Post-mortem changes of anisotropic mechanical properties in the porcine brain assessed by MR elastography.

Unlabelled: Knowledge of the mechanical properties of brain tissue is essential to understanding the mechanisms underlying traumatic brain injury (TBI) and to creating accurate computational models of TBI and neurosurgical simulation. Brain white matter, which is composed of aligned, myelinated, axonal fibers, is structurally anisotropic. White matter also exhibits mechanical anisotropy, as measured by magnetic resonance elastography (MRE), but measurements of anisotropy obtained by mechanical testing of white matter have been inconsistent.

Mechanical stiffness and anisotropy measured by MRE during brain development in the minipig.

The relationship between brain development and mechanical properties of brain tissue is important, but remains incompletely understood, in part due to the challenges in measuring these properties longitudinally over time. In addition, white matter, which is composed of aligned, myelinated, axonal fibers, may be mechanically anisotropic. Here we use data from magnetic resonance elastography (MRE) and diffusion tensor imaging (DTI) to estimate anisotropic mechanical properties in six female Yucatan minipigs at ages from 3 to 6 months.

Measurement of relative motion of the brain and skull in the mini-pig in-vivo.

The mechanical role of the skull-brain interface is critical to the pathology of concussion and traumatic brain injury (TBI) and may evolve with age. Here we characterize the skull-brain interface in juvenile, female Yucatan mini-pigs from 3 to 6 months old using techniques from magnetic resonance elastography (MRE). The displacements of the skull and brain were measured by a motion-sensitive MR imaging sequence during low-amplitude harmonic motion of the head.

Design and characterization of 3-D printed hydrogel lattices with anisotropic mechanical properties.

The goal of this study was to design, fabricate, and characterize hydrogel lattice structures with consistent, controllable, anisotropic mechanical properties. Lattices, based on three unit-cell types (cubic, diamond, and vintile), were printed using stereolithography (SLA) of polyethylene glycol diacrylate (PEGDA). To create structural anisotropy in the lattices, unit cell design files were scaled by a factor of two in one direction in each layer and then printed.

Estimation of the mechanical properties of a transversely isotropic material from shear wave fields via artificial neural networks.

Artificial neural networks (ANN), established tools in machine learning, are applied to the problem of estimating parameters of a transversely isotropic (TI) material model using data from magnetic resonance elastography (MRE) and diffusion tensor imaging (DTI). We use neural networks to estimate parameters from experimental measurements of ultrasound-induced shear waves after training on analogous data from simulations of a computer model with similar loading, geometry, and boundary conditions. Strain ratios and shear-wave speeds (from MRE) and fiber direction (the direction of maximum diffusivity from diffusion tensor imaging (DTI)) are used as inputs to neural networks trained to estimate the parameters of a TI material (baseline shear modulus μ, shear anisotropy φ, and tensile anisotropy ζ).