Improved consistency of bond-line thickness when conducting single lap-shear joint tests.

This article details a method for improving the consistency of bond-line thickness during lap-shear sample preparation. This includes the schematic for a lap-shear sample test rig and consideration for controlled variation of the bond-line thickness for up to ten pairs of samples at a time. Concerns regarding the curing of the samples when held on a large heat reservoir are addressed through direct measurement of the bond-rig temperature in combination with the cure chamber temperature.

Hydroxyapatite and fluorapatite coatings on dental screws: effects of blast coating process and biological response.

This paper describes the deposition of hydroxyapatite (HA) and fluorapatite (FA) onto titanium dental screws using a novel ambient temperature coating technique named CoBlast. The process utilises a coating medium and a blast medium sprayed simultaneously at the substrate surface. The blast medium was a sintered apatite (sHA) and two particles sizes (<106 and <180 µm) were used to assess their influence on the coating process.

Co-blasting of titanium surfaces with an abrasive and hydroxyapatite to produce bioactive coatings: substrate and coating characterisation.

The aim of this work is to assess the influence of two blast media on the deposition of hydroxyapatite onto a titanium substrate using a novel ambient temperature coating technique named CoBlast. CoBlast was developed to address the problems with high temperature coating techniques. The blasting media used in this study were Al2O3 and a sintered apatite powder.

Deposition of hybrid organic-inorganic composite coatings using an atmospheric plasma jet system.

The objective of this study is to investigate the influence of alcohol addition on the incorporation of metal oxide nanoparticles into nm thick siloxane coatings. Titanium oxide (TiO2) nanoparticles with diameters of 30-80 nm were incorporated into an atmospheric plasma deposited tetramethylorthosilicate (TMOS) siloxane coating. The TMOS/TiO2 coating was deposited using the atmospheric plasma jet system known as PlasmaStream.

Microwave-assisted rapid discharge sintering of a bioactive glass-ceramic.

Bioactive glass-ceramics have been developed as successful bone graft materials. Although conventional sintering in an electrically-heated furnace is most commonly used, an alternative microwave plasma batch processing technique, known as rapid discharge sintering (RDS), is examined to crystallise the metastable base glass to form one or more ceramic phases. Apatite-mullite glass-ceramics (AMGC) were examined to elucidate the effects of RDS on the crystallization of a bioactive glass-ceramic.

Effect of titanium oxide nanoparticle incorporation into nm thick coatings deposited using an atmospheric pressure plasma.

This study reports on the use of an atmospheric plasma technique to incorporate metal oxide nanoparticles into nm thick siloxane coatings. Titanium dioxide (TiO2) particles with diameters of 30-80 nm, were mixed with a number of different siloxanes-polydimethylsiloxane, hexamethyldisiloxane and tetraethylorthosilicate (TEOS). The TiO2/TEOS mixture was found to give the most stable suspension, possibly due to the higher surface tension of TEOS compared with the other siloxanes.