Non-invasive volumetric assessment of aortic atheroma: a core laboratory validation using computed tomography angiography.

Aortic atherosclerosis has been linked with worse peri- and post-procedural outcomes following a range of aortic procedures. Yet, there are currently no standardized methods for non-invasive volumetric pan-aortic plaque assessment. We propose a novel means of more accurately assessing plaque volume across whole aortic segments using computed tomography angiography (CTA) imaging.

The going home initiative: getting critical care patients home with hospice.

Although considerable effort is being directed at providing patients and their families with a "good death," most patients in intensive care units, if given the choice, would prefer to die at home. With little guidance from the literature, the palliative care committee of an intensive care unit developed guidelines to get patients home from the intensive care unit to die. In the past few years, the unit has transferred many patients home with hospice care, much to the delight of their families.

Bonding of self-adhesive (self-etching) root canal sealers to radicular dentin.

The latest generation of methacrylate resin-based sealers has eliminated the use of separate self-etching primers by incorporating acidic resin monomers in the sealers to render them self-adhesive to dentin. This study examined the adhesive strengths, interfacial ultrastructure, and tracer penetration of a nonetching (EndoREZ; Ultradent, South Jordan, UT) and two self-adhesive methacrylate resin-based sealers (MetaSEAL; Parkell, Farmington, NY, and RealSeal SE; SybronEndo, Orange, CA) when they were applied to radicular dentin following the manufacturers' recommended use of EDTA as the active final rinse. A modified push-out testing design was used to evaluate the dislodgement of core-free sealers.

Contemporary methacrylate resin-based root canal sealers exhibit different degrees of ex vivo cytotoxicity when cured in their self-cured mode.

The cytotoxicity of four methacrylate resin-based sealers was investigated by the 3-(4,5-dimethyl-thiazoyl)-2,5-diphenyl-tetrazolium bromide assay, which measures cell viability by assessing its succinate dehydrogenase activity. The sealers were polymerized in the self-cured mode to simulate the setting condition upon their extrusion into periradicular tissues. Disks were prepared from EndoREZ (Ultradent, South Jordan, UT), RealSeal (SybronEndo, Orange, CA), MetaSEAL (Parkell, Farmington, NY), and RealSeal SE (SybronEndo) together with positive and negative controls.

A study of functional outcomes following implantation of a total distal radioulnar joint prosthesis.

This paper reports a long-term follow-up measuring pain, range of motion and weight-bearing ability, following implantation of a total distal radioulnar joint prosthesis. This prosthesis differs from excision arthroplasties and ulnar head replacements by replacing all three components of the distal radioulnar joint, viz. the sigmoid notch, the ulnar head and the triangular fibrocartilage.

Distal ulnar prosthetic replacement.

A stable, functioning distal radioulnar joint not only provides supination and pronation of the forearm but also is essential to gripping and lifting. Therefore, when distal radioulnar joint deterioration occurs, proper repair is crucial. Ulnar head resection typically is performed; however, a prosthesis may be needed to replace all or part of the joint.

Computer assisted identification and classification of streptomycete promoters.

Short sequences that were over represented in a database of Streptomyces promoter region sequences were identified. These sequences and others that were selected on the basis of the characteristics of known promoters, were tested to determine if they were found predominantly at particular distances from the transcription start site. In several cases obvious clusters were recorded.

Transposon mutagenesis of Clostridium acetobutylicum P262: isolation and characterization of solvent deficient and metronidazole resistant mutants.

An efficient transposon mutagenesis system using conjugative transposons Tn916 and Tn925::Tn917 was established for Clostridium acetobutylicum P262, an industrial strain which has proved difficult to manipulate genetically. Transposon insertions occurred at several different locations to produce a variety of mutants. An oligosporogenous mutant deficient in acetone and butanol production, and two sporulation-deficient and metronidazole resistant mutants were characterized with respect to differentiation and solvent production.

Demonstration of a relation between urinary digoxin-like immunoreactive substance and cardiac performance.

Objective: To determine the relation between urinary digoxin-like immunoreactive substance (DLIS) and cardiac performance.

Design: Cohort study.

Setting: Echocardiography laboratory of a university-affiliated teaching hospital.

An azophenolic colorimetric reagent for use in enzyme-linked immunosorbent assays.

A colorimetric reagent, 4-(4'-nitro-2'-methylsulfonylphenylazo)phenyl phosphate (NMPP), has been shown to be an effective substrate of alkaline phosphatase. NMPP and p-nitrophenyl phosphate were applied in comparative studies using enzyme immunoassays for the detection of viral antigens and antiviral antibodies. The new substrate exhibited similar, or even higher, sensitivity than p-nitrophenyl phosphate depending on the substrate concentrations used.

Urinary digoxin-like immunoreactive substance in pregnancy. Relation to urinary electrolytes.

High concentrations of digoxin-like immunoreactive substance (DLIS) have been identified in amniotic fluid and in blood during pregnancy. In this study, urine from healthy women was analyzed for DLIS during pregnancy and following delivery, and levels were related to various clinical and urinary findings. Urinary DLIS increased progressively during pregnancy, having a linear relation to gestational week (DLIS = 0.

A diazo-based dry film for determination of total bilirubin in serum.

We have prepared a diazo-based dry film for use in determining total serum bilirubin. On a transparent support are a buffered gelatin layer containing a polymeric quaternary amine (the mordant) and a white, reflective spreading layer that contains all of the components necessary for detection of bilirubin. The method is based on the use of dyphylline and Triton X-100 surfactant to dissociate bilirubin from albumin and subsequent reaction of bilirubin with a diazonium salt [4-(N-carboxymethylsulfamyl)benzenediazonium hexafluorophosphate].