Practical training using BEWE aimed at improving the diagnosis ability of erosive tooth wear for dental students-A randomized trial.

Introduction: Erosive tooth wear (ETW) has been gaining attention due to its high prevalence. However, ETW clinical diagnosis is difficult and may go unnoticed by many professionals. The present study aimed to develop, implement and evaluate a theoretical-practical training using active methodologies in the development of undergraduate students' skills for the diagnosis of ETW compared to the traditional teaching method.

Are S-PRG composites able to resist against erosive and abrasive challenges and protect surrounding enamel in situ?

Objectives: This study evaluated the resistance of S-PRG (Surface Pre-Reacted Glass-ionomer) composites and other restorative materials against erosive and abrasive challenges and their protective effect on enamel adjacent to the restorations.

Materials And Methods: Bovine enamel blocks were prepared and randomized into 12 groups, including 6 types of material, each of them subjected to erosion_e or erosion+abrasion_ea: Beautifil II (S-PRG); Beautifil Bulk Restorative (S-PRG); Filtek Z250 XT; Filtek Bulk Fill; EQUIA Forte; Riva Light Cure. Cavities were prepared in the middle of enamel blocks and restored with the materials.

Erosion-inhibiting and enamel rehardening effects of different types of saliva.

Objectives: The objective of this study was to assess the effects of in situ saliva compared to in vitro human saliva, with or without mucin, on inhibiting erosion and promoting enamel rehardening.

Design: Bovine enamel blocks were randomly distributed into groups (n = 23): Gsitu (human saliva in situ), Gvitro (collected human saliva) and GvitroM (collected human saliva with mucin). The enamel blocks underwent a 2-hour period for the formation of salivary pellicle, based on the assigned groups.

Revisiting the use of stainless steel crowns for treatment of molar-incisor hypomineralization: a case series.

The restoration of teeth affected by molar-incisor hypomineralization (MIH) is challenging. To this end, preformed stainless steel crowns (SSCs) are a good option; however, their conventional use involves the removal of tooth structure. In the Hall technique, the SSC is seated over the primary teeth without caries removal or tooth preparation, aiming to seal carious lesions.

S-PRG-based composites erosive wear resistance and the effect on surrounding enamel.

This study evaluated Surface Pre-Reacted Glass-ionomer (S-PRG)-based-composites' surface resistance against erosive wear and their protective effect on surrounding enamel. Bovine enamel was randomized into 12 groups (n = 10/group) [erosion (e) or erosion + abrasion (a)]: nanohybrid-S-PRG-based composite (SPRGe/SPRGa), nanohybrid-S-PRG-based bulk-fill (SPRGBFe/SPRGBFa), nanoparticle-composite (RCe/RCa), nanohybrid-bulk-fill (BFe/BFa), Glass Hybrid Restorative System (GHRSe/GHRSa), and resin-modified glass-ionomer-cement (RMGICe/RMGICa). Cavities were prepared and restored.

Vitamin E: A potential preventive approach against dental erosion-an in vitro short-term erosive study.

Objectives: This study evaluated the in vitro effect of different components of palm oil on enamel in a short-term erosive challenge.

Methods: The acquired enamel pellicle (AEP) was previously formed in situ for 2 h. Subsequently, the bovine enamel blocks were treated in vitro according to following solutions: G1-palm oil; G2-85% tocotrienol solution; G3-oily vitamin E; G4-oily vitamin A; G5-deionized water (negative control); G6-stannous-containing solution (Elmex® Erosion Protection Dental Rinse) (positive control).

Impact of a simplified in situ protocol on enamel loss after erosive challenge.

This study investigated the effect of the period of use and location of intraoral appliances on enamel surface loss. This randomized, single blind in situ study was conducted in 2 crossover phases based on the period of use, in which maxillary and mandibular appliances were simultaneously worn. Bovine enamel blocks (n = 120) were randomly divided among the studied groups by surface hardness.