The light emission from a tunneling junction induced by tunneling electrons has been studied around the cutoff at hν=eV. The emitted photons are found to exceed the excitation energy provided by the energy of the tunneling electrons. The experiments have been performed by a low- temperature scanning tunneling microscope at 80 K for an Ag(111) surface and an Ag-covered PtIr tip.
View Article and Find Full Text PDFUpgrade of a commercial ultra-high vacuum four-probe scanning tunneling microscopy system for atomic resolution capability and thermal stability is reported. To improve the mechanical and thermal performance of the system, we introduced extra vibration isolation, magnetic damping, and double thermal shielding, and we redesigned the scanning structure and thermal links. The success of the upgrade is characterized by its atomically resolved imaging, steady cooling down cycles with high efficiency, and standard transport measurement capability.
View Article and Find Full Text PDFWe analyse the electron transport in a 16 quintuple layer thick stepped BiSe film grown on Si(1 1 1) by means of scanning tunnelling potentiometry (STP) and multi-point probe measurements. Scanning tunnelling microscopy images reveal that the local structure of the BiSe film is dominated by terrace steps and domain boundaries. From a microscopic study on the nm scale by STP, we find a mostly linear gradient of the voltage on the BiSe terraces which is interrupted by voltage drops at the position of the domain boundaries.
View Article and Find Full Text PDFThe dehydrogenation and dechlorination of FeOEP-Cl on Cu(111) has been studied in detail by scanning tunneling microscopy. Although, it is not possible to follow the reaction of an individual molecule, the complete pathway of the reaction with 22 inequivalent intermediate states and the rates of the involved processes are revealed. This is achieved by combining the analysis of a large data set showing thousands of molecules in the different stages of the reaction with numerical simulations.
View Article and Find Full Text PDFThe use of three-dimensional topological insulators for disruptive technologies critically depends on the dissipationless transport of electrons at the surface, because of the suppression of backscattering at defects. However, in real devices, defects are unavoidable and scattering at angles other than 180° is allowed for such materials. Until now, this has been studied indirectly by bulk measurements and by the analysis of the local density of states in close vicinity to defect sites.
View Article and Find Full Text PDFWe report on a reversible structural phase transition of a two-dimensional system that can be locally induced by an external electric field. Two different structural configurations may coexist within a CO monolayer on Cu(111). The balance between the two phases can be shifted by an external electric field, causing the domain boundaries to move, increasing the area of the favored phase controllable both in location and size.
View Article and Find Full Text PDFBeilstein J Nanotechnol
September 2014
By using scanning tunnelling potentiometry we characterized the lateral variation of the electrochemical potential µec on the gold-induced Ge(001)-c(8 × 2)-Au surface reconstruction while a lateral current flows through the sample. On the reconstruction and across domain boundaries we find that µec shows a constant gradient as a function of the position between the contacts. In addition, nanoscale Au clusters on the surface do not show an electronic coupling to the gold-induced surface reconstruction.
View Article and Find Full Text PDFTo be or not to be chlorinated: When octaethylporphyrin iron(III) chloride (FeOEP-Cl) molecules are sublimated onto Cu(111) surfaces, two different molecular species are observed through scanning tunneling microscopy, showing either a protrusion or a depression at the center. In combination with van der Waals-corrected density functional calculations, our experiments reveal that one species corresponds to FeOEP-Cl molecules with the chlorine atom pointing away from the surface, whereas the other species has been dechlorinated.
View Article and Find Full Text PDFIndividual molecules of octa-ethyl-porhphyrin-iron(III)-chloride adsorbed on a Cu(111) surface are studied by scanning tunneling microscopy. Upon moderate heating the molecules are found to transform into Fe-tetra-benzo-porphyrin at a surprisingly low temperature of 380 K. If the annealing is interrupted, the different steps of the transformation can be imaged.
