From Fiber Layout to the Sensor: Preparation Methods as Key Factors for High-Quality Coupled-Core-Fiber Sensors.

During recent years, the optical-fiber-based simultaneous sensing of strain and temperature has attracted increased interest for different applications, e.g., in medicine, architecture, and aerospace.

Highly birefringent microstructured optical fiber for distributed hydrostatic pressure sensing with sub-bar resolution.

We demonstrate distributed optical fiber-based pressure measurements with sub-bar pressure resolution and 1 m spatial resolution over a ∼100 m distance using a phase-sensitive optical time-domain reflectometry technique. To do so, we have designed a novel highly birefringent microstructured optical fiber that features a high pressure to temperature sensitivity ratio, a high birefringence and a mode field diameter that is comparable to that of conventional step-index single mode fibers. Our experiments with two fibers fabricated according to the design confirm the high polarimetric pressure sensitivities (-62.

Hybrid sensor based on a hollow square core fiber for temperature independent refractive index detection.

In this work, a hybrid sensor based on a section of hollow square core fiber (HSCF) spliced between two single mode fibers is proposed for the measurement of refractive index of liquids. The sensor, with a length of a few millimeters, operates in a transmission configuration. Due to the HSCF inner geometry, two different interferometers are generated.

Simultaneous measurement of displacement and temperature using a balloon-like hybrid fiber sensor.

A fiber sensor based on a silica capillary in a balloon-like shape for simultaneous measurement of displacement and temperature is proposed and experimentally demonstrated. The sensor is fabricated by splicing a segment of a hollow-core fiber between two single-mode fibers (SMF) and by creating a balloon shape with the capillary at the top-center position. The SMF-capillary-SMF configuration excites an antiresonant (AR) guidance, and the balloon shape enhances the Mach-Zehnder interferometer (MZI).

Optical Fiber Sensor for Monitoring the Evaporation of Ethanol-Water Mixtures.

An inline optical fiber sensor is proposed to monitor in real time the evaporation process of ethanol-water binary mixtures. The sensor presents two interferometers, a cladding modal interferometer (CMI) and a Mach-Zehnder interferometer (MZI). The CMI is used to acquire the variations in the external medium refractive index, presenting a maximum sensitivity of 387 nm/RIU, and to attain the variation in the sample concentration profile, while the MZI monitors temperature fluctuations.

Double Antiresonance Fiber Sensor for the Simultaneous Measurement of Curvature and Temperature.

Antiresonant hollow core fibers (ARHCFs) have gained some attention due to their notoriously attractive characteristics on managing optical properties. In this work, an inline optical fiber sensor based on a hollow square core fiber (HSCF) is proposed. The sensor presents double antiresonance (AR), namely an internal AR and an external AR.

Multimodal nonlinear endomicroscopic imaging probe using a double-core double-clad fiber and focus-combining micro-optical concept.

Multimodal non-linear microscopy combining coherent anti-Stokes Raman scattering, second harmonic generation, and two-photon excited fluorescence has proved to be a versatile and powerful tool enabling the label-free investigation of tissue structure, molecular composition, and correlation with function and disease status. For a routine medical application, the implementation of this approach into an in vivo imaging endoscope is required. However, this is a difficult task due to the requirements of a multicolour ultrashort laser delivery from a compact and robust laser source through a fiber with low losses and temporal synchronization, the efficient signal collection in epi-direction, the need for small-diameter but highly corrected endomicroobjectives of high numerical aperture and compact scanners.

Supercontinuum generation in a carbon disulfide core microstructured optical fiber.

We demonstrate supercontinuum generation in a liquid-core microstructured optical fiber using carbon disulfide as the core material. The fiber provides a specific dispersion landscape with a zero-dispersion wavelength approaching the telecommunication domain where the corresponding capillary-type counterpart shows unsuitable dispersion properties for soliton fission. The experiments were conducted using two pump lasers with different pulse duration (30 fs and 90 fs) giving rise to different non-instantaneous contributions of carbon disulfide in each case.

