Characterization of emissions from a pilot-scale combustor operating on coal blended with woody biomass.

Emissions generated from the combustion of coal have been a subject of regulation by the United States Environmental Protection Agency (U.S. EPA) and State agencies for years, as they have been associated with adverse effects on human health and the environment.

Carbonaceous Particulate Matter Emitted from a Pellet-Fired Biomass Boiler.

Biomass pellets are a source of renewable energy; although, the air pollution and exposure risks posed by the emissions from burning pellets in biomass boilers (BBs) are uncertain. The present study examines the organic species in fine particle matter (PM) emissions from an BB firing switchgrass (SwG) and hardwood (HW) biomass pellets using different test cycles. The organic and elemental carbon (OC and EC) content and select semivolatile organic compounds (SVOCs) in filter-collected PM were identified and quantified using thermal-optical analysis and gas chromatography-mass spectrometry (GC-MS), respectively.

Comparison of gaseous and particulate emissions from a pilot-scale combustor using three varieties of coal.

Gaseous and particulate emissions generated from the combustion of coal have been associated with adverse effects on human health and the environment, and have therefore been the subject of regulation by federal and state government agencies. Detailed emission characterizations are needed to better understand the impacts of pre- and post-combustion controls on a variety of coals found in the United States (U.S.

Simultaneous control of Hg0, SO2, and NOx by novel oxidized calcium-based sorbents.

Efforts to develop multipollutant control strategies have demonstrated that adding certain oxidants to different classes of Ca-based sorbents leads to a significant improvement in elemental Hg vapor (Hg0), SO2, and NOx removal from simulated flue gases. In the study presented here, two classes of Ca-based sorbents (hydrated limes and silicate compounds) were investigated. A number of oxidizing additives at different concentrations were used in the Ca-based sorbent production process.