A solar flow photo-reactor for antibiotic removal from aquaculture effluents using TiO/carbon quantum dots.

Effluents contaminated with antibiotics must be treated before reuse or even discharge into the aquatic environment, avoiding the increase of antimicrobial resistance (AMR) - a major public health problem of the 21 century. Little is known regarding the natural solar photodegradation of antibiotics in tubular reactors operated under flow mode and even less concerning the application of photocatalysts. The use of photocatalysts is considered a promising strategy for a sustainable solar-driven removal of antibiotics from effluents.

Photodegradation of oxolinic acid in aquaculture effluents under solar irradiation: is it possible to enhance efficiency by the use of TiO/carbon quantum dots composites?

Antibiotics, such as oxolinic acid (OXA), in aquaculture effluents contribute to the dissemination of antimicrobial resistance, which makes it urgent to develop efficient and sustainable processes for their removal. Aiming a photocatalytic degradation under solar radiation, different carbon quantum dots (CQDs) were produced in this work through a bottom-up hydrothermal methodology and incorporated into TiO by a simple calcination method. A total of thirteen materials were synthesized and tested for OXA photocatalytic removal from synthetic and real matrices.

Sulfadiazine's photodegradation using a novel magnetic and reusable carbon based photocatalyst: Photocatalytic efficiency and toxic impacts to marine bivalves.

In the present study, waste-based biochar functionalized with titanium dioxide (TiO) and afterwards magnetized by an ex-situ approach, defined as synthetic photosensitizer (SPS), was explored for the photocatalytic degradation of sulfadiazine (SDZ), an antibiotic widely used in the aquaculture industry, under solar irradiation. The use of the SPS enhanced the photodegradation efficiency, with a half-life time (t) reduction from 12.2 ± 0.

Photodegradation of Aquaculture Antibiotics Using Carbon Dots-TiO Nanocomposites.

In this work, carbon dots (CD) were synthesized and coupled to titanium dioxide (TiO) to improve the photodegradation of antibiotics in aquaculture effluents under solar irradiation. Oxolinic acid (OXA) and sulfadiazine (SDZ), which are widely used in aquaculture, were used as target antibiotics. To prepare nanocomposites of CD containing TiO, two modes were used: in-situ (CD@TiO) and ex-situ (CD/TiO).

Antibiotics in Aquaculture Wastewater: Is It Feasible to Use a Photodegradation-Based Treatment for Their Removal?

Aquacultures are a sector facing a huge development: farmers usually applying antibiotics to treat and/or prevent diseases. Consequently, effluents from aquaculture represent a source of antibiotics for receiving waters, where they pose a potential threat due to antimicrobial resistance (AMR) induction. This has recently become a major concern and it is expectable that regulations on antibiotics' discharge will be established in the near future.

Biochar-TiO magnetic nanocomposites for photocatalytic solar-driven removal of antibiotics from aquaculture effluents.

Contamination of surrounding waters with antibiotics by aquaculture effluents can be problematic due to the possible increase of bacterial resistance, making it crucial the efficient treatment of those effluents before their release into the environment. In this work, the application of waste-based magnetic biochar/titanium dioxide (BC/TiO) composite materials on the photodegradation of two antibiotics widely used in aquaculture (sulfadiazine (SDZ) and oxolinic acid (OXA)) was assessed. Four materials were synthesized: BCMag (magnetized BC), BCMag_TiO (BCMag functionalized with TiO), BC_TiO_MagIn and BC_TiO_MagEx (BC functionalized with TiO and afterwards magnetized by in-situ and ex-situ approaches, respectively).

Oxolinic acid in aquaculture waters: Can natural attenuation through photodegradation decrease its concentration?

Quinolones, such as oxolinic acid (OXA), are antimicrobials commonly used in aquaculture. Thus, its presence in the aquatic environment surrounding aquaculture facilities is quite easy to understand. When present in aquatic environment, pharmaceuticals may be subjected to several attenuation processes that can influence their persistence.

Photodegradation of sulfadiazine in different aquatic environments - Evaluation of influencing factors.

The presence of antibiotics, such as sulfadiazine (SDZ), in the aquatic environment contributes to the generation of antimicrobial resistance, which is a matter of great concern. Photolysis is known to be a major degradation pathway for SDZ in surface waters. Therefore, influencing factors affecting SDZ photodegradation in different aquatic environments were here evaluated in order to have a better knowledge about its persistence in the environment.

Sulfamethoxazole exposure to simulated solar radiation under continuous flow mode: Degradation and antibacterial activity.

