Enhancing the Mechanical Properties of Co-Cr Dental Alloys Fabricated by Laser Powder Bed Fusion: Evaluation of Quenching and Annealing as Heat Treatment Methods.

Residual stresses and anisotropic structures characterize laser powder bed fusion (L-PBF) products due to rapid thermal changes during fabrication, potentially leading to microcracking and lower strength. Post-heat treatments are crucial for enhancing mechanical properties. Numerous dental technology laboratories worldwide are adopting the new technologies but must invest considerable time and resources to refine them for specific requirements.

A Novel Measurement Approach to Experimentally Determine the Thermomechanical Properties of a Gas Foil Bearing Using a Specialized Sensing Foil Made of Inconel Alloy.

Modern approaches dedicated to controlling the operation of gas foil bearings require advanced measurement techniques to comprehensively investigate the bearings' thermal and thermomechanical properties. Their successful long-term maintenance with constant operational characteristics may be feasible only when the allowed thermal and mechanical regimes are rigorously kept. Hence, an adequate acquisition of experimental readings for the critical physical quantities should be conducted to track the actual condition of the bearing.

Research on Linear Actuators for Active Foil Bearings.

Active foil bearings are a kind of gas foil bearing. They contain actuators which allow for modification of the bearing sleeve size and the shape of the lubrication gap. Rotor vibrations can be actively controlled by these changes.

Embedded Optical Fibre with Fibre Bragg Grating Influence on Additive Manufactured Polymeric Structure Durability.

Additive manufacturing (AM) polymers are applied in many branches of the industry due to the possibility of fast and accurate production of elements with various and complex shapes. Fibre Bragg grating sensors (FBG) are widely applied in structural health monitoring (SHM) systems. The main objective of this research is to perform analyses of the influence of embedded FBG sensors on AM polymer elements' durability.

Additively Manufactured Parts Made of a Polymer Material Used for the Experimental Verification of a Component of a High-Speed Machine with an Optimised Geometry-Preliminary Research.

This paper describes a novel method for the experimental validation of numerically optimised turbomachinery components. In the field of additive manufacturing, numerical models still need to be improved, especially with the experimental data. The paper presents the operational characteristics of a compressor wheel, measured during experimental research.