Interface Investigation on SiGe/Si Multilayer Structures: Influence of Different Epitaxial Process Conditions.

SiGe/Si multilayer is the core structure of the active area of gate-all-around field-effect transistors and semiconductor quantum computing devices. In this paper, high-quality SiGe/Si multilayers have been grown by a reduced-pressure chemical vapor deposition system. The effects of temperature, pressure, interface processing (dichlorosilane (SiHCl, DCS) and hydrogen chloride (HCl)) on improving the transition thickness of SiGe to Si interfaces were investigated.

Demonstration of Germanium Vertical Gate-All-Around Field-Effect Transistors Featured by Self-Aligned High-κ Metal Gates with Record High Performance.

A special Ge nanowire/nanosheet (NW/NS) p-type vertical sandwich gate-all-around (GAA) field-effect transistor (FET) (Ge NW/NS pVSAFET) with self-aligned high-κ metal gates (HKMGs) is proposed. The Ge pVSAFETs were fabricated by high-quality GeSi/Ge epitaxy, an exclusively developed self-limiting isotropic quasi atomic layer etching (qALE) of Ge selective to both GeSi and the (111) plane, top-drain implantation, and ozone postoxidation (OPO) channel passivation. The Ge pVSAFETs, which have hourglass-shaped (111) channels with the smallest size range from 5 to 20 nm formed by qALE, have reached a record high of ∼291 μA/μm and exhibited good short channel effects (SCEs) control.

High-Quality Recrystallization of Amorphous Silicon on Si (100) Induced via Laser Annealing at the Nanoscale.

At sub-3 nm nodes, the scaling of lateral devices represented by a fin field-effect transistor (FinFET) and gate-all-around field effect transistors (GAAFET) faces increasing technical challenges. At the same time, the development of vertical devices in the three-dimensional direction has excellent potential for scaling. However, existing vertical devices face two technical challenges: "self-alignment of gate and channel" and "precise gate length control".

Insight into over Repair of Hot Carrier Degradation by GIDL Current in Si p-FinFETs Using Ultra-Fast Measurement Technique.

In this article, an experimental study on the gate-induced drain leakage (GIDL) current repairing worst hot carrier degradation (HCD) in Si p-FinFETs is investigated with the aid of an ultra-fast measurement (UFM) technique (~30 μs). It is found that increasing GIDL bias from 3 V to 4 V achieves a 114.7% V recovery ratio from HCD.

Selective Digital Etching of Silicon-Germanium Using Nitric and Hydrofluoric Acids.

A digital etching method was proposed to achieve excellent control of etching depth. The digital etching characteristics of p-Si and SiGe using a combination of HNO oxidation and buffered oxide etching oxide removal processes were investigated. Experimental results showed that oxidation saturates as time goes on because of low activation energy and its diffusion-limited characteristic.

Strained SiGe/Ge multilayer Stacks Epitaxially Grown on a Low-/high-Temperature Ge Buffer Layer and Selective Wet-Etching of Germanium.

With the development of new designs and materials for nano-scale transistors, vertical Gate-All-Around Field Effect Transistors (vGAAFETs) with germanium as channel materials have emerged as excellent choices. The driving forces for this choice are the full control of the short channel effect and the high carrier mobility in the channel region. In this work, a novel process to form the structure for a VGAA transistor with a Ge channel is presented.

A Novel Dry Selective Isotropic Atomic Layer Etching of SiGe for Manufacturing Vertical Nanowire Array with Diameter Less than 20 nm.

Semiconductor nanowires have great application prospects in field effect transistors and sensors. In this study, the process and challenges of manufacturing vertical SiGe/Si nanowire array by using the conventional lithography and novel dry atomic layer etching technology. The final results demonstrate that vertical nanowires with a diameter less than 20 nm can be obtained.

Joining copper oxide nanotube arrays driven by the nanoscale Kirkendall effect.

Various annealing conditions (environment, temperature, and duration) are applied to study the nanoscale Kirkendall effect of copper (Cu) nanowire (NW) arrays on a Si substrate. The results show that an appropriate amount of oxygen supply is crucial for uniform transformation from Cu NWs (average diameter ∼50 nm) into Cu oxide nanotube arrays. An annealing duration of 30 min at 200 °C in a low vacuum environment reveals that the voids are not uniformly distributed at the Cu/Cu oxide interface.