Massive intrusion of maxillary second molar for prosthodontic purposes through miniscrew-supported biomechanics and fixed partial appliances: A case report.

This clinical case demonstrates how the use of a hybrid approach consisting of aligners, orthodontic miniscrews and partial fixed appliances can be an effective and efficient solution for recovering adequate vertical space for satisfactory implant-prosthetic rehabilitation. Specifically, massive intrusion of an upper second molar (tooth 1.7) was achieved orthodontically with direct TADs support to allow otherwise unpredictable movements and achieve maximum anchorage control for subsequent implant rehabilitation of the fourth quadrant.

Class II subdivision with skeletal transverse maxillary deficit treated by single-sitting bone-borne appliance.

This case report describes orthodontic treatment including both skeletal maxillary expansion and unilateral distalization by means of a single bone-borne appliance followed by clear aligner therapy in a young adult patient. A surgical guide was digitally designed and three-dimensionally printed to facilitate the placement of four miniscrews in the palatal vault. The miniscrews were fitted and the bone-borne appliance was delivered in a single clinical appointment.

Clear aligner hybrid approach: A case report.

Introduction: This case demonstrates that hybrid application of clear aligners can be a rational and efficient approach for treating malocclusions, as compared with a clear aligner therapy alone option in which the magnitude of some movements would require a higher number of aligners and likely further refinement.

Treatment Plan And Progress: After a first successful orthopedic phase face mask + rapid maxillary expansion (FM + RME), a diagnostic digital setup of the second orthodontic treatment phase was performed, opting for an esthetic approach to make the treatment as fast and efficient as possible. After positioning lingual tubes on both arches, digital models were obtained and lingual archwires, passing through the previously positioned tubes, were simulated digitally.

Class II subdivision correction with clear aligners using intermaxilary elastics.

Background: To describe an esthetic orthodontic treatment using aligners in an adult patient with class II subdivision associated with crowding and dental crossbite. An 18-year-old hyperdivergent male patient with skeletal class II from mandibular retrusion presented for an orthodontic treatment. Occlusally, the patient presents class II subdivision, crossbite at tooth 4.

Class III malocclusion and bilateral cross-bite in an adult patient treated with miniscrew-assisted rapid palatal expander and aligners.

This case report describes the use of a miniscrew-assisted rapid palatal expander and aligners to correct bilateral cross-bite and crowding in an adult patient with a Class III skeletal pattern. A digitally designed surgical guide was three-dimensionally printed and used to accurately insert four miniscrews into the palate; these were employed to anchor a novel miniscrew-assisted rapid palatal expander appliance without any dental anchorage. Cone-beam computed tomograms before and after miniscrew-assisted rapid palatal expander treatment demonstrated the orthopedic expansion of the maxilla without dental tipping.

Stiffness comparison of mushroom and straight SS and TMA lingual archwires.

Background: The aim of this study is to investigate the relative stiffness of straight and mushroom lingual archwires of different diameters, cross sections and alloys, plotting their load/deflection graphs and using a modified three-point bending test.

Methods: Fujita's mushroom archwires and straight lingual archwires of different diameters, cross sections and alloys were derived by a virtual set-up of an equal malocclusion and were cut at their straight distal portion. These distal portions were tested using a modified three-point bending test by an Instron 4467 dynamometer and the forces, were exerted at 1-mm deflection and were compared on each resulting load/deflection curve by means of ANOVA (p < 0.