A state-of-the-art review of the recent advances in drug delivery systems for different therapeutic agents in periodontitis.

Periodontitis (PD) is a chronic gum illness that may be hard to cure for a number of reasons, including the fact that no one knows what causes it, the side effects of anti-microbial treatment, and how various kinds of bacteria interact with one another. As a result, novel therapeutic approaches for PD treatment must be developed. Additionally, supplementary antibacterial regimens, including local and systemic medication administration of chemical agents, are necessary for deep pockets to assist with mechanical debridement of tooth surfaces.

The potential use of nanozymes as an antibacterial agents in oral infection, periodontitis, and peri-implantitis.

Several studies suggest that oral pathogenic biofilms cause persistent oral infections. Among these is periodontitis, a prevalent condition brought on by plaque biofilm. It can even result in tooth loss.

Spotlight on therapeutic efficiency of green synthesis metals and their oxide nanoparticles in periodontitis.

Periodontitis, one of the most prevalent dental diseases, causes the loss of bone and gum tissue that hold teeth in place. Several bacteria, commonly present in clinically healthy oral cavities, may induce and perpetuate periodontitis when their concentration rises in the gingival sulcus. Antibacterial effect against various Gram-negative and Gram-positive bacteria, including pathogenic and drug-resistant ones, has been shown for several distinct transient metal and metal oxide NPs.

Fabrication of a customized impression metal jig for an implant-supported overdenture with a milled bar.

The use of computer-aided design/computer-aided manufacturing technology simplifies the laboratory and clinical steps for the fabrication of implant prostheses. It also reduces additional costs for the prosthetic components and technical procedures. This article describes a modified impression technique using an impression metal jig to enhance the accuracy of final impression and also to eliminate the need for the try-in of resin pattern of the milled bar.