Among pharmaceuticals, the occurrence of antibiotics in the environment is a subject of special concern due to their environmental impact, namely the development of bacterial resistance. Sulfamethoxazole (SMX) is one of the most commonly used antibiotics and it is regularly found, not only in effluents from sewage treatment plants (STPs), but also in the aquatic environment. Photodegradation appears as an alternative process for the removal of this type of pollutants from contaminated waters.

Fixed-bed performance of a waste-derived granular activated carbon for the removal of micropollutants from municipal wastewater.

This work aimed to assess the fixed-bed adsorptive performance of a primary paper mill sludge-based granular activated carbon (PSA-PA) for the removal of pharmaceuticals, namely carbamazepine (CBZ), sulfamethoxazole (SMX) and paroxetine (PAR), from water. The breakthrough curves corresponding to the adsorption of CBZ at different flow rates and in two different matrices (distilled and municipal wastewater) were firstly determined, which allowed to select the most favorable flow rate for the subsequent experiments. The fixed-bed adsorption of CBZ, SMX and PAR from single and ternary solutions in wastewater showed that the performance of PSA-PA was different for each pharmaceutical.

Adsorption of pharmaceuticals from biologically treated municipal wastewater using paper mill sludge-based activated carbon.

A waste-based alternative activated carbon (AAC) was produced from paper mill sludge under optimized conditions. Aiming its application in tertiary wastewater treatment, AAC was used for the removal of carbamazepine, sulfamethoxazole, and paroxetine from biologically treated municipal wastewater. Kinetic and equilibrium adsorption experiments were run under batch operation conditions.

Obtaining granular activated carbon from paper mill sludge - A challenge for application in the removal of pharmaceuticals from wastewater.

In this work, a granular activated carbon (GAC) was produced using primary paper mill sludge (PS) as raw material and ammonium lignosulfonate (AL) as binder agent. PS is a residue from the pulp and paper industry and AL is a by-product of the cellulose pulp manufacture and the proposed production scheme contributes for their valorisation together with important savings in GAC precursors. The produced GAC (named PSA-PA) and a commercially available GAC (GACN), used as reference material, were physically and chemically characterized.

Photodegradation of sulfamethoxazole in environmental samples: The role of pH, organic matter and salinity.

Sulfamethoxazole (SMX) is the most representative antibiotic of the sulfonamides group used in both human and veterinary medicine, and thus frequently detected in water resources. This has caused special concern due to the pronounced toxicity and potential to foster bacterial resistance of this drug. Therefore, and to further understand the fate of SMX in the aquatic environment, its photodegradation under simulated solar radiation was here studied in ultrapure water and in different environmental samples, namely estuarine water, freshwater and wastewater.

Dispersive liquid-liquid microextraction for the quantification of venlafaxine in environmental waters.

The present work describes a new methodology for the detection of the antidepressant venlafaxine (VEN) in aquatic environments using dispersive liquid-liquid microextraction followed by high performance liquid chromatography with fluorescence detection (DLLME-HPLC-FLD). The method developed is fast, low cost, easy to apply, uses a small volume of organic solvents and allows the simultaneous extraction of various samples. The DLLME-HPLC-FLD method presented a linearity range from 25 to 1500 ng L, a detection limit of 24.

Production of highly efficient activated carbons from industrial wastes for the removal of pharmaceuticals from water-A full factorial design.

The wide occurrence of pharmaceuticals in aquatic environments urges the development of cost-effective solutions for their removal from water. In a circular economy context, primary paper mill sludge (PS) was used to produce activated carbon (AC) aiming the adsorptive removal of these contaminants. The use of low-cost precursors for the preparation of ACs capable of competing with commercial ACs continues to be a challenge.

Waste-based alternative adsorbents for the remediation of pharmaceutical contaminated waters: Has a step forward already been taken?

When adsorption is considered for water treatment, commercial activated carbon is usually the chosen adsorbent for the removal of pollutants from the aqueous phase, particularly pharmaceuticals. In order to decrease costs and save natural resources, attempts have been made to use wastes as raw materials for the production of alternative carbon adsorbents. This approach intends to increase efficiency, cost-effectiveness, and also to propose an alternative and sustainable way for the valorization/management of residues.

Single and multi-component adsorption of psychiatric pharmaceuticals onto alternative and commercial carbons.

