Nanomechanical Mapping of Three Dimensionally Printed Poly-ε-Caprolactone Single Microfibers at the Cell Scale for Bone Tissue Engineering Applications.

Poly-ε-caprolactone (PCL) has been widely used in additive manufacturing for the construction of scaffolds for bone tissue engineering. However, its use is limited by its lack of bioactivity and inability to induce cell adhesion, hence limiting bone tissue regeneration. Biomimicry is strongly influenced by the dynamics of cell-substrate interaction.

Near-Surface Nanomechanics of Medical-Grade PEEK Measured by Atomic Force Microscopy.

Detecting subtle changes of surface stiffness at spatial scales and forces relevant to biological processes is crucial for the characterization of biopolymer systems in view of chemical and/or physical surface modification aimed at improving bioactivity and/or mechanical strength. Here, a standard atomic force microscopy setup is operated in nanoindentation mode to quantitatively mapping the near-surface elasticity of semicrystalline polyether ether ketone (PEEK) at room temperature. Remarkably, two localized distributions of moduli at about 0.

Nanomechanical Mapping of Hard Tissues by Atomic Force Microscopy: An Application to Cortical Bone.

Force mapping of biological tissues via atomic force microscopy (AFM) probes the mechanical properties of samples within a given topography, revealing the interplay between tissue organization and nanometer-level composition. Despite considerable attention to soft biological samples, constructing elasticity maps on hard tissues is not routine for standard AFM equipment due to the difficulty of interpreting nanoindentation data in light of the available models of surface deformation. To tackle this issue, we proposed a protocol to construct elasticity maps of surfaces up to several GPa in moduli by AFM nanoindentation using standard experimental conditions (air operation, nanometrically sharp spherical tips, and cantilever stiffness below 30 N/m).

Presence of enteric bacterial pathogens in meat samples of wild boar hunted in Campania region, southern Italy.

Wild boars can be infected with several foodborne pathogens which may be transmitted to humans through the consumption of their meat, but currently, data of their prevalence are still limited. The present study aimed to evaluate the presence of enteric pathogens in wild boar meat samples killed in the Campania region. Twentyeight wild boar meat samples were analyzed for the detection of spp, , spp.

Differences in the Cortical Structure of the Whole Fibula and Tibia Between Long-Distance Runners and Untrained Controls. Toward a Wider Conception of the Biomechanical Regulation of Cortical Bone Structure.

The cortical structure of human fibula varies widely throughout the bone suggesting a more selective adaptation to different mechanical environments with respect to the adjacent tibia. To test this hypothesis, serial-pQCT scans of the dominant fibulae and tibiae of 15/15 men/women chronically trained in long-distance running were compared with those of 15/15 untrained controls. When compared to controls, the fibulae of trained individuals had similar (distally) or lower (proximally) cortical area, similar moments of inertia (MI) for anterior-posterior bending (xMI) and lower for lateral bending (yMI) with a lower "shape-index" (yMI/xMI ratio) throughout, and higher resistance to buckling distally.

Enhanced Raman Investigation of Cell Membrane and Intracellular Compounds by 3D Plasmonic Nanoelectrode Arrays.

3D nanostructures are widely exploited in cell cultures for many purposes such as controlled drug delivery, transfection, intracellular sampling, and electrical recording. However, little is known about the interaction of the cells with these substrates, and even less about the effects of electroporation on the cellular membrane and the nuclear envelope. This work exploits 3D plasmonic nanoelectrodes to study, by surface-enhanced Raman scattering (SERS), the cell membrane dynamics on the nanostructured substrate before, during, and after electroporation.

Differences in the relation between bone mineral content and lean body mass according to gender and reproductive status by age ranges.

The present study aims: (1) to explore the influence of lean mass (LM) on bone mineral content (BMC), (2) to investigate the pubertal influences on the BMC-LM relation, and (3) to perform Z-score charts of BMC-LM relation, stratified by gender and reproductive status categorized by age ranges. A cross-sectional analysis was conducted using 4001 healthy subjects between 7 and 90 years participating in the Health Workers Cohort Study. Of these, 720 participants were ≤ 19 years, 2417 were women ≥ 20 years, and 864 were men ≥ 20 years.

Fibula: The Forgotten Bone-May It Provide Some Insight On a Wider Scope for Bone Mechanostat Control?

The human fibula responds to its mechanical environment differently from the tibia accordingly with foot usage. Fibula structure is unaffected by disuse, and is stronger concerning lateral bending in soccer players (who evert and rotate the foot) and weaker in long-distance runners (who jump while running) with respect to untrained controls, along the insertion region of peroneus muscles. These features, strikingly associated to the abilities of the fibulae of predator and prey quadrupeds to manage uneven surfaces and to store elastic energy to jump, respectively, suggest that bone mechanostat would control bone properties with high selective connotations beyond structural strength.

