Evaluation of the Hydrophilic/Hydrophobic Balance of 13X Zeolite by Adsorption of Water, Methanol, and Cyclohexane as Pure Vapors or as Mixtures.

Adsorption isotherms of pure vapors and vapor mixtures of water, methanol, and cyclohexane were studied using a synthesized 13X zeolite (FAU topology), by means of a DVS gravimetric vapor analyzer. These results were validated by GCMC calculations. The surface chemistry of the adsorbent was characterized by the thermodesorption of ammonia, and its textural properties were studied using nitrogen physisorption.

Acylation of Anisole With Benzoyl Chloride Over Rapidly Synthesized Fly Ash-Based HBEA Zeolite.

Stable HBEA zeolite with high surface area and strong acid sites was synthesized from coal fly ash-based silica extract via indirect hydrothermal synthesis. The rapid HBEA hydrothermal crystallization times of 8, 10, and 12 h were achieved through a reduced molar water fraction in the synthesis composition. The HBEA zeolites prepared from fly ash silica extract exhibited well-defined spheroidal-shaped crystal morphology with uniform particle sizes of 192, 190, or 239 nm obtained after 8, 10, or 12 h of synthesis time, respectively.

CO Capture by Hydroxylated Azine-Based Covalent Organic Frameworks.

Covalent organic frameworks (COFs) RIO-13, RIO-12, RIO-11, and RIO-11m were investigated towards their CO capture properties by thermogravimetric analysis at 1 atm and 40 °C. These microporous COFs bear in common the azine backbone composed of hydroxy-benzene moieties but differ in the relative number of hydroxyl groups present in each material. Thus, their sorption capacities were studied as a function of their textural and chemical properties.

HKUST-1 MOF in reline deep eutectic solvent: synthesis and phase transformation.

The fate of HKUST-1 (Cu(BTC), BTC = 1,3,5-benzenetricarboxylate) in the green Deep Eutectic Solvent (DES) reline (choline chloride/urea 1 : 2) was investigated, highlighting that not only reline can be used to make this MOF but also to transform it into another crystalline material. The synthesis of HKUST-1(reline) showing good textural properties and a particular rose morphology was indeed successfully achieved in this solvent. However, upon optimizing the reaction conditions such as concentration and metal/ligand ratio, it was found that another structure Cu(BTC)Cl also forms.

Industrial carbon dioxide capture and utilization: state of the art and future challenges.

Dramatically increased CO concentration from several point sources is perceived to cause severe greenhouse effect towards the serious ongoing global warming with associated climate destabilization, inducing undesirable natural calamities, melting of glaciers, and extreme weather patterns. CO capture and utilization (CCU) has received tremendous attention due to its significant role in intensifying global warming. Considering the lack of a timely review on the state-of-the-art progress of promising CCU techniques, developing an appropriate and prompt summary of such advanced techniques with a comprehensive understanding is necessary.

Design, Synthesis and Characterization of Nickel-Functionalized Covalent Organic Framework NiCl@RIO-12 for Heterogeneous Suzuki-Miyaura Catalysis.

A series of nickel-decorated covalent organic frameworks, NiCl@RIO-12, were prepared using the post-synthetic modification strategy, that is, by reacting NiCl with pristine RIO-12 under alkaline conditions. Interestingly, they retained their crystallinity and the amount of nickel incorporated could be tuned from 3.6 to 25 wt % according to the reaction conditions.

PFG-NMR as a Tool for Determining Self-Diffusivities of Various Probe Molecules through H-ZSM-5 Zeolites.

The understanding of major zeolite applications is partially based on diffusion of molecules inside or outside microporous networks. However, it is still a challenge to measure such phenomena. The diffusion ordered nuclear magnetic resonance spectroscopy (DOSY) technique has been reported to measure a probe molecule's diffusion inside porous solids.

CO Adsorption Capacities in Zeolites and Layered Double Hydroxide Materials.

The development of technologies that allow us to reduce CO emissions is mandatory in today's society. In this regard, we present herein a comparative study of CO adsorption over three types of materials: zeolites, layered double hydroxides (LDH), and zeolites coated LDH composites. The influence of the zeolite Si/Al ratio on zeolites sorption capacity along with the presence of mesopores was investigated.

