Effect of Low-Level Laser Irradiation on Proliferative Activity of Wharton's Jelly Mesenchymal Stromal Cells.

We studied the effect of low-level laser irradiation on proliferative activity of cultured human Wharton's jelly mesenchymal stromal sells. Cells were irradiated with a solid-state laser emitting at 650 nm; irradiation doses were 0.04, 0.

Laser MICROSAMPLING of soil microbial community.

[Image: see text]

Photoluminescence of Drying Droplets with Silicon Nanoparticles.

This study is dedicated to the formation of structures during drying of droplets of sols of silicon nanoparticles (SiNPs) in dimethylsulfoxide (DMSO) with a diameter of 1-5 mm on the horizontal glass and mica surfaces. Drying of such droplets with pinning (sticking) of the droplet contact line causes gradual gathering of the SiNPs on its edge with the formation of a thin ring. It has been found that the integral photoluminescence intensity I greatly varies during the drying process.

Laser printing of microbial systems: effect of absorbing metal film.

Recently, it was shown that laser-induced forward transfer (LIFT) technology and the laser engineering of microbial systems (LEMS) technique (based on LIFT method) are effective for isolation of micro-organisms from different complex substrates. These techniques frequently utilize Au as an absorbing layer material. The purpose of this study was to investigate the influence of absorbing film materials (Au, Ti and Cr) on the effectiveness of laser printing of micro-organisms to improve LEMS and LIFT techniques.

Anomalous behavior of nonlinear refractive indexes of CO and Xe in supercritical states.

Direct measurement of pressure dependent nonlinear refractive index of CO and Xe in subcritical and supercritical states are reported. In the vicinity of the ridge (or the Widom line), corresponding to the maximum density fluctuations, the nonlinear refractive index reaches a maximum value (up to 4.8*10m/W in CO and 3.

Reinforced Hybrid Collagen Sponges for Tissue Engineering.

We created an anisotropic material based on collagen sponge and reactive polylactide structured by laser photopolymerization. The combination of collagen with reactive polylactide improves the resistance of the formed matrices to biodegradation in comparison with collagen sponge, while the existence of sites with different mechanical characteristics and cell affinity on the matrix provides directed cell growth during their culturing. It was shown that reinforcement of the collagen sponges 7-fold increased the mean Young's modulus for the hybrid matrix without affecting its cytotoxicity.

Osteoinducing scaffolds with multi-layered biointerface.

This study was aimed to design and characterise hybrid tissue-engineered constructs composed of osteoinducing polylactide-based scaffolds with multi-layered cellular biointerface for bone tissue reconstruction. Three-dimensional scaffolds with improved hydrophilic and osteoinducing properties were produced using the surface-selective laser sintering (SSLS) method. The designed scaffold pattern had dimensions of 8 × 8 × 2.

Publisher Correction: Carbon nanowalls as a platform for biological SERS studies.

A correction to this article has been published and is linked from the HTML and PDF versions of this paper. The error has been fixed in the paper.

Carbon nanowalls as a platform for biological SERS studies.

Herein we report about developing new type of Surface Enhanced Raman Scattering (SERS) substrates based on Au-decorated carbon nanowalls. The designed substrates possess high specific surface area and high sensitivity. Chemical stability of Au perfectly blends with electrical properties and high value of specific surface area of carbon nanowalls.

The role of laser power and pullback velocity in the endovenous laser ablation efficacy: an experimental study.

Endovenous laser ablation is an effective and minimally invasive alternative to surgical removal of incompetent veins. However, many controversies concerning optimal laser parameters usage in this procedure still remain. The purpose of this experimental study was to assess the adequate parameters required for vein wall destruction and to evaluate the role of fiber pullback velocity on vessel wall degradation.

Surface micromorphology of cross-linked tetrafunctional polylactide scaffolds inducing vessel growth and bone formation.

