Ferroelectric nanodomains were formed in bulk lithium niobate single crystals near nanostructured microtracks laser-inscribed by 1030-nm 0.3-ps ultrashort laser pulses at variable pulse energies in sub- and weakly filamentary laser nanopatterning regimes. The microtracks and related nanodomains were characterized by optical, scanning probe and confocal second-harmonic generation microscopy methods.
View Article and Find Full Text PDFThe possibility to control the charge, type, and density of domain walls allows properties of ferroelectric materials to be selectively enhanced or reduced. In ferroelectric-ferroelastic materials, two types of domain walls are possible: pure ferroelectric and ferroelastic-ferroelectric. In this paper, we demonstrated a strategy to control the selective ferroelectric or ferroelastic domain wall formation in the (111) single-domain rhombohedral PMN-PT single crystals at the nanoscale by varying the relative humidity level in a scanning probe microscopy chamber.
View Article and Find Full Text PDFThe structural state and crystal structure of LuScFeO (0 ≤ ≤ 1) compounds prepared by a chemical route based on a modified sol-gel method were investigated using X-ray diffraction, Raman spectroscopy, as well as scanning electron microscopy. It was observed that chemical doping with Sc ions led to a structural phase transition from the orthorhombic structure to the hexagonal structure via a wide two-phase concentration region of 0.1 < < 0.
View Article and Find Full Text PDFMonitoring the charged defect concentration at the nanoscale is of critical importance for both the fundamental science and applications of ferroelectrics. However, up-to-date, high-resolution study methods for the investigation of structural defects, such as transmission electron microscopy, X-ray tomography, etc., are expensive and demand complicated sample preparation.
View Article and Find Full Text PDFIEEE Trans Ultrason Ferroelectr Freq Control
August 2021
Formation of the domain structure by ion beam irradiation was studied in thermally depolarized Ce-doped strontium barium niobate single crystals covered by a dielectric layer. Three types of irradiation regimes were used: dot exposure, stripe exposure, and line exposure. The dependences of the domain size and depth on the irradiated dose were measured.
View Article and Find Full Text PDFThe understanding of self-organization processes at the micro- and nanoscale is of fundamental interest and is important to meet the great challenges in further miniaturization of electronic devices to the nanoscale. Here, we report self-organized quasi-regular nanodomain structure formation on the nonpolar cut of a ferroelectric lithium niobate single crystal. These structures were formed along the trajectory of grounded scanning probe microscope tip approaching or moving away from the freshly switched region.
View Article and Find Full Text PDFWe have studied experimentally the interaction of isolated needle-like domains created in an array via local switching using a biased scanning probe microscope (SPM) tip and visualized via piezoelectric force microscopy (PFM) at the non-polar cuts of MgO-doped lithium niobate (MgOLN) crystals. It has been found that the domain interaction leads to the intermittent quasiperiodic and chaotic behavior of the domain length in the array in a manner similar to that of polar cuts, but with greater spacing between the points of bias application and voltage amplitudes. It has also been found that the polarization reversal at the non-polar cuts and domain interaction significantly depend on humidity.
View Article and Find Full Text PDFRecent advances in the development of novel methods for the local characterization of ferroelectric domains open up new opportunities not only to image, but also to control and to create desired domain configurations (domain engineering). The morphotropic and polymorphic phase boundaries that are frequently used to increase the electromechanical and dielectric performance of ferroelectric ceramics have a tremendous effect on the domain structure, which can serve as a signature of complex polarization states and link local and macroscopic piezoelectric and dielectric responses. This is especially important for the study of lead-free ferroelectric ceramics, which is currently replacing traditional lead-containing materials, and great efforts are devoted to increasing their performance to match that of lead zirconate titanate (PZT).
View Article and Find Full Text PDFElectromechanical properties such as d33 and strain are significantly enhanced at morphotropic phase boundaries (MPBs) between two or more different crystal structures. Many actuators, sensors and MEMS devices are therefore systems with MPBs, usually between polar phases in lead (Pb)-based ferroelectric ceramics. In the search for Pb-free alternatives, systems with MPBs between polar and non-polar phases have recently been theorized as having great promise.
View Article and Find Full Text PDF