Thermal-induced residual stresses affect the lifetime of zirconia-veneer crowns.

Objectives: The purposes of this study were to investigate the effects of thermal residual stresses on the reliability and lifetime of zirconia-veneer crowns.

Methods: One hundred and twenty eight second upper premolar zirconia-veneer crowns were manufactured for testing the initial strength (n=64) and under cyclic fatigue (n=64). Zirconia copings (YZ Cubes, VITA Zahnfabrik, CTE: alphac=10.

Marginal quality of flowable 4-mm base vs. conventionally layered resin composite.

Objective: This study evaluated marginal integrity of bonded posterior resin composite fillings to enamel and dentine with and without 4mm flowable base, before and after thermo-mechanical loading (TML).

Methods: 80 MOD cavities with one proximal box beneath the CEJ were prepared in extracted human third molars. Direct resin composite restorations (SDR with CeramX mono, Tetric EvoCeram, Filtek Supreme XT, and Venus Diamond or the respective resin composites alone) were bonded with system immanent adhesives XP Bond, Xeno V, Syntac, Adper Prompt L-Pop, and iBond self-etch.

Chairside vs. labside ceramic inlays: effect of temporary restoration and adhesive luting on enamel cracks and marginal integrity.

Objectives: To assess the influence of different temporary restorations and luting techniques of labside and chairside ceramic inlays on enamel defects and marginal integrity.

Methods: 120 extracted human third molars received MOD preparations with one proximal box each limited in either enamel or dentin. 64 Cerec 2 inlays and 56 IPS Empress I inlays were randomly assigned to the following groups (fabrication mode: chairside (CS)=no temporary restoration (TR), labside (LS)=TR with Luxatemp (L) inserted with TempBond NE, or Systemp.

Biomechanical comparison of a new staple technique with tension band wiring for transverse patella fractures.

Background: The tension band wiring technique is the most common method of transverse patella fracture fixation. Since post-operative instabilities have been reported for this technique, alternative osteosynthesis solutions are of interest. We investigated the biomechanical behaviour of a new staple technique for treatment of transverse patella fractures in a cadaveric model.

Complications after Intramedullary Stabilization of Proximal Femur Fractures: a Retrospective Analysis of 178 Patients.

Secondary dislocation, non-union, re-fracture and implant failure are generally known complications after intramedullary fixation of proximal femur fractures with the PFN(®) (Synthes GmbH, Solothurn, Switzerland). The goal of our study was to assess the impact of patient- and treatment-specific risk factors on these complications. Complex fracture type and poor bone quality were defined as patient-specific risk factors.

The intravertebral vacuum phenomen as specific sign of osteonecrosis in vertebral compression fractures: results from a radiological and histological study.

This study investigated the prevalence of the intravertebral vacuum phenomenon (IVP) and osteonecroses in vertebral compression fractures (VCFs). We therefore performed an histological analysis of biopsies obtained from VCFs prior to balloon kyphoplasty. Computed tomography (CT) scans were reviewed regarding the presence of an IVP (i.

Recurrent locking of knee joint caused by intraarticular migration of bioabsorbable tibial interference screw after arthroscopic ACL reconstruction.

Two cases are reported in which, after ACL reconstruction with autologous hamstring grafts, tibial polylactide interference screws migrated into the knee joint. Clinically, both patients presented with recurrent locking of the joint. In one case, a broken 15 mm-long tip of the screw was found intra-articularly.