In the presented study, we have developed a synthetic strategy allowing a gradual variation of a polylactide arms' length, which later influences the micromorphology of the scaffold surface, formed by a two-photon polymerization technique. It has been demonstrated that the highest number of cells is present on the scaffolds with the roughest surface made of the polylactide with longer arms (PLA760), and osteogenic differentiation of mesenchymal stem cells is most pronounced on such scaffolds. According to the results of biological testing, the PLA760 scaffolds were implanted into a created cranial defect in a mouse for an in vivo assessment of the bone tissue formation.

Reconstruction of Ligament and Tendon Defects Using Cell Technologies.

We studied the possibility of restoring the integrity of the Achilles tendon in rabbits using autologous multipotent stromal cells. Collagen or gelatin sponges populated with cells were placed in a resorbable Vicryl mesh tube and this tissue-engineered construct was introduced into a defect of the middle part of the Achilles tendon. In 4 months, histological analysis showed complete regeneration of the tendon with the formation of parallel collagen fibers, spindle-shaped tenocytes, and newly formed vessels.

Generation of an adjustable multi-octave supercontinuum under near-IR filamentation in gaseous, supercritical, and liquid carbon dioxide.

A new supercontinuum (SC) source from high-pressure gas, liquid, and supercritical fluid CO aggregate states that covers more than two octaves (from 400 nm up to 2 μm) is successively reported by using a 200 fs pulsed pump at 1.24 μm under femtosecond filamentation. The key features of the proposed source are the highly adjustable nonlinear properties (comparable with condensed matter) of the medium.

Formation of Neural Networks in 3D Scaffolds Fabricated by Means of Laser Microstereolithography.

We developed and tested new 3D scaffolds for neurotransplantation. Scaffolds of predetermined architectonic were prepared using microstereolithography technique. Scaffolds were highly biocompatible with the nervous tissue cells.

[Compatibility of cells of the nervous system with structured biodegradable chitosan-based hydrogel matrices].

Hydrogel matrices for cell cultivation have been generated by two-photon laser polymerization of unsaturated chitosan derivatives and methacrylated hyaluronic acid. The adhesive and toxic properties of the matrices have been assessed, and the matrices have been shown to have a good compatibility with primary hippocampal cell cultures. The formation of morphologically normal neural networks by cells of the nervous system cultured on the surface of hydrogel matrices has been observed.

Chitosan impregnation with biologically active tryaryl imidazoles in supercritical carbon dioxide.

The presented paper is focused on impregnation of chitosan and its derivatives with a biologically active triaryl imidazole model compound ((2-2-hydroxyphenyl)-4.5-diphenyl-1H-imidazole) in the supercritical carbon dioxide medium. Since initial chitosan represents a polycation-exchange resin and does not swell in supercritical carbon dioxide, the impregnation was carried out in the presence of water (0.

Induction of the Adaptive Response in Mice Exposed to He-Ne Laser and X-Ray Radiation.

We studied the dose-dependent induction of in vivo adaptive response in the bone marrow and blood of mice exposed to low-intensity radiation of He-Ne laser (633 nm) and X-ray radiation by the severity of cytogenetic injury and intensity of ROS production, respectively. Induction of the adaptive response in mice preexposed to He-Ne laser and X-ray radiation depended on the adaptive dose and the interval between the adaptive and main doses and correlated with changes in ROS generation. The adaptive response after exposure to low-intensity ionizing and non-ionizing radiation was observed in the same dose range, which attests to similar mechanisms of its induction.

Novel biodegradable star-shaped polylactide scaffolds for bone regeneration fabricated by two-photon polymerization.

Aim: To assess the properties of 3D biodegradable scaffolds fabricated from novel star-shaped poly(D,L-lactide) (SSL) materials for bone tissue regeneration.

Materials & Methods: The SSL polymer was synthesized using an optimized synthetic procedure and applied for scaffold fabrication by the two-photon polymerization technique. The osteogenic differentiation was controlled using human adipose-derived stem cells cultured for 28 days.

Comparative Analysis of Proliferation and Viability of Multipotent Mesenchymal Stromal Cells in 3D Scaffolds with Different Architectonics.

