Waste Material Classification Based on a Wavelength-Sensitive Ge-on-Si Photodetector.

Waste material classification is critical for efficient recycling and waste management. This study proposes a novel, low-cost material classification system based on a single, voltage-tunable Ge-on-Si photodetector operating across the visible and short-wave infrared (SWIR) spectral regions. Thanks to its tunability, the sensor is able to extract spectral information, and the system effectively distinguishes between seven different materials, including plastics, aluminum, glass, and paper.

Waste Material Classification: A Short-Wave Infrared Discrete-Light-Source Approach Based on Light-Emitting Diodes.

Waste material classification is a challenging yet important task in waste management. The realization of low-cost waste classification systems and methods is critical to meet the ever-increasing demand for efficient waste management and recycling. In this paper, we demonstrate a simple, compact and low-cost classification system based on optical reflectance measurements in the short-wave infrared for the segregation of waste materials such as plastics, paper, glass, and aluminium.

Colloidal Quantum Dots for Explosive Detection: Trends and Perspectives.

Sensitive, accurate, and reliable detection of explosives has become one of the major needs for international security and environmental protection. Colloidal quantum dots, because of their unique chemical, optical, and electrical properties, as well as easy synthesis route and functionalization, have demonstrated high potential to meet the requirements for the development of suitable sensors, boosting the research in the field of explosive detection. Here, we critically review the most relevant research works, highlighting three different mechanisms for explosive detection based on colloidal quantum dots, namely photoluminescence, electrochemical, and chemoresistive sensing.

Material classification based on a SWIR discrete spectroscopy approach.

A crucial yet difficult task for waste management is the identification of raw materials like plastic, glass, aluminum, and paper. Most previous studies use the diffused reflection spectroscopy for classification purposes. Despite the benefits in terms of speed and simplicity offered by modern compact spectrometers, their cost and the need for an external, wide-spectrum source of illumination create complications.

Optical gas sensor based on the combination of a QD photoluminescent probe and a QD photodetector.

We report on a sensor architecture for detection of hazardous gases. The proposed device is based on the integration of a solid-state quantum dot (QD) photoluminescent probe with a QD photodetector on the same substrate. The effectiveness of the approach is demonstrated by developing a compact optical sensor for trace detection of explosives in air.

Lead sulphide colloidal quantum dots for room temperature NO gas sensors.

Colloidal quantum dots (CQDs) have been recently investigated as promising building blocks for low-cost and high-performance gas sensors due to their large effective surface-to-volume ratio and their suitability for versatile functionalization through surface chemistry. In this work we report on lead sulphide CQDs based sensors for room temperature NO detection. The sensor response has been measured for different pollutant gases including NO, CH, CO and CO and for different concentrations in the 2.

Narrowband colloidal quantum dot photodetectors for wavelength measurement applications.

High performance photodetectors based on colloidal quantum dots have been demonstrated in a wide spectral range spanning from the visible to the mid infrared. Quantum dot photodetectors typically show a low-pass type spectral response with a tunable cutoff wavelength. In this paper, we propose a method for the realization of narrowband photodetectors based on the combination of photoconductors and optical filters, both realized with colloidal PbS quantum dots.

Increasing responsivity and air stability of PbS colloidal quantum dot photoconductors with iodine surface ligands.

PbS colloidal quantum dots (QDs) are a promising material for the realization of low-cost, high-responsivity near-infrared photodetectors. Previously reported attempts showed high responsivity but a fast performance decay in air-exposed devices, demanding encapsulation of the photodetectors. Conversely, devices with very high air stability have been demonstrated but the low trap-state density hinders photoconductive gain and reduces overall responsivity.

PbS Colloidal Quantum Dot Photodetectors operating in the near infrared.

Colloidal quantum dots have recently attracted lot of interest in the fabrication of optoelectronic devices due to their unique optical properties and their simple and low cost fabrication. PbS nanocrystals emerged as the most advanced colloidal material for near infrared photodetectors. In this work we report on the fabrication and characterization of PbS colloidal quantum dot photoconductors.