Adaptation of a Differential Scanning Calorimeter for Simultaneous Electromagnetic Measurements.

Although much information can be gained about thermally induced microstructural changes in metals through the measurement of their thermophysical properties using a differential scanning calorimeter (DSC), due to competing influences on the signal, not all microstructural changes can be fully characterised this way. For example, accurate characterisation of recrystallisation, tempering, and changes in retained delta ferrite in alloyed steels becomes complex due to additional signal changes due to the Curie point, oxidation, and the rate (and therefore the magnitude) of transformation. However, these types of microstructural changes have been shown to invoke strong magnetic and electromagnetic (EM) responses; therefore, simultaneous EM measurements can provide additional complementary data which can help to emphasise or deconvolute these complex signals and develop a more complete understanding of certain metallurgical phenomena.

Balancing of Resonant Differential Coils for Broadband Inductive Sensor Systems.

Differential coils are frequently implemented in inductive sensing systems. They can be considered as a single coil that is made up of two or more subcoils, wound in series opposition. They can be used on the transmit or receive side of measurement systems, and, if designed correctly, ensure no coupling between coils under background conditions.

Classification of Shredded Aluminium Scrap Metal Using Magnetic Induction Spectroscopy.

Recycling aluminium is essential for a circular economy, reducing the energy required and greenhouse gas emissions compared to extraction from virgin ore. A 'Twitch' waste stream is a mix of shredded wrought and cast aluminium. Wrought must be separated before recycling to prevent contamination from the impurities present in the cast.

A method for evaluating sensitivity of electromagnetic localization systems for wireless capsule endoscopes.

This paper studies the use of electromagnetic induction in localization of wireless capsule endoscopes (WECs). There is still currently a need for an accurate localization system to enable localizing possible findings in the gastrointestinal tract, and to develop an active steering system for the capsule. Developing an optimal localization system requires the sensitivity of the system to be analyzed.

Combining Electromagnetic Spectroscopy and Ground-Penetrating Radar for the Detection of Anti-Personnel Landmines.

Dual mode detectors combining metal detection and ground-penetrating radar are increasingly being used during humanitarian demining operations because of their ability to discriminate metal clutter. There are many reports in the academic literature studying metal detector and ground-penetrating radar systems individually. However, the combination of these techniques has received much less attention.

Investigating the Performance of Bi-Static GPR Antennas for Near-Surface Object Detection.

Antennas are an important component in ground penetrating radar (GPR) systems. Although there has been much research reported on the design of individual antennas, there is less research reported on the design of the geometry of bi-static antennas. This paper considers the effects of key parameters in the setup of a GPR head consisting of a bi-static bow-tie pair to show the effect of these parameters on the GPR performance.

A method to solve the forward problem in magnetic induction tomography based on the weakly coupled field approximation.

Magnetic induction tomography (MIT) is a noninvasive modality for imaging the complex conductivity (kappa = sigma + jomegaepsilon) or the magnetic permeability (mu) of a target under investigation. Because MIT employs noncontact coils for excitation and detection, MIT may be suitable for imaging biological tissues. In medical applications where high resolutions are sought, image reconstruction is a time and memory consuming task because the associated inverse problem is nonlinear and ill-posed.