The Formation and Transformation of Low-Dimensional Carbon Nanomaterials by Electron Irradiation.

Low-dimensional materials based on graphene or graphite show a large variety of phenomena when they are subjected to irradiation with energetic electrons. Since the 1990s, electron microscopy studies, where a certain irradiation dose is unavoidable, have witnessed unexpected structural transformations of graphitic nanoparticles. It is recognized that electron irradiation is not only detrimental but also bears considerable potential in the formation of new graphitic structures.

Lattice Defects in Sub-Micrometer Spin-Crossover Crystals Studied by Electron Diffraction.

Spin-crossover particles of [Fe(Htrz)trz](BF) with sizes of some hundred nanometers are studied by electron microscopy. Despite their high radiation sensitivity, it was possible to analyze the particles by imaging and diffraction so that a detailed analysis of crystallographic defects in individual particles became possible. The presence of one or several tilt boundaries, where the tilt axis is the direction of the polymer chains, is detected in each particle.

Laser-Driven Transient Phase Oscillations in Individual Spin Crossover Particles.

An unusual expansion dynamics of individual spin crossover nanoparticles is studied by ultrafast transmission electron microscopy. After exposure to nanosecond laser pulses, the particles exhibit considerable length oscillations during and after their expansion. The vibration period of 50-100 ns is of the same order of magnitude as the time that the particles need for a transition from the low-spin to the high-spin state.

Photo-Thermal Switching of Individual Plasmonically Activated Spin Crossover Nanoparticle Imaged by Ultrafast Transmission Electron Microscopy.

Spin crossover (SCO) is a promising switching phenomenon when implemented in electronic devices as molecules, thin films or nanoparticles. Among the properties modulated along this phenomenon, optically induced mechanical changes are of tremendous importance as they can work as fast light-induced mechanical switches or allow to investigate and control microstructural strains and fatigability. The development of characterization techniques probing nanoscopic behavior with high spatio-temporal resolution allows to trigger and visualize such mechanical changes of individual nanoscopic objects.

Sub-4 nm Nanodiamonds from Graphene-Oxide and Nitrated Polycyclic Aromatic Hydrocarbons at 423 K.

Nanodiamonds are interesting materials from the point of view of their biocompatibility and their chemical, spectroscopic, and mechanical properties. Current synthetic methods for nanodiamonds involve harsh environments, which are potentially hazardous in addition to being expensive. We report a low-temperature (423 K) hydrothermal approach to form nanodiamonds by using graphene-oxide or nitrated polycyclic aromatic hydrocarbons (naphthalene, anthracene, phenanthrene, or pyrene) as a starting material.

Nanosecond electron pulses in the analytical electron microscopy of a fast irreversible chemical reaction.

We show how the kinetics of a fast and irreversible chemical reaction in a nanocrystalline material at high temperature can be studied using nanosecond electron pulses in an electron microscope. Infrared laser pulses first heat a nanocrystalline oxide layer on a carbon film, then single nanosecond electron pulses allow imaging, electron diffraction and electron energy-loss spectroscopy. This enables us to study the evolution of the morphology, crystallography, and elemental composition of the system with nanosecond resolution.

Improving atomic displacement and replacement calculations with physically realistic damage models.

Atomic collision processes are fundamental to numerous advanced materials technologies such as electron microscopy, semiconductor processing and nuclear power generation. Extensive experimental and computer simulation studies over the past several decades provide the physical basis for understanding the atomic-scale processes occurring during primary displacement events. The current international standard for quantifying this energetic particle damage, the Norgett-Robinson-Torrens displacements per atom (NRT-dpa) model, has nowadays several well-known limitations.

Electron Beam Etching of CaO Crystals Observed Atom by Atom.

With the rapid development of nanoscale structuring technology, the precision in the etching reaches the sub-10 nm scale today. However, with the ongoing development of nanofabrication the etching mechanisms with atomic precision still have to be understood in detail and improved. Here we observe, atom by atom, how preferential facets form in CaO crystals that are etched by an electron beam in an in situ high-resolution transmission electron microscope (HRTEM).

Electron beam dynamics in an ultrafast transmission electron microscope with Wehnelt electrode.

High temporal resolution transmission electron microscopy techniques have shown significant progress in recent years. Using photoelectron pulses induced by ultrashort laser pulses on the cathode, these methods can probe ultrafast materials processes and have revealed numerous dynamic phenomena at the nanoscale. Most recently, the technique has been implemented in standard thermionic electron microscopes that provide a flexible platform for studying material's dynamics over a wide range of spatial and temporal scales.

Growth of single-layer boron nitride dome-shaped nanostructures catalysed by iron clusters.

