Isolating the Photovoltaic Junction: Atomic Layer Deposited TiO2-RuO2 Alloy Schottky Contacts for Silicon Photoanodes.

We synthesized nanoscale TiO2-RuO2 alloys by atomic layer deposition (ALD) that possess a high work function and are highly conductive. As such, they function as good Schottky contacts to extract photogenerated holes from n-type silicon while simultaneously interfacing with water oxidation catalysts. The ratio of TiO2 to RuO2 can be precisely controlled by the number of ALD cycles for each precursor.

Atomic Layer Deposited Corrosion Protection: A Path to Stable and Efficient Photoelectrochemical Cells.

A fundamental challenge in developing photoelectrochemical cells for the renewable production of solar chemicals and fuels is the simultaneous requirement of efficient light absorption and robust stability under corrosive conditions. Schemes for corrosion protection of semiconductor photoelectrodes such as silicon using deposited layers were proposed and attempted for several decades, but increased operational lifetimes were either insufficient or the resulting penalties for device efficiency were prohibitive. In recent years, advances in atomic layer deposition (ALD) of thin coatings have made novel materials engineering possible, leading to substantial and simultaneous improvements in stability and efficiency of photoelectrochemical cells.

Titanium Oxide Crystallization and Interface Defect Passivation for High Performance Insulator-Protected Schottky Junction MIS Photoanodes.

Atomic layer deposited (ALD) TiO2 protection layers may allow for the development of both highly efficient and stable photoanodes for solar fuel synthesis; however, the very different conductivities and photovoltages reported for TiO2-protected silicon anodes prepared using similar ALD conditions indicate that mechanisms that set these key properties are, as yet, poorly understood. In this report, we study hydrogen-containing annealing treatments and find that postcatalyst-deposition anneals at intermediate temperatures reproducibly yield decreased oxide/silicon interface trap densities and high photovoltage. A previously reported insulator thickness-dependent photovoltage loss in metal-insulator-semiconductor Schottky junction photoanodes is suppressed.

Engineering Interfacial Silicon Dioxide for Improved Metal-Insulator-Semiconductor Silicon Photoanode Water Splitting Performance.

Silicon photoanodes protected by atomic layer deposited (ALD) TiO2 show promise as components of water splitting devices that may enable the large-scale production of solar fuels and chemicals. Minimizing the resistance of the oxide corrosion protection layer is essential for fabricating efficient devices with good fill factor. Recent literature reports have shown that the interfacial SiO2 layer, interposed between the protective ALD-TiO2 and the Si anode, acts as a tunnel oxide that limits hole conduction from the photoabsorbing substrate to the surface oxygen evolution catalyst.

Design principles for maximizing photovoltage in metal-oxide-protected water-splitting photoanodes.

Metal oxide protection layers for photoanodes may enable the development of large-scale solar fuel and solar chemical synthesis, but the poor photovoltages often reported so far will severely limit their performance. Here we report a novel observation of photovoltage loss associated with a charge extraction barrier imposed by the protection layer, and, by eliminating it, achieve photovoltages as high as 630 mV, the maximum reported so far for water-splitting silicon photoanodes. The loss mechanism is systematically probed in metal-insulator-semiconductor Schottky junction cells compared to buried junction p(+)n cells, revealing the need to maintain a characteristic hole density at the semiconductor/insulator interface.