Smartphone-enabled flow injection amperometric glucose monitoring based on a screen-printed carbon electrode modified with PEDOT@PB and a GOx@PPtNPs@MWCNTs nanocomposite.

This study presents a modified screen-printed carbon electrode (SPCE) to determine glucose in a custom-built flow injection system. The biosensor was constructed by immobilizing glucose oxidase on porous platinum nanoparticles decorated on multi-walled carbon nanotubes (GOx@PPtNPs@MWCTNs). The fabrication of the biosensor was completed by coating the GOx@PPtNPs@MWCTNs nanocomposite on an SPCE modified with a nanocomposite of poly(3,4-ethylenedioxythiophene) and Prussian blue (GOx@PPtNPs@MWCTNs/PEDOT@PB/SPCE).

Flow injection amperometric uric acid biosensor based on AuNPs-GO-CS porous composite cryogel coated on PB-PEDOT:PSS modified screen-printed carbon electrode.

An enzymatic amperometric uric acid (UA) biosensor was successfully developed by modifying a screen-printed carbon electrode (SPCE) with Prussian blue-poly(3,4-ethylene dioxythiophene) polystyrene sulfonate composite (PB-PEDOT:PSS). The modified SPCE was coated with gold nanoparticles-graphene oxide-chitosan composite cryogel (AuNPs-GO-CS cry). Uricase (UOx) was directly immobilized via chemisorption on AuNPs.

Disposable Polyaniline/-Phenylenediamine-Based Electrochemical Lactate Biosensor for Early Sepsis Diagnosis.

Lactate serves as a crucial biomarker that indicates sepsis assessment in critically ill patients. A rapid, accurate, and portable analytical device for lactate detection is required. This work developed a stepwise polyurethane-polyaniline--phenylenediamine via a layer-by-layer based electrochemical biosensor, using a screen-printed gold electrode for lactate determination in blood samples.

Voltammetric sensor for an anti-cancer drug cisplatin based on bismuth nanoparticles/graphene modified glassy carbon electrode.

A selective and sensitive voltammetric sensor for the measurement of the chemotherapy drug cisplatin was based on bismuth nanoparticles decorated on a graphene-modified glassy carbon electrode (BiNPs/Gr/GCE). The surface morphologies of electrode modifications were characterized using scanning electron microscopy (SEM). Electrochemical characteristics were evaluated by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS).

A Novel Microfluidic-Based OMC-PEDOT-PSS Composite Electrochemical Sensor for Continuous Dopamine Monitoring.

Fast and precise analysis techniques using small sample volumes are required for next-generation clinical monitoring at the patient's bedside, so as to provide the clinician with relevant chemical data in real-time. The integration of an electrochemical sensor into a microfluidic chip allows for the achievement of real-time chemical monitoring due to the low consumption of analytes, short analysis time, low cost, and compact size. In this work, dopamine, used as a model, is an important neurotransmitter responsible for controlling various vital life functions.

An enzymatic histamine biosensor based on a screen-printed carbon electrode modified with a chitosan-gold nanoparticles composite cryogel on Prussian blue-coated multi-walled carbon nanotubes.

A histamine biosensor was developed based on a screen-printed carbon electrode modified with Prussian blue (PB) electrodeposited on multi-walled carbon nanotubes covered with a macroporous layer of chitosan-gold nanoparticles composite cryogel (CS-AuNPs Cry). With its high specific surface area and conductivity, CS-AuNPs Cry proved an excellent supporting material for diamine oxidase (DAO) immobilization. PB acted as a redox mediator to promote electron transfer between hydrogen peroxide and the electrode surface.

An ultrasensitive label-free electrochemical immunosensor based on 3D porous chitosan-graphene-ionic liquid-ferrocene nanocomposite cryogel decorated with gold nanoparticles for prostate-specific antigen.

A highly sensitive and selective label-free electrochemical immunosensor was successfully fabricated for measuring prostate-specific antigen (PSA). A composite of chitosan, graphene, ionic liquid and ferrocene (CS-GR-IL-Fc) was drop casted onto a screen-printed carbon electrode (SPCE) and frozen to create a layer of 3D porous cryogel (CS-GR-IL-Fc cry) which was decorated with gold nanoparticles (AuNPs). The biocompatibility and porosity of the cryogel increased the surface area available for AuNPs loading via amino groups and the population of anti-PSA, immobilized on the AuNPs via chemisorption, could be increased.

A highly sensitive flow injection amperometric glucose biosensor using a gold nanoparticles/polytyramine/Prussian blue modified screen-printed carbon electrode.

