Influence of ripening stage on the microwave-assisted pectin extraction from banana peels: A feasibility study targeting both the Homogalacturonan and Rhamnogalacturonan-I region.

This work investigated a sustainable and efficient approach of pectin extraction for banana peel waste valorisation and studied the influence of banana ripening stages (RS at 2,5 and 7). Although pectin content in banana peel raw material decreased during ripening, pectin extraction was favoured. The highest alcohol-insoluble solids (AIS) yield (12.

Carbon Monoxide Production during Bio-Waste Composting under Different Temperature and Aeration Regimes.

Despite the development of biorefinery processes, the possibility of coupling the "conventional" composting process with the production of biochemicals is not taken into account. However, net carbon monoxide (CO) production has been observed during bio-waste composting. So far, O concentration and temperature have been identified as the main variables influencing CO formation.

The dynamics of macro- and microplastic quantity and size changes during the composting process.

The quantity and type of macro- and microplastics was investigated in rotting material during the composting process of two state-of-the-art composting plants in Austria. Microplastics >0.2 mm, were found already after the first turning event in both facilities.

Lignin recovery from cocoa bean shell using microwave-assisted extraction and deep eutectic solvents.

Lignin is the second most abundant natural polymer after cellulose, and valorisation of lignin-rich streams has attracted increasing attention recently. This paper presents a novel and sustainable method to recover lignin from Cocoa Bean Shells (CBS) using Deep Eutectic Solvents (DES) and microwaves. A DES containing p-toluenesulfonic acid, choline chloride and glycerol (2:1:1 M ratio) was selected based on its dielectric properties.

Green and simple approach for low-cost bioproducts preparation and CO capture.

This study has demonstrated, for the first time, a simple, fast and flexible microwave processing method for the simultaneous preparation of bio-products (bio-oil, bio-gas and biochar) using a methodology that avoids any form of catalyst or chemical activation. The dielectric properties of biomass and physicochemical characterisation such as TGA, elemental and proximate analysis, XRD, SEM/EDX and textural properties, showed that 8 kJ g of microwave energy can produce superior biochars for applications in CO capture. The maximum CO uptake capacity for biochar produced was 2.

Investigating the influence of pectin content and structure on its functionality in bio-flocculant extracted from okra.

Okra extract is known to have potential application as a bio-flocculant for wastewater treatment. However, no research to date has given insight into the components responsible for the flocculating ability of okra extract or its flocculating mechanism. The work presented here addresses this knowledge gap showing that pectin, especially pectin homogalacturonan (HGA) regions, appear to be the polysaccharides responsible for the flocculating ability of okra extract.

Understanding the influence of processing conditions on the extraction of rhamnogalacturonan-I "hairy" pectin from sugar beet pulp.

Sugar beet pectin is rich in rhamnogalacturonan-I (RG-I) region, which is a potential source of prebiotics. RG-I pectin cannot be extracted the same way as commercial homogalacturan-rich pectin using hot acid. Therefore, this study has explored several alternative methods, including microwave-assisted extraction (MAE) and conventional-solvent extraction (CSE) at atmospheric pressure using different solvents, and microwave-assisted hydrothermal extraction (MAHE) under pressure using water.

Influence assessment of a lab-scale ripening process on the quality of mechanically-biologically treated MSW for possible recovery.

In this study, the influence of an additional ripening process on the quality of mechanically-biologically treated MSW was evaluated in the prospective of recovering the end material, rather than landfilling. The biostabilised waste (BSW) coming from one of the MBT plants of Rome was therefore subjected to a ripening process in slightly aerated lab test cells. An in-depth investigation on the biological reactivity was performed by means of different types of tests (aerobic and anaerobic biological tests, as well as FT-IR spectroscopy method).

Optimisation of extraction and sludge dewatering efficiencies of bio-flocculants extracted from Abelmoschus esculentus (okra).

The production of natural biopolymers as flocculants for water treatment is highly desirable due to their inherent low toxicity and low environmental footprint. In this study, bio-flocculants were extracted from Hibiscus/Abelmoschus esculentus (okra) by using a water extraction method, and the extract yield and its performance in sludge dewatering were evaluated. Single factor experimental design was employed to obtain the optimum conditions for extraction temperature (25-90 °C), time (0.

Quantification of methane emissions from full-scale open windrow composting of biowaste using an inverse dispersion technique.

An inverse dispersion technique in conjunction with Open-Path Tunable-Diode-Laser-Spectroscopy (OP-TDLS) and meteorological measurements was applied to characterise methane (CH4) emissions from an Austrian open-windrow composting plant treating source-separated biowaste. Within the measurement campaigns from July to September 2012 different operating conditions (e.g.

Large scale study on measurement of respiration activity (AT(4)) by Sapromat and OxiTop.

In the run-up for amending the Austrian landfill ordinance, parameters were developed to assess the stability/reactivity of mechanically-biologically pretreated residual wastes. The Landfill Ordinance 2008 regulates limit values for Respiration Activity (="Atmungsaktivität") RA(4) (AT(4))<7mgO(2)*(g dry matter (DM))(-1), Gas Generation Sum GS(21)<20Nl*kgDM(-1) and alternatively Gas Evolution (="Gasbildung") GB(21)<20Nl*kgDM(-1). Methods for analysing these parameters were established by the Austrian Standards Institute (2004).

Modeling the final phase of landfill gas generation from long-term observations.

For waste management, methane emissions from landfills and their effect on climate change are of serious concern. Current models for biogas generation that focus on the economic use of the landfill gas are usually based on first order chemical reactions (exponential decay), underestimating the long-term emissions of landfills. The presented study concentrated on the curve fitting and the quantification of the gas generation during the final degradation phase under optimal anaerobic conditions.

Investigations of biological processes in Austrian MBT plants.

Mechanical biological treatment (MBT) of municipal solid waste (MSW) has become an important technology in waste management during the last decade. The paper compiles investigations of mechanical biological processes in Austrian MBT plants. Samples from all plants representing different stages of degradation were included in this study.

Determination of MBT-waste reactivity - An infrared spectroscopic and multivariate statistical approach to identify and avoid failures of biological tests.

The Austrian Landfill Ordinance provides limit values regarding the reactivity for the disposal of mechanically biologically treated (MBT) waste before landfilling. The potential reactivity determined by biological tests according to the Austrian Standards (OENORM S 2027 1-2) can be underestimated if the microbial community is affected by environmental conditions. New analytical tools have been developed as an alternative to error-prone and time-consuming biological tests.

An integrated assessment of options for rural wastewater management in Austria.

This paper reports a recently finished, interdisciplinary project on rural wastewater management in Austria. The objective of the project was to study alternative wastewater management options based on separation of the wastewater into its constituent parts, and to compare them with conventional ones. Thereby, a feasibility study of both conventional and alternative options for wastewater management in six model regions was carried out.

Landfill modelling in LCA - a contribution based on empirical data.

Landfills at various stages of development, depending on their age and location, can be found throughout Europe. The type of facilities goes from uncontrolled dumpsites to highly engineered facilities with leachate and gas management. In addition, some landfills are designed to receive untreated waste, while others can receive incineration residues (MSWI) or residues after mechanical biological treatment (MBT).