3D biodegradable materials (scaffolds) containing bioactive hydroxyapatite molecules fabricated by foaming in supercritical carbon dioxide and by selective laser sintering were used for culturing of mesenchymal stromal cells from the human adipose tissue. Experiments showed that stromal cells from the human adipose tissue adhered and proliferated on all studied types of structures. Addition of hyproxyapatite to the scaffold stimulated proliferation of stromal adipose tissue cells.

In Vitro Effect of Laser-Induced Hydrodynamics on Cancer Cells.

We studied the effect of laser-induced hydrodynamic on viability of Colo-26 murine colon carcinoma cells in vitro. Laser-induced hydrodynamics was generated by a laser (λ=1.56 μ, power 3 W, 5 min exposure); to this end, the fiber end was submersed into a buffer above the cell monolayer.

Effects of acoustic and EHF impulses on multipotent stromal cells during formation of bone marrow containing heterotopic organs in tissue engineered constructions.

We studied the effects of physical factors (acoustic impulses of laser-induced hydrodynamics, AILIH, and EHF-radiation) on the formation of heterotopic bone marrow organs. Suspension of precipitated mouse bone marrow cells was exposed to AILIH and EHF or their combinations (AILIH+EHF, EHF+AILIH). The developed tissue engineering constructions (gelatin sponges containing 107 nucleated bone marrow cells exposed to physical factors) were transplanted under the renal capsule of syngeneic mice.

Collagen structure deterioration in the skin of patients with pelvic organ prolapse determined by atomic force microscopy.

We used atomic force microscopy (AFM) to diagnose pathological changes in the extracellular matrix (ECM) of skin connective tissue in patients with pelvic organ prolapse (POP). POP is a common condition affecting women that considerably decreases the patients' quality of life. Deviations from normal morphology of the skin ECM from patients with POP occur including packing and arrangement of individual collagen fibers and arrangement of collagen fibrils.

Osteogenic differentiation of human mesenchymal stem cells in 3-D Zr-Si organic-inorganic scaffolds produced by two-photon polymerization technique.

Two-photon polymerization (2PP) is applied for the fabrication of 3-D Zr-Si scaffolds for bone tissue engineering. Zr-Si scaffolds with 150, 200, and 250 μm pore sizes are seeded with human bone marrow stem cells (hBMSCs) and human adipose tissue derived stem cells (hASCs) and cultured in osteoinductive and control media for three weeks. Osteogenic differentiation of hASCs and hBMSCs and formation of bone matrix is comparatively analyzed via alkaline phosphatase activity (ALP), calcium quantification, osteocalcin staining and scanning electron microscopy (SEM).

Effects of gamma irradiation on collagen damage and remodeling.

Purpose: To evaluate the dose-time dependences of structural changes occurring in collagen within 24 hours to three months after gamma-irradiation at doses from 2-40 Gy in vivo.

Materials And Methods: Rat's tail tendon was chosen as in vivo model, with its highly ordered collagen structure allowing the changes to be interpreted unambiguously. Macromolecular level (I) was investigated by differential scanning calorimetry (DSC); fibers and bundles level (II) by laser scanning microscopy (LSM), and bulk tissue microstructural level (III) by cross-polarization optical coherence tomography (CP-OCT).

Large-scale high-quality 2D silica crystals: dip-drawing formation and decoration with gold nanorods and nanospheres for SERS analysis.

High-quality colloidal crystals (CCs) are important for use in photonic research and as templates for large-scale plasmonic SERS substrates. We investigated how variations in temperature, colloid concentration, and dip-drawing parameters (rate, incubation time, etc) affect the structure of 2D CCs formed by highly monodisperse silica nanoparticles (SiNPs) synthesized in an l-arginine solution and regrown by a modified Stöber method. The best quality 2D CCs were obtained with aqueous 12 wt% colloids at a temperature of 25 °C, an incubation time of 1 min, and a drawing rate of 50 mm min(-1).