Semi-mechanistic analysis of emergency planning zones for 20 MWe lead-cooled fast reactor by hypothetical accidents during Korea's arctic exploration.

Small modular reactors or micro modular reactors have been considered as an alternative power source for merchant ships because of minimal carbon emission and a long lifecycle without refueling. Ahead of the operation, however, their emergency planning zones (EPZs) should be optimally set and approved to ensure both radiological safety and cost efficiency in case of nuclear accidents. Thus, the required size of EPZs was analyzed based on semi-mechanistic assumptions for hypothetical accidents with MicroURANUS, a micro modular fast reactor type of 20-MW lead-bismuth-cooled, used to power an icebreaker during Korea's Arctic missions.

Gamma-Ray Sensor Using YAlO(Ce) Single Crystal and CNT/PEEK with High Sensitivity and Stability under Harsh Underwater Conditions.

A new gamma-ray sensor, which could be employed in harsh underwater conditions, was developed using YAlO(Ce) single crystal and carbon nanotube reinforced polyetheretherketone (CNT/PEEK). The sensor is compact, highly sensitive and stable, by providing real-time gross counts and an accumulated spectrum for fresh, saline, or contaminated water conditions. The sensor was tested in a water tank for quantification of the limit of detections.

Optimizing UAV-based radiation sensor systems for aerial surveys.

In this study, we qualitatively and quantitatively analyzed unmanned aerial vehicle (UAV)-based radiation sensor systems suitable for specific survey missions. We examined a variety of UAVs, radiation sensors, and radiological survey missions; after reviewing previous studies that developed and conducted field tests, we categorized them by mission and suggested suitable types of UAVs and radiation sensors for each mission. To quantitatively analyze various system designs previously suggested, we proposed a new figure of merit (FOM) formula that can explain the mutual effects of parameters of both radiation sensors and UAVs on system performance.

Effect of output power, target temperature, and solid concentration on the solubilization of waste activated sludge using microwave irradiation.

In this paper, we quantify the effect of heating pretreatment on the degree of solubilization of waste activated sludge. The pretreatment process was carried out using a lab-scale industrial microwave unit (2450 MHz frequency). Response surface analysis was applied to determine the combination of output power (400-1600 W), target temperature (60-120 degrees C), and total solid concentration (1-3% total solid (TS)).