Evaluation of the efficacy of inter-dental brush and dental floss for peri-implant mucositis: A crossover randomized clinical trial.

Objectives: To evaluate the most effective method for mechanical inter-dental plaque removal between inter-dental brushes (IDB) and dental floss (DF), in addition to toothbrushing in patients affected by peri-implant mucositis (PIM); to identify possible factors related to the patient or to the single implant-supported element that could influence plaque accumulation and inflammation of peri-implant tissues.

Methods: Forty patients with PIM were recruited. They were randomly assigned to two different groups depending on inter-dental device used (IDB or DF).

Shaping ability of Procodile and R6 Reziflow nickel-titanium reciprocating instruments in curved mesial root canals of mandibular molars: A MicroCT study.

To compare the shaping ability of Procodile and R6 Reziflow instruments used in reciprocating motion in severely curved root canals, assessed with micro-computed tomography (μCT). Fourteen extracted human mandibular first molars were randomly assigned to two instrumentation techniques (n = 14 mesial root canals): Procodile or R6 Reziflow. For both groups, root canals were prepared to the working length up to a size 25, .

Root-end resection with or without retrograde obturation after orthograde filling with two techniques: A micro-CT study.

To evaluate the filling ability of two orthograde obturation techniques followed by the apical resection with or without retrograde obturation through micro-computed tomography (CT). Thirty-two single-rooted permanent teeth were prepared and randomised into four groups (n = 8) according to the orthograde obturation technique (single cone technique [SCT] and mineral trioxide aggregate placement) combined or not with retrograde obturation. The volume of voids (VoV) within the entire endodontic space, the apical 3 mm, and 1 mm after root resection was calculated by micro-CT.

Retreatability of calcium silicate-based root canal sealer using reciprocating instrumentation with different irrigation activation techniques in single-rooted canals.

This study analysed the bioceramic sealer cleaning ability of two chemo-mechanical systems in intact and restored teeth. Thirty-two single-rooted teeth were used, and half of them restored with a pre-endodontic composite restoration (PCR). All samples were instrumented with a size 40 Reciproc Blue file and filled with BioRoot RCS.

Comparative Evaluation of the Penetration Depth into Dentinal Tubules of Three Endodontic Irrigants.

This study aimed to examine the penetration depth into dentinal tubules of some chelating agents. The 17% EDTA and two preparations containing surfactants (Smear Clear, Bioakt Endo) were tested. Surface tension and liquid viscosity were measured using a Dynamic Contact Angle Analyzer and a Haake rotational rheometer.

Influence of Thickness and Shade on the Color of Layered Novel Nanohybrid Composite Systems.

The influence of the layer thickness and composite shade on the final color of Ceram.X composites (Dentsply Sirona) was tested, selecting five intermediate-translucency Ceram.X Universal shades, three high-translucency Ceram.

The knowledge about periodontal health of northeastern Italian pharmacists: a cross-sectional survey.

Background: The aim of this study was to determine the knowledge of periodontal health and prevention of periodontal diseases of a pool of pharmacists working in Friuli Venezia Giulia.

Methods: A 22-questions questionnaire about oral health was sent by mail to all the pharmacies working in Friuli Venezia Giulia and to the most known associations of pharmacists. The data were collected and analyzed by Google Forms software.

Evaluation of degree of conversion, rate of cure, microhardness, depth of cure, and contraction stress of new nanohybrid composites containing pre-polymerized spherical filler.

The aim of the present study was to characterize nanohybrid and nanofilled composites in terms of degree of conversion (DC), rate of cure (RC), microhardness (Vickers hardness number; VHN), depth of cure, and contraction stress (CS). Ceram.X® universal- A3, duo enamel E2, and duo dentin D3 composites were compared to Tetric EvoCeram® and FiltekTMSupreme XTE composites of equivalent dentin and enamel shades under a 40 s photopolymerization protocol.

Filling ability of three variants of the single-cone technique with bioceramic sealer: a micro-computed tomography study.

The present study evaluated the quality of single-cone root canal fillings with bioceramic (BC) sealer using three different techniques by means of micro-computed tomography (micro-CT). The canals of 30 extracted single-rooted permanent teeth were shaped with R40 Reciproc blue files and filled with the single-cone technique (SCT). BioRoot RCS BC sealer was placed inside the canals with one of the following master cones: R40 cone to working length (RWL, n = 10); R40 cone trimmed 1 mm short of working length (RWL-1, n = 10); non-standardized gutta-percha cone to working length (NSWL, n = 10).

