Effect of Dispersed ZrO Particles on Microstructure Evolution and Superconducting Properties of Nb-Ti Alloy.

The influence of dispersed ZrO particles on the microstructure evolution and the superconducting properties of a Nb-Ti alloy was investigated. The studied materials were prepared by different methods including mechanical alloying (MA) and arc-melting. The obtained samples were studied by X-ray diffraction (XRD) and vibrating-sample magnetometer (VSM).

Investigation of Layered Structure Formation in MgB Wires Produced by the Internal Mg Coating Process under Low and High Isostatic Pressures.

Currently, MgB wires made by the powder-in-tube (PIT) method are most often used in the construction and design of superconducting devices. In this work, we investigated the impact of heat treatment under both low and high isostatic pressures on the formation of a layered structure in PIT MgB wires manufactured using the Mg coating method. The microstructure, chemical composition, and density of the obtained superconductive wires were investigated using scanning electron microscopy (SEM) with an energy-dispersive X-ray spectroscopy (EDS) analyzer and optical microscopy with Kameram CMOS software (version 2.

Anisotropies of thermal conductivity of SrIr4In2Ge4 and EuIr4In2Ge4 crystals: Manifestation of coupling of phonons with europium spin 1D fluctuations?

We report the results of measurements of thermal conductivity coefficient dependence on temperature of single crystals of SrIr4In2Ge4 and EuIr4In2Ge4. The measurements were carried out over the temperature range of ∼5-300 K. The EuIr4In2Ge4 crystal, unlike its strontium analog SrIr4In2Ge4, shows an amazing anisotropy: At low temperatures, it displays significantly smaller thermal conductivity in the ab plane than in the direction of c axis, while at the high ones the thermal conductivity in the direction perpendicular to the c axis increases well above that of in the c axis.

A Segmental 2D Readout Board Manufactured in Printed Circuit Board Technology for Gas Electron Multiplier Detectors.

The Gas Electron Multiplier (GEM) was introduced by Fabio Sauli in 1997. This technology is broadly used in current and planned High-Energy Physics (HEP) experiments. One of the key components of these detectors is a readout board, which collects charges amplified by GEM foils and transfers them to readout electronics.

Effect of Low Annealing Temperature on the Critical-Current Density of 2% C-Doped MgB Wires Used in Superconducting Coils with the Wind-and-React (W&R) Method-High-Field and High-Temperature Pinning Centers.

The use of a low annealing temperature during the production of coils made from superconducting materials is very important because it reduces the production costs. In this study, the morphology, transport critical-current density (), irreversible magnetic field (), and critical temperature () of straight wires and small 2% C-doped MgB coils were investigated. The coils were made using the wind-and-react (W&R) method and annealed at various temperatures from 610 °C to 650 °C for 2-12 h.

Enhanced Superconducting Critical Parameters in a New High-Entropy Alloy NbTiZrTaHf.

The structural and physical properties of the new titanium- and niobium-rich type-A high-entropy alloy (HEA) superconductor Nb0.34Ti0.33Zr0.

Effects of Ni/Co doping on structural and electronic properties of 122 and 112 families of Eu based iron pnictides.

Superconductivity in high-temperature superconductors such as cuprates or iron pnictides is typically achieved by hole or electron doping and it is of great interest to understand how doping affects their properties leading to superconductivity. To study it we conducted Fe and As K edge x-ray absorption spectroscopy measurements on several electron doped compounds from the 112 and 122 family of Eu-based iron pnictides. XANES and EXAFS results confirm that dopants are located at expected sites.

Magnetic Field Influence on the Microwave Characteristics of Composite Samples Based on Polycrystalline Y-Type Hexaferrite.

Here, we report results on the magnetic and microwave properties of polycrystalline Y-type hexaferrite synthesized by sol-gel auto-combustion and acting as a filler in a composite microwave-absorbing material. The reflection losses in the 1-20 GHz range of the Y-type hexaferrite powder dispersed homogeneously in a polymer matrix of silicon rubber were investigated in the absence and in the presence of a magnetic field. A permanent magnet was used with a strength of 1.

Canted antiferromagnetic order in EuZnAs single crystals.

Compounds containing Eu show a vast range of unique physical properties due to the interplay of electronic and magnetic properties, which can lead to a nontrivial electronic topology combined with magnetic order. We report on the growth of trigonal ([Formula: see text] space group) EuZnAs single crystals and on the studies of their structural, electronic and magnetic properties. A range of experimental techniques was applied including X-ray diffraction, electron microscopy, magnetic susceptibility, magnetization, heat capacity and Mössbauer spectroscopy in the study.

LTCC Strip Electrode Arrays for Gas Electron Multiplier Detectors.

