tunneling microscopy (STM), and density functional theory (DFT).

Cell-derived and enzyme-based decellularized extracellular matrix exhibit compositional and structural differences that are relevant for its use as a biomaterial.

Due to its availability and minimal invasive harvesting human adipose tissue-derived extracellular matrix (dECM) is often used as a biomaterial in various tissue engineering and healthcare applications. Next to dECM, cell-derived ECM (cdECM) can be generated by and isolated from in vitro cultured cells. So far both types of ECM were investigated extensively toward their application as (bio)material in tissue engineering and healthcare.

Inhomogeneous defect distribution of triangular WS monolayer revealed by surface-enhanced and tip-enhanced Raman and photoluminescence spectroscopy.

Confocal optical microscopy and tip-enhanced optical microscopy are applied to characterize the defect distributions in chemical vapor deposition-grown WS monolayer triangles qualitatively and quantitatively. The presence of defects in individual monolayer WS triangles is revealed with diffraction-limited spatial resolution in their photoluminescence (PL) images, from which the inhomogeneous defect density distribution is calculated, showing an inverse relationship to the PL intensity. The defect-related surface-enhanced Raman spectroscopy (SERS) effect is investigated by depositing a thin copper phthalocyanine layer (5 nm) as the probe molecule on the monolayer WS triangles surface.

Industry White Paper: Contemporary Opportunities and Challenges in Characterizing Crystallinity in Amorphous Solid Dispersions.

Members of the IQ Consortium ″Working Group on Characterization on Amorphous Solid Dispersions″ shares here a perspective on the analytical challenges, and limitations of detecting low levels of crystalline drug substance in amorphous solid dispersions (ASDs) and associated drug products. These companies aim to employ highly sensitive commercially available analytical technologies to guide development, support control strategies, and enable registration of quality products. We hope to promote consistency in development and registration approaches and guide the industry in development of "characterization best practices" in the interest of providing high quality products for patients.

Interface Properties of CoPc on Nanographene-Covered Au(111) and the Influence of Annealing.

Organic bilayer systems and heterostructures are of enormous importance for optoelectronic devices. We study interface properties and the structural ordering of cobalt phthalocyanine (CoPc) on a highly ordered monolayer hexa-peri-hexabenzocoronene (HBC), grown on Au(111), using photoemission, X-ray absorption, scanning tunneling microscopy, and low-energy electron diffraction. A charge transfer between CoPc and the gold substrate is almost completely prevented by the HBC intermediate layer.

The interface between chloroaluminum phthalocyanine and titanium dioxide: the influence of surface defects and substrate termination.

Interface properties of chloroaluminum(iii) phthalocyanine (AlClPc) on two different rutile titanium dioxide (TiO2) single crystal surfaces ((100) and (001)) have been studied using X-ray and ultraviolet photoemission spectroscopy (XPS and UPS). It is shown that the strength of the interaction clearly depends on the substrate termination and preparation. Generally, the (001) surface is more reactive compared to the (100) surface.

Interface interaction of transition metal phthalocyanines with strontium titanate (100).

We study interface properties of CoPcF and FePcF ( = 0 or 16) on niobium-doped SrTiO(100) surfaces using mainly X-ray photoelectron spectroscopy and ultraviolet photoelectron spectroscopy. For all studied molecules, a rather complex, bidirectional charge transfer with the oxide substrate was observed, involving both the macrocycle and the central metal atom. For molecules of the first monolayer, an electron transfer to the central metal atom is concluded from transition metal 2p core level photoemission spectra.

Demonstrating the Impact of the Adsorbate Orientation on the Charge Transfer at Organic-Metal Interfaces.

Charge-transfer processes at molecule-metal interfaces play a key role in tuning the charge injection properties in organic-based devices and thus, ultimately, the device performance. Here, the metal's work function and the adsorbate's electron affinity are the key factors that govern the electron transfer at the organic/metal interface. In our combined experimental and theoretical work, we demonstrate that the adsorbate's orientation may also be decisive for the charge transfer.