A novel oxidase enzyme sensor was fabricated based on the chemisorption of highly active glucose oxidase (GOx) on gold nanoparticles that were adsorbed on a polytyramine layer (AuNPs/Pty). The GOx/AuNPs/Pty assembly was coated on a Prussian blue (PB)-modified screen-printed carbon electrode (SPCE) to produce the GOx/AuNPs/Pty/PB/SPCE biosensor. The amperometric glucose biosensor response was measured at -0.

Simultaneous Detection of Ammonium and Nitrate in Environmental Samples Using on Ion-Selective Electrode and Comparison with Portable Colorimetric Assays.

Simple, robust, and low-cost nitrate- and ammonium-selective electrodes were made using substrate prepared from household materials. We explored phosphonium-based ILs and poly (methyl methacrylate)/poly(decyl methacrylate)(MMA-DMA) copolymer as matrix materials alternative to classical PVC-based membranes. IL-based membranes showed suitability only for nitrate-selective electrode exhibiting linear concentration range between 5.

Phage-based capacitive biosensor for Salmonella detection.

This article reports the detection of Salmonella spp. based on M13 bacteriophage in a capacitive flow injection system. Salmonella-specific M13 bacteriophage was immobilized on a polytyramine/gold surface using glutaraldehyde as a crosslinker.

Pyrrolidinyl PNA polypyrrole/silver nanofoam electrode as a novel label-free electrochemical miRNA-21 biosensor.

A label-free electrochemical miRNA biosensor was developed based on a pyrrolidinyl peptide nucleic acid (acpcPNA)/polypyrrole (PPy)/silver nanofoam (AgNF) modified electrode. The AgNF was electrodeposited as redox indicator on a gold electrode, which was then functionalized with an electropolymerized layer of PPy, a conducting polymer, to immobilize the PNA probes. The fabrication process was investigated by electrochemical impedance spectroscopy.

Capacitive antibacterial susceptibility screening test with a simple renewable sensing surface.

A simple renewable surface for a rapid antibacterial susceptibility test has been demonstrated. The 3-aminophenylboronic acid (3-APBA) modified electrode bind with cis-diol groups on the cell wall of both gram positive and gram negative bacteria. The detection of antibacterial susceptibility response by a capacitive system can be done within a short time, 2.

4-mercaptophenylboronic acid functionalized gold nanoparticles for colorimetric sialic acid detection.

A simple and selective colorimetric sensor for sialic acid detection, based on the aggregation of 4-mercaptophenylboronic acid functionalized gold nanoparticles (4-MPBA-AuNPs) was developed. The color of the solution changed from wine-red to blue after binding with sialic acid. The colorimetric sensor provided good analytical performances with a linear dynamic range of 80µM to 2.

Enhancing capacitive DNA biosensor performance by target overhang with application on screening test of HLA-B*58:01 and HLA-B*57:01 genes.

A highly sensitive label-free DNA biosensor based on PNA probes immobilized on a gold electrode was used to detect a hybridization event. The effect of a target DNA overhang on the hybridization efficiency was shown to enhance the detected signal and allowed detection at a very low concentration. The sensors performances were investigated with a complementary target that had the same length as the probe, and the signal was compared to the target DNAs with different lengths and overhangs.

Highly-sensitive label-free electrochemical carcinoembryonic antigen immunosensor based on a novel Au nanoparticles-graphene-chitosan nanocomposite cryogel electrode.

For the first time, a simple and highly sensitive label-free electrochemical carcinoembryonic antigen (CEA) immunosensor based on a cryogel electrode has been developed and tested. The as-prepared nanocomposite combined the advantages of the graphene, AuNPs and chitosan (AuNPs-GP-CS) together with the ease of preparing a cryogel coupled to a silver deposition, to act as a redox mediator, on a Au electrode. Under the optimal conditions, the decrease of the cyclic voltammetry (CV) silver peak current was proportional to the CEA concentration over a range of from 1.

A novel molecularly imprinted chitosan-acrylamide, graphene, ferrocene composite cryogel biosensor used to detect microalbumin.

A novel highly sensitive and selective molecularly imprinted polymer (MIP) cryogel biosensor for determination of microalbumin in urine samples was fabricated. The MIP gel was prepared based on the graft copolymerization of acrylamide with N,N'-methylenebisacrylamide on chitosan using human serum albumin (HSA) as the template. The sub-zero polymerization allowed the solvent to form ice crystals and left a macroporous cryogel structure when it was thawed.

Electrochemical detection of the disease marker human chitinase-3-like protein 1 by matching antibody-modified gold electrodes as label-free immunosensors.