Synthesis of ZSM-5/Siliceous Zeolite Composites for Improvement of Hydrophobic Adsorption of Volatile Organic Compounds.

In this research, we investigated the hydrophobicity and dynamic adsorption-desorption behaviors of volatile organic compounds (VOCs) by applying different optimized coating dosage (25, 50, and 75%) on designed novel ZSM-5/MCM-41 and ZSM-5/Silicalite-1 hierarchical composites. The relatively large specific surface area and pore volume of adsorbents ZSM-5/MCM-41 and ZSM-5/Silicalite-1 composites with excellent stability were affirmed by XRD, FTIR, BET, SEM, and water contact angle analyses. Regarding, toluene adsorption-desorption investigation, ZSM-5/MCM-41 composite lead a longer stable toluene breakthrough time no matter under dry or 50% humid conditions.

Biomass-mediated ZSM-5 zeolite synthesis: when self-assembly allows to cross the Si/Al lower limit.

A family of Al-rich ZSM-5 zeolites with Si/Al = 8 ± 0.5 was prepared according to a biomass-mediated supramolecular approach. A combination of advanced characterisation techniques and periodic density functional theory (DFT) calculations unraveled the purity and stability of un-expected Al-enriched ZSM-5 structures, hence allowing to cross the frontier of Si/Al lower limit.

Microporous Zeolite@Vertically Aligned Mg-Al Layered Double Hydroxide Core@Shell Structures with Improved Hydrophobicity and Toluene Adsorption Capacity under Wet Conditions.

Zeolites have been recognized as one type of the most promising adsorbents for capturing volatile organic compounds (VOCs, e.g., toluene), but their performance suffers severely from water vapor under wet conditions.

Fabrication of Lithium Silicates As Highly Efficient High-Temperature CO Sorbents from SBA-15 Precursor.

A series of lithium silicates with improved CO sorption capacity were successfully synthesized using SBA-15 as the silicon precursor. The influence of Li/Si ratio, calcination temperature, and calcination duration on the chemical composition and CO capture capacity of obtained lithium silicates was systematically investigated. The correlation between CO sorption performance and crystalline phase abundance was determined using X-ray diffraction and a normalized reference intensity ratio method.

Inorganic-organic heteropolyacid-gold(I) hybrids: structures and catalytic applications.

Gold(I)-polyoxometalate hybrid complexes 1-4 ([PPh3AuMeCN]xH4-x SiW12O40, x=1-4) were synthesized and characterized. The structure of the primary gold(I)-polyoxometalate 1 (x=1) was fully ascertained by XRD, FTIR, (31)P and (29)Si magic-angle spinning (MAS) NMR, mass spectroscopy, and SEM-energy dispersive X-ray spectroscopy (EDX) techniques. Moreover, this complex exhibited better catalytic activity and selectivity compared with standard, homogeneous, gold catalysts in the new rearrangement of propargylic gem-diesters.

One-step synthesis of a highly homogeneous SBA-NHC hybrid material: en route to single-site NHC-metal heterogeneous catalysts with high loadings.

The one-step synthesis of a mesoporous silica of SBA type, functionalized with a 1-(2,6-diisopropylphenyl)-3-propyl-imidazolium (iPr2Ar-NHC-propyl) cation located in the pore channels, is described. This material was obtained by the direct hydrolysis and co-condensation of tetraethylorthosilicate (TEOS) and 1-(2,6-diisopropylphenyl)-3-[3-(triethoxysilyl)propyl]-imidazolium iodide in the presence of Pluronic P123 as a non-ionic structure-directing agent and aqueous HCl (37%) as an acid catalyst. Small-angle X-ray diffraction measurements, scanning and transmission electron microscopies, as well as dinitrogen sorption analyses revealed that the synthesized material is highly mesoporous with a 2D hexagonal arrangement of the porous network.

Diels-Alder Reaction between Isoprene and Methyl Acrylate over Different Zeolites: Influence of Pore Topology and Acidity.

The Diels-Alder reaction between isoprene and methyl acrylate over several zeolites was thoroughly investigated. ZSM-5 zeolites provided the highest productivity in methyl 4-methylcyclohex-3-enecarboxylate isomer, achieving 0.219 mmol product per mmol H in 1 hour.

Scandium(III)-zeolites as new heterogeneous catalysts for imino-Diels-Alder reactions.