Selective intracellular delivery and intracellular recordings combined in MEA biosensors.

Biological studies on in vitro cell cultures are of fundamental importance to investigate cell response to external stimuli, such as new drugs for the treatment of specific pathologies, or to study communication between electrogenic cells. Although three-dimensional (3D) nanostructures brought tremendous improvements on biosensors used for various biological in vitro studies, including drug delivery and electrical recording, there is still a lack of multifunctional capabilities that could help gain deeper insights in several bio-related research fields. In this work, the electrical recording of large cell ensembles and the intracellular delivery of few selected cells are combined on the same device by integrating microfluidic channels on the bottom of a multi-electrode array decorated with 3D hollow nanostructures.

Cell Membrane Disruption by Vertical Micro-/Nanopillars: Role of Membrane Bending and Traction Forces.

Gaining access to the cell interior is fundamental for many applications, such as electrical recording and drug and biomolecular delivery. A very promising technique consists of culturing cells on micro-/nanopillars. The tight adhesion and high local deformation of cells in contact with nanostructures can promote the permeabilization of lipids at the plasma membrane, providing access to the internal compartment.

Multi-Scale Approach for the Evaluation of Bone Mineralization in Strontium Ranelate-Treated Diabetic Rats.

Long-term diabetes mellitus can induce osteopenia and osteoporosis, an increase in the incidence of low-stress fractures, and/or delayed fracture healing. Strontium ranelate (SrR) is a dual-action anti-osteoporotic agent whose use in individuals with diabetic osteopathy has not been adequately evaluated. In this study, we studied the effects of an oral treatment with SrR and/or experimental diabetes on bone composition and biomechanics.

Long-Range Capture and Delivery of Water-Dispersed Nano-objects by Microbubbles Generated on 3D Plasmonic Surfaces.

The possibility of investigating small amounts of molecules, moieties, or nano-objects dispersed in solution constitutes a central step for various application areas in which high sensitivity is necessary. Here, we show that the rapid expansion of a water bubble can act as a fast-moving net for molecules or nano-objects, collecting the floating objects in the surrounding medium in a range up to 100 μm. Thanks to an engineered 3D patterning of the substrate, the collapse of the bubble could be guided toward a designed area of the surface with micrometric precision.

Structural Ordering of Molybdenum Disulfide Studied via Reactive Molecular Dynamics Simulations.

Molybdenum disulfide (MoS) is a well-known and effective lubricant that provides extremely low values of coefficient of friction. It is known that the sliding process may induce structural transformations of amorphous or disordered MoS to the crystalline phase with basal planes oriented parallel to the sliding direction, which is optimal for reducing friction. However, the key reaction parameters and conditions promoting this structural transformation are still largely unknown.

Velocity dependence of sliding friction on a crystalline surface.

We introduce and study a minimal 1D model for the simulation of dynamic friction and dissipation at the atomic scale. This model consists of a point mass (slider) that moves over and interacts weakly with a linear chain of particles interconnected by springs, representing a crystalline substrate. This interaction converts a part of the kinetic energy of the slider into phonon waves in the substrate.

Soft electroporation for delivering molecules into tightly adherent mammalian cells through 3D hollow nanoelectrodes.

Electroporation of in-vitro cultured cells is widely used in biological and medical areas to deliver molecules of interest inside cells. Since very high electric fields are required to electroporate the plasma membrane, depending on the geometry of the electrodes the required voltages can be very high and often critical to cell viability. Furthermore, in traditional electroporation configuration based on planar electrodes there is no a priori certain feedback about which cell has been targeted and delivered and the addition of fluorophores may be needed to gain this information.

Meagre effects of disuse on the human fibula are not explained by bone size or geometry.

Unlabelled: Fibula response to disuse is unknown; we assessed fibula bone in spinal cord injury (SCI) patients and able-bodied counterparts. Group differences were smaller than in the neighbouring tibia which could not be explained by bone geometry. Differential adaptation of the shank bones may indicate previously unknown mechanoadaptive behaviours of bone.

Structural differences in cortical shell properties between upper and lower human fibula as described by pQCT serial scans. A biomechanical interpretation.

This study describes the structural features of fibula cortical shell as allowed by serial pQCT scans in 10/10 healthy men and women aged 20-40years. Indicators of cortical mass (mineral content -BMC-, cross-sectional area -CSA-), mineralization (volumetric BMD, vBMD), design (perimeters, thickness, moments of inertia -MIs-) and strength (Bone Strength Indices, BSIs; polar Strength-Strain Index, pSSI) were determined. All cross-sectional shapes and geometrical or strength indicators suggested a sequence of five different regions along the bone, which would be successively adapted to 1.