The Low Temperature Cofired Ceramic (LTCC) technology has proven to be highly suitable for 3D microstructures manufacturing in electronic devices due to its excellent electrical and mechanical properties. In this paper, a novel idea of implementing the LTCC structures into high-energy particle detectors technology is proposed. It can be applied in High Energy Physics (HEP) laboratories, where such sophisticated sensors are constantly exposed to particles of the TeV energy range for many years.

Fe and Eu Mössbauer studies of 3d-4f spin interplay in EuFeNiAs.

The EuFeNiAs (with 0 ≤ x ≤ 0.4) compounds exhibiting 3d and/or 4f magnetic order were investigated by means of Fe and Eu Mössbauer spectroscopy. Additionally, results for EuNiAs are reported for comparison.

Data supporting the results of the characterization of the phases and structures appearing during the synthesis process of BaSrZnNiFeO by auto-combustion.

The data presented has to do with identifying the various phases arising during the synthesis of the Y-type hexaferrite series BaSrZnNiFeO by auto-combustion that we deem important for their microstructural and magnetic properties. The data and the related analyses support the research paper "Ni-substitution effect on the properties of BaSrZnNiFeO powders" [1]. Thus, the parameters are presented of the phases appearing after auto-combustion and after the initial annealing at 800 °C, namely, crystal cell and crystallite size.

Superconductivity Emerging from an Electronic Phase Separation in the Charge Ordered Phase of RbFe_{2}As_{2}.

^{75}As, ^{87}Rb, and ^{85}Rb nuclear quadrupole resonance (NQR) and ^{87}Rb nuclear magnetic resonance measurements in a RbFe_{2}As_{2} iron-based superconductor are presented. We observe a marked broadening of the ^{75}As NQR spectrum below T_{0}≃140  K which is associated with the onset of a charge order in the FeAs planes. Below T_{0} we observe a power-law decrease in the ^{75}As nuclear spin-lattice relaxation rate down to T^{*}≃20  K.

FAPA mass spectrometry of designer drugs.

Application of a flowing atmospheric-pressure afterglow ion source for mass spectrometry (FAPA-MS) for the analysis of designer drugs is described. In this paper, we present application of FAPA MS for identification of exemplary psychotropic drugs: JWH-122, 4BMC, Pentedrone, 3,4-DNNC and ETH-CAT. We have utilized two approaches for introducing samples into the plasma stream; first in the form of a methanolic aerosol from the nebulizer, and the second based on a release of vapors from the electrically heated crucible by thermal desorption.

Electrochemical generation of selegiline metabolites coupled to mass spectrometry.

The metabolic pathways of selegiline (a drug used for the treatment of early-stage Parkinson's disease) were analyzed by electrochemical oxidation with application of the flow electrochemical cell consisting of three electrodes (ROXY™, Antec, the Netherlands). Two types of working electrodes were applied: glassy carbon (GC) and boron-doped diamond (BDD). The potential applied at working electrode and composition of the solvent were optimized for the best conditions for oxidation and identification processes.

Molecular scavengers as carriers of analytes for mass spectrometry identification.

Storage and preconcentration of various molecules by molecular scavengers for thermal desorption and identification by mass spectrometry is presented. A dielectric barrier discharge ionization source combined with a heating element for the chemical characterization of amines and organic acids, initially trapped by molecular scavengers, is described. The developed technique can be applied for preconcentration of minute amounts of molecules in liquid and gaseous phases, as well as their transportation and thorough analysis.

Dielectric barrier discharge ionization in characterization of organic compounds separated on thin-layer chromatography plates.

A new method for on-spot detection and characterization of organic compounds resolved on thin layer chromatography (TLC) plates has been proposed. This method combines TLC with dielectric barrier discharge ionization (DBDI), which produces stable low-temperature plasma. At first, the compounds were separated on TLC plates and then their mass spectra were directly obtained with no additional sample preparation.

Investigation of thermal effects in through-silicon vias using scanning thermal microscopy.

Results of quantitative investigations of copper through-silicon vias (TSVs) are presented. The experiments were performed using scanning thermal microscopy (SThM), enabling highly localized imaging of thermal contrast between the copper TSVs and the surrounding material. Both dc and ac active-mode SThM was used and differences between these variants are shown.

Atmospheric pressure plasma jet with high-voltage power supply based on piezoelectric transformer.

The dielectric barrier discharge plasma jet, an example of the nonthermal atmospheric pressure plasma jet (APPJ), generates low-temperature plasmas that are suitable for the atomization of volatile species and can also be served as an ionization source for ambient mass and ion mobility spectrometry. A new design of APPJ for mass spectrometry has been built in our group. In these plasma sources magnetic transformers (MTs) and inductors are typically used in power supplies but they present several drawbacks that are even more evident when dealing with high-voltage normally used in APPJs.