Influence of different motions on the cyclic fatigue resistance of Reciproc and Reciproc Blue endodontic instruments.

Aim: The aim of this study was to evaluate the cyclic fatigue resistance of Reciproc (RCP) and RPC Blue (RCPB) instruments used in continuous rotation, "RECIPROC" mode, and "WAVEONE" mode.

Materials And Methods: Sixty RCP and 60 RCPB R25 files were used. For each file type, three groups ( = 20) were defined depending on the used kinematics: continuous rotation, "RECIPROC" mode, and "WAVEONE" mode.

Outcome of Different Surgical Approaches in the Treatment of Class II Furcation Defects in Mandibular Molars: A Randomized Clinical Trial.

The aim of this study was to investigate which factors play a major role in the healing of Class II mandibular furcation defects treated with different surgical techniques. Twenty-five systemically healthy subjects with periodontitis stage III grade B and Class II buccal mandibular furcation involvement received one of the following open flap debridement approaches: Group 1 (n = 10), no further treatment; Group 2 (n = 10), piezoelectric contouring of the furcation roof; Group 3 (n = 9), piezoelectric contouring of the furcation roof and bone grafting; Group 4 (n = 10), piezoelectric contouring of the furcation roof and bone grafting with coronally positioned flap. Clinical and radiologic variables-bleeding on probing, probing depth (PPD), vertical and horizontal bone level (CAL and PH), gingival recession, root trunk length, radicular separation, and furcation perimeter (FP)-were evaluated at baseline and 180 days and 1 year after surgery.

Surgical extrusion: A dental technique.

This article describes a technique for surgically extruding severely compromised roots needing prosthetic rehabilitation. Unlike previously described approaches, the technique does not require advanced clinical skills or equipment, may reduce the risk of tooth or bone fracture during the luxation maneuvers, and does not seem to interfere with the alveolar socket healing process.

Multidisciplinary Management and Pulp Vitality Preservation of a Tooth With Extensive Iatrogenic Furcal Root Perforation and Biologic Width Violation.

This article describes the case of a vital molar tooth with a vast furcal iatrogenic root perforation and biologic width violation, which was successfully managed by a multidisciplinary approach aimed at preserving pulp vitality. The root perforation was cleaned and then sealed with mineral trioxide aggregate, which was positioned onto the pulp at the canal orifices. After one month, the patient was not reporting symptoms, and the tooth was positively responding to the thermal test.

Primary Stability of Short Implants Inserted Using Piezoelectric or Drilling Systems: An In Vitro Comparison.

The primary objective of the present in vitro study was to evaluate the influence of implant site preparation technique (drills vs ultrasonic instrumentation) on the primary stability of short dental implants with two different designs inserted in simulated low-quality cancellous bone. Eighty implant sites were prepared in custom-made solid rigid polyurethane blocks with two different low cancellous bone densities (5 or 15 pounds per cubic foot [PCF]), equally distributed between piezoelectric (Surgysonic Moto, Esacrom, Italy) and conventional drilling techniques. Two short implant systems (Prama and Syra, Sweden & Martina) were tested by inserting 40 fixtures of each system (both 6.

Sarcopenia in Ovarian Cancer Patients, Oncologic Outcomes Revealing the Importance of Clinical Nutrition: Review of Literature.

Introduction: Ovarian cancer is the leading cause of death among gynecological malignancies. Its usual clinical manifestation is at advanced stages, with nutritional impairment, weight loss, and a consequent decline in skeletal muscle mass and strength (defined as sarcopenia). The relationship between sarcopenia and decreased survival was demonstrated not only in ovarian cancer but also in other cancer types, such as hepatocellular, pancreatic, lung, colon, cervical, metastatic breast, and renal cancer.

Constructional apraxia screening and oral health among hospitalized older adults: A cross-sectional study.

Aims: Apraxia may hinder oral self-care and is associated with poor oral hygiene. Intersecting Pentagons Test (IPT) is a simple screening tool for constructional apraxia (CA) that tests the ability to copy a bidimensional figure. In this study we investigated whether IPT is useful to identify subjects that need interventions to support oral health in a cohort of geriatric inpatients.

