Dual-fluorescent starch biopolymer films containing 5-(4-nitrophenyl)-1,3,4-thiadiazol-2-amine powder as a functional nanofiller.

Physical and photophysical properties of starch-based biopolymer films containing 5-(4-nitrophenyl)-1,3,4-thiadiazol-2-amine (NTA) powder as a nanofiller were examined using atomic force microscopy (AFM), Fourier-transform infrared spectroscopy (FTIR), stationary UV-Vis and fluorescence spectroscopy as well as resonance light scattering (RLS) and time-resolved measurements, and where possible, analyzed with reference to pristine NTA solutions. AFM studies revealed that the addition of NTA into the starch biopolymer did not significantly affect surface roughness, with all examined films displaying similar Sq values ranging from 70.7 nm to 79.

Polysaccharide Composite Films Utilising Wood Waste.

This study aimed to investigate the effect of raw waste pine wood dust () from furniture production on polysaccharide biopolymer film properties. The obtained biocomposite films produced via the casting method were prepared with 20% glycerol and 0%, 5%, 10%, 15%, 20%, and 25% of added wood dust in relation to the dry starch matter. Wood dust composition and particle size distribution analysis were performed.

Physical Properties of Starch/Powdered Activated Carbon Composite Films.

In the present study, starch/powdered activated carbon composite films were prepared by incorporating various amounts of powdered activated carbon (PAC)-1-5, 10, and 15 %-into a starch matrix, using the solvent casting method. The effect of PAC addition on the biopolymer film was investigated. The mechanical properties were examined by ultra-nanoindentation, nanoscratch, and micro-tensile tests.

The Quantitative Nanomechanical Mapping of Starch/Kaolin Film Surfaces by Peak Force AFM.

Starch films modified with additives are materials increasingly being used in the production of packaging. These types of biopolymers can, to a considerable degree, replace plastic, contributing to the reduction in both production and waste management costs. However, they should be characterised by specific mechanical and surface parameters which determine their application.

The Structure and Mechanical Properties of the Surface Layer of Polypropylene Polymers with Talc Additions.

In the presented work the influence of different 3MgO·4SiO·HO (talc) contents in polypropylene samples on the structure, hardness, elasticity, and friction of the surface layer was investigated. The talc content ranged from 0 to 25 wt.%, and all the samples were obtained in the same conditions by the injection molding process.

The Influence of Kaolin Clay on the Mechanical Properties and Structure of Thermoplastic Starch Films.

The aim of study was to investigate the influence of kaolin on the physical properties and utility of film produced from native starch. The work involved measurements of strength, structure, and thermal properties. The films were prepared by the casting method.

The relationship between physiological and mechanical properties of Acer platanoides L. and Tilia cordata Mill. leaves and their seasonal senescence.

The seasonal senescence of leaves in the phenological cycle coincides with the change of their strength properties which determine resistance to environmental conditions and the efficiency of the photosynthesis process. That affects the development, growth and condition of the plant. Therefore, the aim of this paper was to observe and compare the results of strength tests performed on the leaves of two species of trees popular in Poland - lime and maple.

Prenatally administered HMB modifies the enamel surface roughness in spiny mice offspring: An atomic force microscopy study.

Objective: The aim of this research was to check the effect of the prenatally administered β-hydroxy β-methylbutyrate (HMB) on the development of enamel surface of the spiny mice offspring.

Design: The spiny mice dams were randomly assigned into three groups: control group (not supplemented with HMB) and two experimental groups in which powdered HMB was given at the daily dosage of 0.2g/kg of body weight (group I) and 0.