Mix and measure II: joint high-energy laboratory powder diffraction and microtomography for cement hydration studies.

Portland cements (PCs) and cement blends are multiphase materials of different fineness, and quantitatively analysing their hydration pathways is very challenging. The dissolution (hydration) of the initial crystalline and amorphous phases must be determined, as well as the formation of labile (such as ettringite), reactive (such as portlandite) and amorphous (such as calcium silicate hydrate gel) components. The microstructural changes with hydration time must also be mapped out.

Recent Advances in C-S-H Nucleation Seeding for Improving Cement Performances.

Reducing cement CO footprint is a societal need. This is being achieved mainly by replacing an increasing amount of Portland clinker by supplementary cementitious materials. However, this comes at a price: lower mechanical strengths at early ages due to slow pozzolanic reaction(s).

Portland and Belite Cement Hydration Acceleration by C-S-H Seeds with Variable / Ratios.

The acceleration of very early age cement hydration by C-S-H seeding is getting attention from scholars and field applications because the enhanced early age features do not compromise later age performances. This acceleration could be beneficial for several low-CO cements as a general drawback is usually the low very early age mechanical strengths. However, the mechanistic understanding of this acceleration in commercial cements is not complete.

Effect of Boron and Water-to-Cement Ratio on the Performances of Laboratory Prepared Belite-Ye'elimite-Ferrite (BYF) Cements.

The effect of superplasticiser, borax and the water-to-cement ratio on BYF hydration and mechanical strengths has been studied. Two laboratory-scale BYF cements-st-BYF (with β-CS and orthorhombic CAS¯) and borax-activated B-BYF (with α'-CS and pseudo-cubic CAS¯)-have been used, and both show similar particle size distribution. The addition of superplasticiser and externally added borax to BYF pastes has been optimised through rheological measurements.

High-pressure and -temperature spinning capillary cell for in situ synchrotron X-ray powder diffraction.

In situ research of materials under moderate pressures (hundreds of bar) is essential in many scientific fields. These range from gas sorption to chemical and biological processes. One industrially important discipline is the hydration of oil well cements.

Rietveld Quantitative Phase Analysis of Oil Well Cement: In Situ Hydration Study at 150 Bars and 150 °C.

Oil and gas well cements are multimineral materials that hydrate under high pressure and temperature. Their overall reactivity at early ages is studied by a number of techniques including through the use of the consistometer. However, for a proper understanding of the performance of these cements in the field, the reactivity of every component, in real-world conditions, must be analysed.

Quantitative disentanglement of nanocrystalline phases in cement pastes by synchrotron ptychographic X-ray tomography.

Mortars and concretes are ubiquitous materials with very complex hierarchical microstructures. To fully understand their main properties and to decrease their CO footprint, a sound description of their spatially resolved mineralogy is necessary. Developing this knowledge is very challenging as about half of the volume of hydrated cement is a nanocrystalline component, calcium silicate hydrate (C-S-H) gel.

A Comparative Study of Experimental Configurations in Synchrotron Pair Distribution Function.

The identification and quantification of amorphous components and nanocrystalline phases with very small crystal sizes, smaller than ~3 nm, within samples containing crystalline phases is very challenging. However, this is important as there are several types of systems that contain these matrices: building materials, glass-ceramics, some alloys, etc. The total scattering synchrotron pair distribution function (PDF) can be used to characterize the local atomic order of the nanocrystalline components and to carry out quantitative analyses in complex mixtures.

Multiscale understanding of tricalcium silicate hydration reactions.

Tricalcium silicate, the main constituent of Portland cement, hydrates to produce crystalline calcium hydroxide and calcium-silicate-hydrates (C-S-H) nanocrystalline gel. This hydration reaction is poorly understood at the nanoscale. The understanding of atomic arrangement in nanocrystalline phases is intrinsically complicated and this challenge is exacerbated by the presence of additional crystalline phase(s).

Mechanism of stabilization of dicalcium silicate solid solution with aluminium.

Stoichiometric dicalcium silicate, Ca2SiO4, displays a well-known polymorphism with temperature. When this phase is doped by a range of elements, belite, one of the main phases of cements, is generated. Here, we thoroughly study the aluminum doping of dicalcium silicate.

In situ powder diffraction study of belite sulfoaluminate clinkering.

Belite sulfoaluminate (BSA) cements have been proposed as environmentally friendly building materials, as their production may release up to 35% less CO(2) into the atmosphere when compared with ordinary Portland cement fabrication. However, their formation mechanism has not been studied in detail so far. Here, an in situ high-temperature high-resolution synchrotron X-ray powder diffraction study is reported.

Active iron-rich belite sulfoaluminate cements: clinkering and hydration.

Ordinary Portland cement (OPC) is an environmentally contentious material, as for every ton of OPC produced, on average, 0.97 tons of CO2 are released. Conversely, belite sulfoaluminate (BSA) cements are promising eco-friendly building materials, as their production may deplete CO2 emissions up to 35% (compared to OPC).

Crystal structures and in-situ formation study of mayenite electrides.

Mayenite inorganic electrides are antizeolite nanoporous materials with variable electron concentration [Ca12Al14O32]2+ square5-deltaO1-delta2-e2delta- (0 < delta < or = 1), where square stands for empty sites. The oxymayenite crystal structure contains positively charged cages where loosely bounded oxide anions are located. These oxygens can be removed to yield electron-loaded materials in which the electrons behave like anions (electrides).

A new family of oxide ion conductors based on tricalcium oxy-silicate.

Tricalcium oxy-silicates, Ca3(SiO4)O and Ca2.93Mg0.07(Si0.