Synergic Catalysis: the Importance of Intermetallic Separation in Co(III)K(I) Catalysts for Ring Opening Copolymerizations.

Dinuclear polymerization catalysts can show high activity and control. Understanding how to design for synergy between the metals is important to improving catalytic performances. Three heterodinuclear Co(III)K(I) catalysts, featuring very similar coordination chemistries, are prepared with different intermetallic separations.

Understanding catalytic synergy in dinuclear polymerization catalysts for sustainable polymers.

Understanding the chemistry underpinning intermetallic synergy and the discovery of generally applicable structure-performances relationships are major challenges in catalysis. Additionally, high-performance catalysts using earth-abundant, non-toxic and inexpensive elements must be prioritised. Here, a series of heterodinuclear catalysts of the form Co(III)M(I/II), where M(I/II) = Na(I), K(I), Ca(II), Sr(II), Ba(II) are evaluated for three different polymerizations, by assessment of rate constants, turn over frequencies, polymer selectivity and control.

Correlating Metal Redox Potentials to Co(III)K(I) Catalyst Performances in Carbon Dioxide and Propene Oxide Ring Opening Copolymerization.

Carbon dioxide copolymerization is a front-runner CO utilization strategy but its viability depends on improving the catalysis. So far, catalyst structure-performance correlations have not been straightforward, limiting the ability to predict how to improve both catalytic activity and selectivity. Here, a simple measure of a catalyst ground-state parameter, metal reduction potential, directly correlates with both polymerization activity and selectivity.

Solid-State Chemical Recycling of Polycarbonates to Epoxides and Carbon Dioxide Using a Heterodinuclear Mg(II)Co(II) Catalyst.

Polymer chemical recycling to monomers (CRM) could help improve polymer sustainability, but its implementation requires much better understanding of depolymerization catalysis, ensuring high rates and selectivity. Here, a heterodinuclear [Mg(II)Co(II)] catalyst is applied for CRM of aliphatic polycarbonates, including poly(cyclohexene carbonate) (PCHC), to epoxides and carbon dioxide using solid-state conditions, in contrast with many other CRM strategies that rely on high dilution. The depolymerizations are performed in the solid state giving very high activity and selectivity (PCHC, TOF = 25700 h, CHO selectivity >99 %, 0.

Insights into the Mechanism of Carbon Dioxide and Propylene Oxide Ring-Opening Copolymerization Using a Co(III)/K(I) Heterodinuclear Catalyst.

A combined computational and experimental investigation into the catalytic cycle of carbon dioxide and propylene oxide ring-opening copolymerization is presented using a Co(III)K(I) heterodinuclear complex (Deacy, A. C. Co(III)/Alkali-Metal(I) Heterodinuclear Catalysts for the Ring-Opening Copolymerization of CO and Propylene Oxide.

Synergic Heterodinuclear Catalysts for the Ring-Opening Copolymerization (ROCOP) of Epoxides, Carbon Dioxide, and Anhydrides.

The development of sustainable plastic materials is an essential target of chemistry in the 21st century. Key objectives toward this goal include utilizing sustainable monomers and the development of polymers that can be chemically recycled/degraded. Polycarbonates synthesized from the ring-opening copolymerization (ROCOP) of epoxides and CO, and polyesters synthesized from the ROCOP of epoxides and anhydrides, meet these criteria.

Chemical Recycling of Poly(Cyclohexene Carbonate) Using a Di-Mg Catalyst.

Chemical recycling of polymers to true monomers is pivotal for a circular plastics economy. Here, the first catalyzed chemical recycling of the widely investigated carbon dioxide derived polymer, poly(cyclohexene carbonate), to cyclohexene oxide and carbon dioxide is reported. The reaction requires dinuclear catalysis, with the di-Mg catalyst showing both high monomer selectivity (>98 %) and activity (TOF=150 h , 0.

Heterodinuclear Mg(II)M(II) (M=Cr, Mn, Fe, Co, Ni, Cu and Zn) Complexes for the Ring Opening Copolymerization of Carbon Dioxide/Epoxide and Anhydride/Epoxide.

The catalysed ring opening copolymerizations (ROCOP) of carbon dioxide/epoxide or anhydride/epoxide are controlled polymerizations that access useful polycarbonates and polyesters. Here, a systematic investigation of a series of heterodinuclear Mg(II)M(II) complexes reveals which metal combinations are most effective. The complexes combine different first row transition metals (M(II)) from Cr(II) to Zn(II), with Mg(II); all complexes are coordinated by the same macrocyclic ancillary ligand and by two acetate co-ligands.

Mg(ii) heterodinuclear catalysts delivering carbon dioxide derived multi-block polymers.