Negative curvature hollow core fiber sensor for the measurement of strain and temperature.

Three different types of strain and temperature sensors based on negative curvature hollow core fiber (NCHCF) are proposed. Each sensor is produced by splicing a small section of the NCHCF between two sections of single mode fiber. Different types of interferometers are obtained simply by changing the splicing conditions.

Giant refractometric sensitivity by combining extreme optical Vernier effect and modal interference.

The optical Vernier effect consists of overlapping responses of a sensing and a reference interferometer with slightly shifted interferometric frequencies. The beating modulation thus generated presents high magnified sensitivity and resolution compared to the sensing interferometer, if the two interferometers are slightly out of tune with each other. However, the outcome of such a condition is a large beating modulation, immeasurable by conventional detection systems due to practical limitations of the usable spectral range.

Influence of pedestal diameter on mode instabilities in Yb/Ce/Al-doped fibers.

In this paper we present numerical and experimental results revealing that the mode instability threshold of highly Yb-doped, Ce/Al co-doped pedestal fibers is affected by the size of the index-increased pedestal structure surrounding the core. An alternative preparation technology for the realization of large mode area fibers with very large Al-doped silica pedestals is introduced. Three different pedestal fiber design iterations characterized by low photodarkening were manufactured and tested in counter-pumped amplifier setups.

Optical Harmonic Vernier Effect: A New Tool for High Performance Interferometric Fibre Sensors.

The optical Vernier effect magnifies the sensing capabilities of an interferometer, allowing for unprecedented sensitivities and resolutions to be achieved. Just like a caliper uses two different scales to achieve higher resolution measurements, the optical Vernier effect is based on the overlap in the responses of two interferometers with slightly detuned interference signals. Here, we present a novel approach in detail, which introduces optical harmonics to the Vernier effect through Fabry-Perot interferometers, where the two interferometers can have very different frequencies in the interferometric pattern.

Transverse single-mode operation in a passive large pitch fiber with more than 200 μm mode-field diameter.

In this Letter, we present, to the best of our knowledge, the largest effective single-mode fiber reported to date. The employed waveguide is a passive large pitch fiber (LPF), which shows the core area scaling potential of such a fiber structure. In particular, we achieved stable single-transverse mode transmission at a wavelength of 1.

Polarization-maintaining Yb-doped large-mode-area fully aperiodic large-pitch fibers.

Based on a special large-pitch architecture that has already proved its single-mode single-polarization behavior in a passive configuration, two ytterbium-doped versions of such large-mode-area fibers have been fabricated and tested in both laser and amplification configurations for high-power laser source applications. Due to the high sensitivity of large-pitch fiber design to the active-core-to-passive-cladding index mismatch, the realization of a single-polarization structure is highly challenging. However, we report on the preservation of a polarization-maintaining feature.

Polarization evolution in single-ring antiresonant hollow-core fibers.

Understanding polarization in waveguides is of fundamental importance for any photonic device and is particularly relevant within the scope of fiber optics. Here, we investigate the dependence of the geometry-induced polarization behavior of single-ring antiresonant hollow-core fibers on various parameters from the experimental perspective, showing that structural deviations from an ideal polygonal shape impose birefringence and polarization-dependent loss, confirmed by a toy model. The minimal output ellipticity was found at the wavelength of lowest loss near the center of the transmission band, whereas birefringence substantially increases toward the resonances.

Fiber-Enhanced Raman Sensing of Cefuroxime in Human Urine.

Fiber-enhanced Raman spectroscopy was developed for the chemically selective and sensitive quantification of the important antibiotic cefuroxime in human urine. A novel optical sensor fiber was drawn and precisely prepared. In this fiber structure, light is strongly confined in the selectively filled liquid core, and the Raman scattered signal is collected with unprecedented efficiency over an extended interaction length.

Resonance-enhanced multi-octave supercontinuum generation in antiresonant hollow-core fibers.