This work describes the adsorptive removal of three widely consumed psychiatric pharmaceuticals (carbamazepine, paroxetine and oxazepam) from ultrapure water. Two different adsorbents were used: a commercial activated carbon and a non-activated waste-based carbon (PS800-150-HCl), produced by pyrolysis of primary paper mill sludge. These adsorbents were used in single, binary and ternary batch experiments in order to determine the adsorption kinetics and equilibrium isotherms of the considered pharmaceuticals.

Sludge from paper mill effluent treatment as raw material to produce carbon adsorbents: An alternative waste management strategy.

Pulp and paper industry produces massive amounts of sludge from wastewater treatment, which constitute an enormous environmental challenge. A possible management option is the conversion of sludge into carbon-based adsorbents to be applied in water remediation. For such utilization it is important to investigate if sludge is a consistent raw material originating reproducible final materials (either over time or from different manufacturing processes), which is the main goal of this work.

Structural considerations on the selectivity of an immunoassay for sulfamethoxazole.

Sulfamethoxazole (SMX), a sulfonamide, is a widely used bacteriostatic antibiotic and therefore a promising marker for the entry of anthropogenic pollution in the environment. SMX is frequently found in wastewater and surface water. This study presents the production of high affinity and selective polyclonal antibodies for SMX and the development and evaluation of a direct competitive enzyme-linked immunosorbent assay (ELISA) for the quantification of SMX in environmental water samples.

Photodegradation behaviour of estriol: An insight on natural aquatic organic matter influence.

Estriol (E3) is one of the steroidal estrogens ubiquitously found in the aquatic environment, photodegradation being an important pathway for the elimination of such endocrine disrupting compounds. However, it is important to understand how environmentally important components present in aquatic matrices, such as organic matter, may affect their photodegradation. The main objective of this work was to investigate the photodegradation of E3 in water, under simulated solar radiation, as well as the effect of humic substances (HS - humic acids (HA), fulvic acids (FA) and XAD-4 fraction) in E3 photodegradation.

Photosensitized Degradation of 17β-estradiol and 17α-ethinylestradiol: Role of Humic Substances Fractions.

Photodegradation of 17α-ethinylestradiol (EE2) and 17β-estradiol (E2) was investigated under simulated solar radiation. Photodegradation kinetics in the absence and presence of humic substances (HSs) fractions (humic acids [HAs], fulvic acids [FAs], and XAD-4), were compared. Although all three fractions were responsible for a noticeable increase on photodegradation rates, the effects were greater for FA and XAD-4.

Effect of natural aquatic humic substances on the photodegradation of estrone.

Photodegradation of estrone (E1) was investigated under simulated solar radiation in absence and presence of the different fractions of humic substances (HS), namely humic acids (HA), fulvic acids (FA) and XAD-4 fraction. The pseudo-first order photodegradation rate constants increased from 0.1137 h(-1), in ultrapure (MQ) water, to 0.

Application of dispersive liquid-liquid microextraction for estrogens' quantification by enzyme-linked immunosorbent assay.

Estrogens, such as 17β-estradiol (E2) and 17α-ethinylestradiol (EE2), are the major responsible for endocrine-disrupting effects observed in aquatic environments due to their high estrogenic potency, even at concentrations ranging from pgL(-1) to ng L(-1). Thus, it is essential to develop analytical methodologies suitable for monitoring their presence in water samples. Dispersive liquid-liquid microextraction (DLLME) was used as a pre-concentration step prior to the quantification of E2 and EE2 by enzyme-linked immunosorbent assay (ELISA).

Evaluation of the anthropogenic input of caffeine in surface waters of the north and center of Portugal by ELISA.

This study comprises the development of an enzyme-linked immunosorbent assay (ELISA) for the quantification of caffeine in complex aqueous matrices without any sample clean-up procedure. Salinity and dissolved organic matter were selected as potential interfering agents. The addition of a sample buffer containing bovine serum albumin (BSA) prior to the sample was found to decrease the influence of those interfering agents.

Low cost methodology for estrogens monitoring in water samples using dispersive liquid-liquid microextraction and HPLC with fluorescence detection.

A new low cost methodology for estrogens' analysis in water samples was developed in this work. Based on dispersive liquid-liquid microextraction followed by high-performance liquid chromatography with fluorescence detection, the developed method is fast, cheap, easy-to-use, uses low volumes of organic solvents and has the possibility of a large number of samples to be extracted in parallel. Under optimum conditions (sample volume: 8 mL; extraction solvent: 200 μL of chlorobenzene; dispersive solvent: 2000 μL of acetone), the enrichment factor and extraction recoveries were 145 and 72% for 17β-estradiol (E2) and 178 and 89% for 17α-ethinylestradiol (EE2), respectively.