Carbon dioxide derived polymers are emerging as useful materials for applications spanning packaging, construction, house-hold goods and automotive components. To accelerate and broaden their uptake requires both more active and selective catalysts and greater structural diversity for the carbon dioxide derived polymers. Here, highly active catalysts show controllable selectivity for the enchainment of mixtures of epoxide, anhydride, carbon dioxide and lactone.

Sequence Control from Mixtures: Switchable Polymerization Catalysis and Future Materials Applications.

There is an ever-increasing demand for higher-performing polymeric materials counterbalanced by the need for sustainability throughout the life cycle. Copolymers comprising ester, carbonate, or ether linkages could fulfill some of this demand as their monomer-polymer chemistry is closer to equilibrium, facilitating (bio)degradation and recycling; many monomers are or could be sourced from renewables or waste. Here, an efficient and broadly applicable route to make such copolymers is discussed, a form of switchable polymerization catalysis which exploits a single catalyst, switched between different catalytic cycles, to prepare block sequence selective copolymers from monomer mixtures.

Co(III)/Alkali-Metal(I) Heterodinuclear Catalysts for the Ring-Opening Copolymerization of CO and Propylene Oxide.

The ring-opening copolymerization of carbon dioxide and propene oxide is a useful means to valorize waste into commercially attractive poly(propylene carbonate) (PPC) polyols. The reaction is limited by low catalytic activities, poor tolerance to a large excess of chain transfer agent, and tendency to form byproducts. Here, a series of new catalysts are reported that comprise heterodinuclear Co(III)/M(I) macrocyclic complexes (where M(I) = Group 1 metal).

Ti(IV)-Tris(phenolate) Catalyst Systems for the Ring-Opening Copolymerization of Cyclohexene Oxide and Carbon Dioxide.

Titanium(IV) complexes of amino-tris(phenolate) ligands (LTiX, X = chloride, isopropoxide) together with bis(triphenylphosphine)iminium chloride (PPNCl) are active catalyst systems for the ring-opening copolymerization of carbon dioxide and cyclohexene oxide. They show moderate activity, with turnover frequency values of ∼60 h (0.02 mol % of catalyst, 80 °C, 40 bar of CO) and high selectivity (carbonate linkages >90%), but their absolute performances are lower than those of the most active Ti(IV) catalyst systems.

Understanding metal synergy in heterodinuclear catalysts for the copolymerization of CO and epoxides.

Carbon dioxide and epoxide copolymerization is an industrially relevant means to valorize waste and improve sustainability in polymer manufacturing. Given the value of the polymer products-polycarbonates or polyether carbonates-it could provide an economic stimulus to capture and storage technologies. The process efficiency depends upon the catalyst, and previously Zn(II)Mg(II) heterodinuclear catalysts showed good performances at low carbon dioxide pressures, attributed to synergic interactions between the metals.

Heterodinuclear complexes featuring Zn(ii) and M = Al(iii), Ga(iii) or In(iii) for cyclohexene oxide and CO copolymerisation.

The ring opening copolymerisation of CO and epoxides is a useful means to valorise waste emissions and to reduce pollution in polymer manufacturing. Heterodinuclear catalysts, particularly those of Zn(ii)/Mg(ii), have shown better performances than homodinuclear analogues in this reaction. As part of on-going efforts to better understand the catalytic synergy, this work describes a series of heterodinuclear complexes, combining Zn(ii) with a metal from Group 13 (M = Al(iii), Ga(iii) or In(iii)).

Groups 1, 2 and Zn(II) Heterodinuclear Catalysts for Epoxide/CO Ring-Opening Copolymerization.

A series of heterodinuclear complexes are reported where both Zn(II) and a metal from Group 1 or 2 are chelated by a macrocyclic diphenolate-tetra-amine ligand. The complexes are characterized in the solid state, where relevant by single crystal X-ray crystallography and elemental analysis, and in solution, using NMR spectroscopy and mass spectrometry. The complex synthesis is achieved by reaction of the ligand with diethyl zinc to form the monozinc complex, in situ, followed by subsequent coordination of the second metal; this method enables heterodinuclear conversions >90% as determined by NMR spectroscopy.

Versatile Catalytic Hydrogenation Using A Simple Tin(IV) Lewis Acid.

Despite the rapid development of frustrated Lewis pair (FLP) chemistry over the last ten years, its application in catalytic hydrogenations remains dependent on a narrow family of structurally similar early main-group Lewis acids (LAs), inevitably placing limitations on reactivity, sensitivity and substrate scope. Herein we describe the FLP-mediated H activation and catalytic hydrogenation activity of the alternative LA iPr SnOTf, which acts as a surrogate for the trialkylstannylium ion iPr Sn , and is rapidly and easily prepared from simple, inexpensive starting materials. This highly thermally robust LA is found to be competent in the hydrogenation of a number of different unsaturated functional groups (which is unique to date for main-group FLP LAs not based on boron), and also displays a remarkable tolerance to moisture.