Study of Adhesion-Cohesive Interactions of Modified Bitumen Compositions.

The aim of the work was to study the effect of additive concentration on changes in the adhesive and cohesive strength of bitumen. To evaluate the effectiveness of modifiers in the composition of binary and triple bitumen systems in relation to mineral fillers of two grades, the method of determination of the adhesive efficiency and thermodynamic calculations of adhesion and cohesion work were used. The following compounds were used as additives: synthesized from the oil refining waste and (waste sealing liquid).

The Effect of the Microstructure and Viscosity of Modified Bitumen on the Strength of Asphalt Concrete.

The purpose of these studies was to establish the influence of the microstructural and rheological characteristics of modified bitumen compositions on the strength indicators of asphalt concrete. The effect of additives concentration on the rheological characteristics and microstructure of binary "bitumen-surfactant", "bitumen-AG-4I", and ternary "bitumen-AG-4I-AG-4I" systems has been studied. To assess the effect of bitumen dispersion on the physical and mechanical characteristics of modified asphalt concrete samples, the compressive strength value was determined.

Increasing the Adhesion of Bitumen to the Surface of Mineral Fillers through Modification with a Recycled Polymer and Surfactant Obtained from Oil Refining Waste.

The purpose of this study was to optimize the processes of wetting fillers by varying the content of such additives as a surfactant and polymer in bitumen-mineral compositions in order to achieve optimal performance. The cosine of the contact angle was used as a criterion for assessing the adhesion of the bitumen binder to the surface of crushed stone. The effect of the additives' concentration on surface tension and adhesive efficiency in binary and ternary bitumen compositions was studied.

Development of an Ultrasonic Method for the Quality Control of Polyethylene Tanks Manufactured Using Rotational Molding Technology.

Tanks made of three different brands of rotational polyethylene (DOW, ELTEX, and M350) with three degrees of sintering (normal sintering (NS), incomplete sintering (ICS), and thermally degraded sintering (TDS)) and three thicknesses (7.5 mm, 8.5 mm, and 9.

Optimizing the Composition of Silicone Enamel to Ensure Maximum Aggregative Stability of Its Suspensions Using Surfactant Obtained from Oil Refining Waste.

The aim of this study was to optimize the composition of enamel consisting of aluminum pigment and polyphenylsiloxane polymer, in order to achieve the maximum aggregative stability of suspensions. Sedimentation rate (SR) was used as a criterion for assessing the aggregative stability of the suspensions. An original product, AS-1, and industrial additives PEPA and Telaz, were tested as surfactants.

Exploration of the Adsorption Reduction of the Pigment Aggregates Strength under the Effect of Surfactants in Water-Dispersion Paints.

This article presents the results of studying the disaggregation of titanium dioxide in water-dispersion compositions based on an acrylic film-forming agent under the action of a surfactant. The possibility of using polyether siloxane copolymer (PC) and sodium polyacrylate (NaPA) in paint and varnish compositions as modifying additives of the dispersing effect is proved. The correlation between the dispersing effect of surfactants and the amount of their adsorption on the pigment is proved.

Optimization of the Composition of Silicone Enamel by the Taguchi Method Using Surfactants Obtained from Oil Refining Waste.

The aim of this work is to optimize the composition of a two-component silicone enamel consisting of an aluminum pigment and a polyphenylsiloxane polymer to obtain the maximum dispersion of the pigment in the coating. The following products were used as surfactants: AS-1, PEPA, and Telaz. To assess the effect of surfactants on the dispersion of the pigment, computer-optical microscopy was used.