We report on the growth and formation of single-layer boron nitride dome-shaped nanostructures mediated by small iron clusters located on flakes of hexagonal boron nitride. The nanostructures were synthesized in situ at high temperature inside a transmission electron microscope while the e-beam was blanked. The formation process, typically originating at defective step-edges on the boron nitride support, was investigated using a combination of transmission electron microscopy, electron energy loss spectroscopy and computational modelling.

The formation of the smallest fullerene-like carbon cages on metal surfaces.

The nucleation and growth of carbon on catalytically active metal surfaces is one of the most important techniques to produce nanomaterials such as graphene or nanotubes. Here it is shown by in situ electron microscopy that fullerene-like spherical clusters with diameters down to 0.4 nm and thus much smaller than C60 grow in a polymerized state on Co, Fe, or Ru surfaces.

Towards nanoprinting with metals on graphene.

Graphene and carbon nanotubes are envisaged as suitable materials for the fabrication of the new generation of nanoelectronics. The controlled patterning of such nanostructures with metal nanoparticles is conditioned by the transfer between a recipient and the surface to pattern. Electromigration under the impact of an applied voltage stands at the base of printing discrete digits at the nanoscale.

Chains of carbon atoms: A vision or a new nanomaterial?

Linear strings of sp(1)-hybridized carbon atoms are considered as a possible phase of carbon since decades. Whereas the debate about the stability of the corresponding bulk phase carbyne continues until today, the existence of isolated chains of carbon atoms has meanwhile been corroborated experimentally. Since graphene, as the two-dimensional sp(2)-bonded allotrope of carbon, has become a vast field, the question about the importance of one-dimensional carbon became of renewed interest.

Strain-induced metal-semiconductor transition observed in atomic carbon chains.

Carbyne, the sp(1)-hybridized phase of carbon, is still a missing link in the family of carbon allotropes. While the bulk phases of carbyne remain elusive, the elementary constituents, that is, linear chains of carbon atoms, have already been observed using the electron microscope. Isolated atomic chains are highly interesting one-dimensional conductors that have stimulated considerable theoretical work.

Quasi-2D Cu2 S crystals on graphene: in-situ growth and ab-initio calculations.

Two-dimensional crystals of beta-copper sulfide are synthesized in an in-situ electron microscopy experiment. Copper crystals are deposited on an amorphous carbon film containing sulfur. The carbon film graphitizes upon heating and electron irradiation and allows the reaction of Cu and S towards two-dimensional Cu(2) S crystals.

Investigating the thermostability of succinate: quinone oxidoreductase enzymes by direct electrochemistry at SWNTs-modified electrodes and FTIR spectroscopy.

Succinate: quinone reductases (SQRs) are the enzymes that couple the oxidation of succinate and the reduction of quinones in the respiratory chain of prokaryotes and eukaryotes. Herein, we compare the temperature-dependent activity and structural stability of two SQRs, the first from the mesophilic bacterium Escherichia coli and the second from the thermophilic bacterium Thermus thermophilus, using a combined electrochemical and infrared spectroscopy approach. Direct electron transfer was achieved with full membrane protein complexes at single-walled carbon nanotube (SWNT)-modified electrodes.

Microscopic bimetallic actuator based on a bilayer of graphene and graphene oxide.

We present an actuator, consisting of a bilayer of graphene and graphene oxide, which allows us to exert forces in micromechanical systems that are at least 50 times higher than reported for other actuators of comparable size. The durability of such a device and stability during many cycles are demonstrated, and the related mechanism is discussed in detail.

Electrical transport measured in atomic carbon chains.

The first electrical-transport measurements of monatomic carbon chains are reported in this study. The chains were obtained by unraveling carbon atoms from graphene ribbons while an electrical current flowed through the ribbon and, successively, through the chain. The formation of the chains was accompanied by a characteristic drop in the electrical conductivity.

In situ growth of cellular two-dimensional silicon oxide on metal substrates.

Crystalline hexagonally ordered silicon oxide layers with a thickness of less than a nanometer are grown on transition metal surfaces in an in situ electron microscopy experiment. The nucleation and growth of silica bilayers and monolayers, which represent the thinnest possible ordered structures of silicon oxide, are monitored in real time. The emerging layers show structural defects reminiscent of those in graphene and can also be vitreous.

Anomalous high capacitance in a coaxial single nanowire capacitor.

Building entire multiple-component devices on single nanowires is a promising strategy for miniaturizing electronic applications. Here we demonstrate a single nanowire capacitor with a coaxial asymmetric Cu-Cu(2)O-C structure, fabricated using a two-step chemical reaction and vapour deposition method. The capacitance measured from a single nanowire device corresponds to ~140 μF cm(-2), exceeding previous reported values for metal-insulator-metal micro-capacitors and is more than one order of magnitude higher than what is predicted by classical electrostatics.