This study demonstrates the first zeolite-catalyzed synthesis of piperidine derivatives, including peptidomimetics and indoloquinolizidine alkaloids. The approach developed utilizes a highly effective one-pot reaction cascade, through imine formation and imino-Diels-Alder reactions, promoted by scandium-loaded zeolites as a heterogeneous catalyst. The methodology described benefits from very low catalyst loadings (≤5 mol % of Sc(III) ), commercially and readily available starting materials, and mild reaction conditions.

Brønsted acid sites in metal-containing solid acids: from quantification to molecular design of new catalysts/silver(I)-polyoxometalates.

Based on H/D isotope exchange studies devoted to the quantification of the number of Brønsted acid sites in solid acids, we report herein an innovative approach to determine the amount of silver cations present in Keggin-type polyoxometalates (POM). The molecular design of these bifunctional heteropolyacids can therefore be achieved by varying the Ag(+)versus H(+) exchange ratio in the starting mixture. Consequently, the stoichiometries of Ag(x)H(4-x)SiW₁₂O₄₀ POM were ascertained for 0 < x < 4 by the H/D exchange technique.

Alkane activation over acidic zeolites: the first step.

The heterogeneous acid-catalyzed activation step of alkanes leading to the reaction intermediates (carbocationic or alkoxy species) was up to now the matter of a longstanding controversy. Gas chromatography and online mass spectroscopy measurements show that H(2) and methane are formed over H-zeolites, whereas HD and CH(3)D are formed over D-zeolites as the primary products in the reaction with isobutane. These results indicate that sigma-bond protolysis by strong acid sites is the first step for hydrocarbon activation on these catalysts at mild temperatures (473 K), in analogy to the activation path occurring in liquid superacid media.

ZSM-5 nanowires assembly supported on medium surface area foam beta-SiC composite with nanoscopic surface properties.

The present study reports the synthesis of supported zeolite with nanoscopic size on the SiC-based composite combining nanoscopic properties, i.e., SiC nanofibers, and macroscopic shaping, i.

Efficient synthesis of dimethyl ether over HZSM-5 supported on medium-surface-area beta-SiC foam.

In this study, we aimed to produce a highly selective and stable catalyst for the production of dimethyl ether by methanol dehydration. The activities were compared of different active phases of the employed system, zeolite HZSM-5 or gamma-alumina, supported on silicon carbide as foam, and it was found that the supported zeolite catalysts are more active than and as selective as the alumina-based catalysts. The as-prepared zeolite/SiC composites reveal good stability in long-term tests in the presence or absence of steam.

Autoassembly of nanofibrous zeolite crystals via silicon carbide substrate self-transformation.

ZSM-5 zeolite nanofibers with a size of 90 nm and lengths up to several micrometers were prepared via in-situ silicon carbide support self-transformation. The morphology and aggregation degree of these zeolite nanofibers could be modified by adjusting the pH conditions, the nature of the mineralizer (OH- or F-), or the synthesis duration. The novelty consists of the preparation of zeolite nanowires without the use of any organogelating agent, along with controlled macroscopic shapes (extrudates, foam monolith) for direct use as a structured reactor.

Experimental and DFT study of the partial oxidation of benzene by N2O over H-ZSM-5: acid catalyzed mechanism.

The reaction mechanism for hydroxylation of benzene by N(2)O has been studied on chemically modified ZSM-5 catalysts. A maximum in catalytic activity and selectivity was reached for steamed samples under mild conditions (about 30% conversion with 94% selectivity). Chemical modifications, through ion exchange (H(+) versus Na(+)), have demonstrated the importance of the presence of Brönsted acid sites.

Quantitative measurement of the Brönsted acid sites in solid acids: toward a single-site design of Mo-modified ZSM-5 zeolite.

On the basis of our previous H/D exchange studies devoted to the quantification of the number of Brönsted acid sites in solid acids, we report here an innovative approach to determine both the amount and the localization of Mo atoms inside the Mo/ZSM-5 catalyst, commonly used for the methane dehydroaromatization reaction. The influence of Mo introduction in the MFI framework was studied by means of BET, X-ray diffraction, 27Al magic angle spinning NMR, NH3 temperature-programmed desorption, and H/D isotopic exchange techniques. A dependence was found between the decrease of acidic OH groups and the Mo content.