Primary stability of short implants inserted using piezoelectric or drilling systems: an in vitro comparison.

The primary objective of the present in vitro study was to evaluate the influence of implant site preparation technique (drills vs. ultrasonic instrumentation) on the primary stability of short dental implants with two different designs inserted in simulated low quality cancellous bone. Eighty implant sites were prepared in custom-made solid rigid polyurethane blocks with two different low cancellous bone densities (5 or 15 pounds per cubic foot, PCF), equally distributed between piezoelectric (Surgysonic Moto, Esacrom, Italy) and conventional drilling techniques.

Influence of preparation designs on marginal adaptation and failure load of full-coverage occlusal veneers after thermomechanical aging simulation.

Objectives: To evaluate the fracture resistance and marginal quality of maxillary molars restored using lithium disilicate glass-ceramic (LDG) occlusal veneers with two preparation designs.

Methods: Sixteen extracted maxillary molars were assigned to two groups (n = 8). In group 1 (G1), the teeth received a preparation for a conservative full-coverage occlusal veneer restoration with a 90° rounded shoulder margin.

In vitro comparison of cyclic fatigue resistance of two rotary single-file endodontic systems: OneCurve versus OneShape.

The aim of the present study was to evaluate the difference in cyclic fatigue resistance between OneCurve (OC) and OneShape (OS) endodontic single-file NiTi systems in a severely curved artificial canal. After sample size calculation (α = 0.01; β = 0.

Computed microtomography study of untreated, shaped and filled mesiobuccal canals of maxillary first molars.

This study assessed the effectiveness of modern endodontic shaping and filling procedures on mesiobuccal roots of maxillary molars with two canals. The canals of 20 mesiobuccal roots were treated with Mtwo rotary files, passive ultrasonic irrigation and Guttafusion obturators. X-ray computed microtomography analysis was carried out prior to treatment, after canal shaping and after canal filling to determine the alterations of the canal volume before and after the instrumentation, the volume of the hard tissue debris, and percentage of the volume occupied by filling materials.

Bone regeneration with adipose derived stem cells in a rabbit model.

It has been shown that stem cells are able to calcify both in vitro and in vivo once implanted under the skin, if conveniently differentiated. Nowadays, however, a study on their efficiency in osseous regeneration does not exist in scientific literature and this very task is the real aim of the present experimentation. Five different defects of 6 mm in diameter and 2 mm in depth were created in the calvaria of 8 white New Zealand rabbits.

Do Nanofilled/Nanohybrid Composites Allow for Better Clinical Performance of Direct Restorations Than Traditional Microhybrid Composites? A Systematic Review.

This systematic review was carried out to assess the clinical effectiveness of nanofilled and nanohybrid composites used for direct restorations in comparison with microhybrid composites. The guidelines for the preferred reporting items for systematic reviews and meta-analyses were followed. A search of articles published from July 1996 to February 2017 was performed in PubMed, SciVerse Scopus, Latin American and Caribbean Health Sciences, the Scientific Electronic Library Online, and the Cochrane Library.

Volumetric Analysis of Gingival Crevicular Fluid and Peri-Implant Sulcus Fluid in Healthy and Diseased Sites: A Cross-Sectional Split-Mouth Pilot Study.

Background: Researchers have recently drawn attention to the analysis of gingival crevicular fluid (GCF) and peri-implant sulcus fluid (PISF) for the implementation of the diagnosis of periodontal and peri-implant disease. Nevertheless, the measurements of volume and biomarkers concentration can be critically biased when data collected from studies with parallel group design are compared, given the technical difficulties, methodological variables, as well as the variability of crevicular fluid characteristics among different individuals.

Objective: The aim of the present study was to assess the GCF and PISF volumes in healthy and diseased sites belonging to the same patient.

Influence of finish line on the marginal seal of nanohybrid composite crowns after periodontal scaling: a microleakage study.

Aim: The aim of the present microleakage study was to assess the sealing ability of nanohybrid composite crowns with different finish lines exposed to simulated mechanical periodontal treatment (SMPT).

Methods: After sample size calculation (α=0.05; β=0.