Aging effect on surface chemistry and sorption properties of atmospheric pressure plasma treated lignocellulosic jute fibers.

Jute fibers are characterized by a heterogeneous chemical composition (cellulose and non-cellulosic components) and a complex layered structure with a hydrophobic surface outer layer responsible for their low wettability. In this work, after the removal of water-soluble components, raw jute fibers were subjected to atmospheric pressure dielectric barrier discharge (DBD) under different conditions (at 150 or 300 Hz) to tailor jute fiber surface structure and wettability. The research was focused on the aging effect during natural aging in a standard atmosphere investigated up to three weeks after DBD treatment.

Effect of plasma treatment on chemical composition, structure and sorption properties of lignocellulosic hemp fibers (Cannabis sativa L.).

Hemp fibers with different amount of hemicelluloses and lignin were subjected to atmospheric pressure dielectric barrier discharge under different conditions (40 W and 80 W power of discharge, const. time 120 s) in order to study influence of plasma treatment on their structure and sorption properties. Wettability of plasma treated samples, compared with precursors, increased due to the changes in hemp fiber surface chemistry confirmed by ATR FTIR spectroscopy and increased roughness as a consequence of intensive surface etching, observed by SEM.

Decolorization of reactive textile dyes using water falling film dielectric barrier discharge.

Decolorization of reactive textile dyes Reactive Black 5, Reactive Blue 52, Reactive Yellow 125 and Reactive Green 15 was studied using advanced oxidation processes (AOPs) in a non-thermal plasma reactor, based on coaxial water falling film dielectric barrier discharge (DBD). Used initial dye concentrations in the solution were 40.0 and 80.

A dual-use of DBD plasma for simultaneous NO(x) and SO(2) removal from coal-combustion flue gas.

Dielectric barrier discharge (DBD) was investigated for the simultaneous removal of NO(x) and SO(2) from flue gas in a coal-combustion power plant. The DBD equipment was used in either a mode where flue gas was directed through the discharge zone (direct oxidation), or a mode where produced ozonized air was injected in the flue gas stream (indirect oxidation). Removal efficiencies of SO(2) and NO for both methods were measured and compared.