Synthesis of an Addition-Crosslinkable, Silicon-Modified Polyolefin via Reactive Extrusion Monitored by In-Line Raman Spectroscopy.

We present the modification of ethylene-propylene rubber (EPM) with vinyltetra-methydisiloxane (VTMDS) via reactive extrusion to create a new silicone-based material with the potential for high-performance applications in the automotive, industrial and biomedical sectors. The radical-initiated modification is achieved with a peroxide catalyst starting the grafting reaction. The preparation process of the VTMDS-grafted EPM was systematically investigated using process analytical technology (in-line Raman spectroscopy) and the statistical design of experiments (DoE).

Going beyond Pentacene: Photoemission Tomography of a Heptacene Monolayer on Ag(110).

Longer acenes such as heptacene are promising candidates for optoelectronic applications but are unstable in their bulk structure as they tend to dimerize. This makes the growth of well-defined monolayers and films problematic. In this article, we report the successful preparation of a highly oriented monolayer of heptacene on Ag(110) by thermal cycloreversion of diheptacenes.

Probing Bias-Induced Electron Density Shifts in Metal-Molecule Interfaces via Tip-Enhanced Raman Scattering.

Surface charging effects at metal-molecule interfaces, for example, charge transfer, charge transport, charge injection, and so on, have a strong impact on the performance of organic electronics. Only having molecules bound or adsorbed on different metals results in a doping-like behavior at the interface by the different work functions of the metals and creates hybrid surface states, which strongly affect the efficiencies. With the ongoing downsizing and thinning of the organic components, the impact of the interface will even further increase.

Fibronectin adsorption on oxygen plasma-treated polyurethane surfaces modulates endothelial cell response.

Fibronectin coating increases implant biocompatibility by enhancing surface endothelialization via integrin-mediated binding. Surface properties determine the fibronectin orientation and conformation, dictating which ligands are presented, and therefore altering the bioactivity of an implant surface. In this study, polyurethane was treated with oxygen plasma, which allowed for a simultaneous modification of the surface chemistry and topography to modulate fibronectin adsorption.

Optimizing the Process Efficiency of Reactive Extrusion in the Synthesis of Vinyltrimethoxysilane-Grafted Ethylene-Octene-Copolymer (EOC-g-VTMS) by Response Surface Methodology.

Thermoplastic polymers like ethylene-octene copolymer (EOC) may be grafted with silanes via reactive extrusion to enable subsequent crosslinking for advanced biomaterials manufacture. However, this reactive extrusion process is difficult to control and it is still challenging to reproducibly arrive at well-defined products. Moreover, high grafting degrees require a considerable excess of grafting reagent.

Visualization of the Borazine Core of BN-Doped Nanographene by STM.

Electronic interface properties and the initial growth of hexa--hexabenzocoronene with a borazine core (BN-HBC) on Au(111) have been studied by using X-ray photoelectron spectroscopy (XPS), low-energy electron diffraction (LEED), and scanning tunneling microscopy (STM). A weak, but non-negligible, interaction between BN-HBC and Au(111) was found at the interface. Both hexa--hexabenzocoronene (HBC) and BN-HBC molecules form well-defined monolayers.

FePc and FePcF on Rutile TiO(110) and (100): Influence of the Substrate Preparation on the Interaction Strength.

Interface properties of iron phthalocyanine (FePc) and perfluorinated iron phthalocyanine (FePcF) on rutile TiO(100) and TiO(110) surfaces were studied using X-ray photoemission spectroscopy (XPS), X-ray absorption spectroscopy (XAS), and low-energy electron diffraction (LEED). It is demonstrated that the interaction strength at the interfaces is considerably affected by the detailed preparation procedure. Weak interactions were observed for all studied interfaces between FePc or FePcF and rutile, as long as the substrate was exposed to oxygen during the annealing steps of the preparation procedure.