View Article and Find Full Text PDFThe electronic structure at the surface of Bi(111) enables us to study the effect of defects scattering into multiple channels. By performing scanning tunneling spectroscopy near step edges, we analyze the resulting oscillations in the local density of electronic states (LDOS) as function of position. At a given energy, forward and backward scattering not only occur simultaneously but may contribute to the same scattering vector Δk.
View Article and Find Full Text PDFThe paper describes a simple scheme enabling the real-time characterization of fluctuations, e.g., of the conductance in scanning tunneling microscopy.
View Article and Find Full Text PDFAlthough noise is observed in many experiments, it is rarely used as a source of information. However, valuable information can be extracted from noisy signals. The motion of particles on a surface induced, for example, by thermal activation or by the interaction with the tip of a scanning tunnelling microscope may lead to fluctuations or switching of the tunnelling current.
View Article and Find Full Text PDFHere we present two techniques which give insight on transport phenomena with atomic resolution. Ballistic electron emission microscopy is used to study the ballistic transport through layered heterogeneous systems. The measured ballistic fraction of the tunneling current provides information about lossless transport channels through metallic layers and organic adsorbates.
View Article and Find Full Text PDFScanning tunnelling microscopy was used to study the morphological changes of the surface of a single-crystalline silver nanowire caused by a lateral electron current. At current densities of about 1.5 × 10(7) A cm(-2), surface atoms are extracted from step edges, resulting in the motion of surface steps, islands and holes with a thickness or depth of one monolayer.
View Article and Find Full Text PDFWe report the spatial imaging of the photon transition probability of a single molecule at submolecular resolution. Photon imaging of a ringlike pattern is further resolved as two orthogonal vibronic transitions after incorporating spectral selectivity. A theoretical model and the calculated intensity images reveal that the transition probability is dominated by the symmetry of the positions of the tip and the transition dipole moment.
View Article and Find Full Text PDFAtomic-scale spatial imaging of one-dimensional chains of silver atoms allows Fermi's golden rule, a fundamental principle governing optical transitions, to be visualized. We used a scanning tunneling microscope (STM) to assemble a silver atom chain on a nickel-aluminum alloy surface. Photon emission was induced with electrons from the tip of the STM.
View Article and Find Full Text PDFWe report on ballistic electron emission microscopy and spectroscopy studies on epitaxial (3-5 nm thick) Bi(111) films, grown on n-type Si substrates. The effective barrier heights of the Schottky barrier observed are 0.58 eV for the Bi/Si(100)-(2x1) and 0.
View Article and Find Full Text PDFIf a current of electrons flows through a normal conductor (in contrast to a superconductor), it is impeded by local scattering at defects as well as phonon scattering. Both effects contribute to the voltage drop observed for a macroscopic complex system as described by Ohm's law. Although this concept is well established, it has not yet been measured around individual defects on the atomic scale.
View Article and Find Full Text PDFScanning tunneling potentiometry (STP) is a powerful tool to analyze the conductance through thin conducting layers with lateral resolution in the nanometer range. In this work, we show how a commercial ultrahigh vacuum multiprobe system, equipped with four independent tips, can be used to perform STP experiments. Two tips are gently pushed into the surface applying a lateral current through the layer of interest.
View Article and Find Full Text PDFIn this work we report on ballistic electron emission spectroscopy (BEES) studies on epitaxial layers of silver grown on silicon surfaces, with either a Si(111)-(7 × 7) or Si(100)-(2 × 1) surface reconstruction. The experiments were done at low temperature and in ultra-high vacuum (UHV). In addition, BEES measurements on polycrystalline Ag films grown on hydrogen-terminated H:Si(111)-(1 × 1) and H:Si(100)-(2 × 1) surfaces were performed.
View Article and Find Full Text PDFWe analyzed the transport of ballistic electrons through organic molecules on uniformly flat surfaces of bismuth grown on silicon. For the fullerene C60 and for a planar organic molecule (3,4,9,10-perylene-tetracarboxylic acid dianhydride), the signals revealed characteristic submolecular patterns that indicated where ballistic transport was enhanced or attenuated. The transport was associated to specific electronic molecular states.
View Article and Find Full Text PDF