Suboptimal methotrexate use in rheumatoid arthritis patients in Italy: the MARI study.

Objectives: Methotrexate (MTX) is the first choice in the treatment of rheumatoid arthritis (RA), but the doses and regimens vary significantly. For this purpose, we conducted an observational study on the use of MTX for RA in Italy (MARI study).

Methods: The MARI study included 1,327 RA patients on MTX treatment for at least 12 months, at 60 Italian rheumatology units.

Electrical charging effects on the sliding friction of a model nano-confined ionic liquid.

Recent measurements suggest the possibility to exploit ionic liquids (ILs) as smart lubricants for nano-contacts, tuning their tribological and rheological properties by charging the sliding interfaces. Following our earlier theoretical study of charging effects on nanoscale confinement and squeezout of a model IL, we present here molecular dynamics simulations of the frictional and lubrication properties of that model under charging conditions. First, we describe the case when two equally charged plates slide while being held together to a confinement distance of a few molecular layers.

Analysis of the independent power of age-related, anthropometric and mechanical factors as determinants of the structure of radius and tibia in normal adults. A pQCT study.

To compare the independent influence of mechanical and non-mechanical factors on bone features, multiple regression analyses were performed between pQCT indicators of radius and tibia bone mass, mineralization, design and strength as determined variables, and age or time since menopause (TMP), body mass, bone length and regional muscles' areas as selected determinant factors, in Caucasian, physically active, untrained healthy men and pre- and post-menopausal women. In men and pre-menopausal women, the strongest influences were exerted by muscle area on radial features and by both muscle area and bone length on the tibia. Only for women, was body mass a significant factor for tibia traits.

Squeezout phenomena and boundary layer formation of a model ionic liquid under confinement and charging.

Electrical charging of parallel plates confining a model ionic liquid down to nanoscale distances yields a variety of charge-induced changes in the structural features of the confined film. That includes even-odd switching of the structural layering and charging-induced solidification and melting, with important changes of local ordering between and within layers, and of squeezout behavior. By means of molecular dynamics simulations, we explore this variety of phenomena in the simplest charged Lennard-Jones coarse-grained model including or excluding the effect a neutral tail giving an anisotropic shape to one of the model ions.

Static friction scaling of physisorbed islands: the key is in the edge.

The static friction preventing the free sliding of nanosized rare gas solid islands physisorbed on incommensurate crystalline surfaces is not completely understood. Simulations modeled on Kr/Pb(111) highlight the importance and the scaling behavior of the island's edge contribution to static friction.

The pQCT 'Bone Strength Indices' (BSIs, SSI). Relative mechanical impact and diagnostic value of the indicators of bone tissue and design quality employed in their calculation in healthy men and pre- and post-menopausal women.

The pQCT-assessed Bone Strength Indices (BSI's, SSI) depend on the product of a 'quality' indicator, the cortical vBMD (vCtD), and a 'design' indicator, one of the cross-sectional moments of inertia or related variables (MIs) in long bones. As the MIs vary naturally much more than the vCtD and represent different properties, it could be that the variation of the indices might not reflect the relative mechanical impact of the variation of their determinant factors in different individuals or circumstances. To understand this problem, we determined the vCtD and MI's in tibia scans of 232 healthy men and pre- and post-MP women, expressed in SD of the means calculated for each group, and analyzed the independent influence of 1 SD unit of variation of each factor on that of the indices by multiple correlations.

pQCT-assessed relationships between diaphyseal design and cortical bone mass and density in the tibiae of healthy sedentary and trained men and women.

In a pQCT study of running-trained and untrained men and women we had shown that bone mass distribution along the tibia was adapted to the usage-derived stress pattern. To study the possible association between the efficiency of diaphyseal design and bone material stiffness, we extend the analysis of the same sample to correlate pQCT indicators of the distribution (CSMIs), mass (BMC), and density (vBMD) of cortical bone tissue as descriptors of "distribution/mass" (d/m) or "distribution/quality" (d/q) relationships. The d/m and d/c curves followed positive (exponential) and negative (hyperbolic-like) equations, respectively.

Mineralization- and remodeling-unrelated improvement of the post-yield properties of rat cortical bone by high doses of olpadronate.

Some pharmacologic effects on bone modeling may not be evident in studies of remodeling skeletons. This study analyzes some effects of olpadronate on cortical bone modeling and post-yield properties in femurs diaphyses (virtually only-modeling bones) of young rats by mid-diaphyseal pQCT scans and bending tests. We studied 20/22 male/female animals traetad orally with olpadronate (45-90 mg/kg/d, 3 months) and 8/9 untreated controls.