Tissue inflammation, certain cardiovascular syndromes and the occurrence of some solid tumors are correlated with raised serum concentrations of human chitinase-3-like protein 1 (YKL-40), a mammalian chitinase-like glycoprotein, which has become the subject of current research. Here we report the construction and characterization of an electrochemical platform for label-free immunosensing of YKL-40. Details of the synthesis of YKL-40 and production of anti-YKL-40 immunoglobulin G (IgG) are provided and cross-reactivity tests presented.

An amperometric uric acid biosensor based on chitosan-carbon nanotubes electrospun nanofiber on silver nanoparticles.

A novel amperometric uric acid biosensor was fabricated by immobilizing uricase on an electrospun nanocomposite of chitosan-carbon nanotubes nanofiber (Chi-CNTsNF) covering an electrodeposited layer of silver nanoparticles (AgNPs) on a gold electrode (uricase/Chi-CNTsNF/AgNPs/Au). The uric acid response was determined at an optimum applied potential of -0.35 V vs Ag/AgCl in a flow-injection system based on the change of the reduction current for dissolved oxygen during oxidation of uric acid by the immobilized uricase.

Label-free capacitive DNA sensor using immobilized pyrrolidinyl PNA probe: effect of the length and terminating head group of the blocking thiols.

This paper reports, for the first time, the influence of the length and the terminating head group of blocking thiols on the sensitivity and specificity of a label-free capacitive DNA detection system using immobilized pyrrolidinyl peptide nucleic acid (acpcPNA) probes. A C-terminal lysine-modified acpcPNA was immobilized through four different alkanethiol self-assembled monolayers (SAMs), i.e.

Interference compensation for thin layer coulometric ion-selective membrane electrodes by the double pulse technique.

Ion-selective membranes operated in a thin layer coulometric detection mode have previously been demonstrated to exhibit attractive characteristics in view of realizing sensors without the need for frequent recalibration. In this methodology, the analyte ion is exhaustively removed across an ion-selective membrane by an applied potential, and the resulting current is integrated to yield the coulomb number and hence the amount of analyte originally present in the sample. This exhaustive process, however, places greater demands on the selectivity of the membrane compared to direct potentiometry, since the level of interference will increase as the analyte depletes.

Label-free capacitive immunosensors for ultra-trace detection based on the increase of immobilized antibodies on silver nanoparticles.

Detection of ultra-trace amounts of antigens by label-free capacitive immunosensors was investigated using electrodes modified with silver nanoparticles (AgNPs) that allows for an increase in the amount of immobilized antibodies. The optimal amount of AgNPs that provided the highest immobilization yield was 48 pmol (in 2.0 mL).

Ultra trace analysis of small molecule by label-free impedimetric immunosensor using multilayer modified electrode.

A multilayer electrode modified with a self-assembled thiourea monolayer (SATUM) followed by gold nanoparticles (AuNPs), mercaptosuccinic acid (MSA) and antibody was investigated for the detection of ultra trace amount of a small molecule (chloramphenicol) in an impedimetric system. The formation of the antibody-antigen complex at the electrode surface caused the impedance to increase. Under optimum conditions three modified electrodes were compared the SATUM/AuNPs/MSA electrode provided a wide linear range (0.

Affinity sensor using 3-aminophenylboronic acid for bacteria detection.

Boronic acid that can reversibly bind to diols was used to detect bacteria through its affinity binding reaction with diol-groups on bacterial cell walls. 3-aminophenylboronic acid (3-APBA) was immobilized on a gold electrode via a self-assembled monolayer. The change in capacitance of the sensing surface caused by the binding between 3-APBA and bacteria in a flow system was detected by a potentiostatic step method.

Capacitive biosensor for quantification of trace amounts of DNA.

A flow injection capacitive biosensor system to detect trace amounts DNA has been developed based on the affinity binding between immobilized histone and DNA. Histones from calf thymus and shrimp were immobilized on gold electrodes covered with self-assembled monolayer (SAM) of thioctic acid. Each of these histones was used to detect DNA from calf thymus, shrimp and Escherichia coli.

Aptamer-based potentiometric measurements of proteins using ion-selective microelectrodes.

We here report on the first example of an aptamer-based potentiometric sandwich assay of proteins. The measurements are based on CdS quantum dot labels of the secondary aptamer, which were determined with a novel solid-contact Cd2+-selective polymer membrane electrode after dissolution with hydrogen peroxide. The electrode exhibited cadmium ion detection limits of 100 pM in 100 mL samples and of 1 nM in 200 microL microwells, using a calcium-selective electrode as a pseudoreference electrode.