Ultrafast supercontinuum generation in gas-filled waveguides is an enabling technology for many intriguing applications ranging from attosecond metrology towards biophotonics, with the amount of spectral broadening crucially depending on the pulse dispersion of the propagating mode. In this study, we show that structural resonances in a gas-filled antiresonant hollow core optical fiber provide an additional degree of freedom in dispersion engineering, which enables the generation of more than three octaves of broadband light that ranges from deep UV wavelengths to near infrared. Our observation relies on the introduction of a geometric-induced resonance in the spectral vicinity of the ultrafast pump laser, outperforming gas dispersion and yielding a unique dispersion profile independent of core size, which is highly relevant for scaling input powers.

Fabry-Perot cavity based on silica tube for strain sensing at high temperatures.

In this work, a Fabry-Perot cavity based on a new silica tube design is proposed. The tube presents a cladding with a thickness of ~14 μm and a hollow core. The presence of four small rods, of ~20 μm diameter each, placed in diametrically opposite positions ensure the mechanical stability of the tube.

Low-loss single-mode guidance in large-core antiresonant hollow-core fibers.

We present an approach how to combine large-mode field diameters with effective single-mode guidance in a hollow-core antiresonant optical fiber. We demonstrate experimentally and in simulations that single-mode guidance is achieved in a simplified hollow-core fiber design with a core diameter of 30 μm by shifting the effective indices of the first cladding modes close to those of higher order core modes. Our fiber shows low loss propagation and effective single-mode operation from the near infrared to deep ultraviolet wavelengths down to 270 nm on a loss level of approximately 3  dB/m.

Origins of modal loss of antiresonant hollow-core optical fibers in the ultraviolet.

Recently, a novel antiresonant hollow core fiber was introduced having promising UV guiding properties. Accompanying simulations predicted ten times lower loss than observed experimentally. Increasing loss is observed in many antiresonant fibers with the origin being unknown.

High temperature sensing with fiber Bragg gratings in sapphire-derived all-glass optical fibers.

A structured sapphire-derived all-glass optical fiber with an aluminum content in the core of up to 50 mol% was used for fiber Bragg grating inscription. The fiber provided a parabolic refractive index profile. Fiber Bragg gratings were inscribed by means of femtosecond-laser pulses with a wavelength of 400 nm in combination with a two-beam phase mask interferometer.

Double antiresonant hollow core fiber--guidance in the deep ultraviolet by modified tunneling leaky modes.

Guiding light inside the hollow cores of microstructured optical fibers is a major research field within fiber optics. However, most of current fibers reveal limited spectral operation ranges between the mid-visible and the infrared and rely on complicated microstructures. Here we report on a new type of hollow-core fiber, showing for the first time distinct transmission windows between the deep ultraviolet and the near infrared.

High-sensitivity dispersive Mach-Zehnder interferometer based on a dissimilar-doping dual-core fiber for sensing applications.

A dual-core fiber in which one of the cores is doped with germanium and the other with phosphorus is used as an in-line Mach-Zehnder dispersive interferometer. By ensuring an equal length but with different dispersion dependencies in the interferometer arms (the two cores), high-sensitivity strain and temperature sensing are achieved. Opposite sensitivities for high and low wavelength peaks were also demonstrated when strain and temperature was applied.

Towards the control of highly sensitive Fabry-Pérot strain sensor based on hollow-core ring photonic crystal fiber.

A high sensitivity Fabry-Pérot (FP) strain sensor based on hollow-core ring photonic crystal fiber was investigated. A low-finesse FP cavity was fabricated by splicing a section of hollow-core ring photonic crystal fiber between two standard single mode fibers. The geometry presents a low cross section area of silica enabling to achieve high strain sensitivity.

[Remote controlled drug release in the alimentary tract by local power deposition in alternating magnetic fields].

Remote controlled release of agents in the alimentary tract is an important task of gastroenterology and pharmacy. We investigated two different methods of drug release by heating locally restricted parts in medical capsules: hysteresis losses of magnetite powder and eddy current losses of metals in alternating magnetic fields. The comparison of our experimental results with theoretically derived expectations show that both methods are suitable techniques if special technical conditions are met.