This work investigated the operational and microbiological aspects of the decolorization of the azo dye Reactive Black 5 in acidogenic reactors followed by aerobic granular sludge (AGS) reactors, evaluating the effect of the acidogenic hydraulic retention time (HRT) (3, 2, and 1 h), effluent recirculation in the AGS reactor (50 mL min), dye concentration (50 and 100 mg L), and the redox mediator sodium anthraquinone-2-disulfonate (AQS) (50 μM). The acidogenic reactors were mainly responsible for the dye decolorization, with AQS significantly improving its efficiency and enabling the use of a shorter HRT (2 h). The recirculation effect was not so evident, probably masked by the adaptation of the acidogenic microbiota.
View Article and Find Full Text PDFAnaerobic digestion of fruit and vegetable waste (FVW) offers an environmentally friendly alternative for waste disposal, converting it into methane for energy recovery. Typically, FVW digestion is conducted in a continuously stirred tank reactor (CSTR) due to its ease of use and stability with solid concentrations between 5 and 10%. However, CSTRs are limited to organic loading rates (OLRs) of about 3 kg COD/m.
View Article and Find Full Text PDFThis work assessed the effect of increasing microaeration flow rates (1-6 mL min at 28 °C and 1 atm, equivalent to 0.025-0.152 L O L feed) on the removal/biotransformation of seven organic micropollutants (OMPs) (three hormones, one xenoestrogen, and three pharmaceuticals), at 200 μg L each, in a lab-scale upflow anaerobic sludge blanket reactor operated at a hydraulic retention time (HRT) of 7.
View Article and Find Full Text PDFEnviron Pollut
July 2021
Methane (CH) production from anaerobic digestion of solid and liquid agro-industrial wastes is an attractive strategy to meet the growing need for renewable energy sources and promote environmentally appropriate disposal of organic wastes. This work aimed at determining the CH production potential of six agro-industrial wastewaters (AWW), evaluating the most promising for methanization purposes. It also aims to provide kinetic parameters and stoichiometric coefficients of CH production and define which kinetic models are most suitable for simulating the CH production of the evaluated substrates.
View Article and Find Full Text PDFThis paper investigated the effect of calcium addition on the formation and properties of aerobic granules under high (conventional SBR) and low (simultaneous fill/draw SBR) selection pressure. Additionally, the simultaneous removal of carbon, nitrogen, and phosphorus, and the operational stability were assessed. The conventional SBRs showed earlier granule development (20 days) than the simultaneous fill/draw SBRs.
View Article and Find Full Text PDFJ Hazard Mater
February 2021
The present work assessed some engineering approaches, such as the addition of the redox mediator anthraquinone-2,6-disulfonate (AQDS) (50 and 100 μM), microaeration (1 mL air min), and nitrate (100-400 mg L), for enhancing the biotransformation of the antibiotics sulfamethoxazole (SMX) and trimethoprim (TMP) (200 μg L each) in anaerobic reactors operated at a short hydraulic retention time (7.4 h). Initially, very low removal efficiencies (REs) of SMX and TMP were obtained under anaerobic conditions (∼6%).
View Article and Find Full Text PDFThis work assessed the impact of methylparaben, ethylparaben, propylparaben, and butylparaben (200 μg L each) on the granulation process as well as on the organic matter and nutrient removal of an aerobic granular sludge (AGS) system (6-h cycle). Additionally, some insights into the main paraben removal mechanisms were provided. In the presence of parabens, aerobic granules with good settleability, but with fragile and irregular structure, were grown.
View Article and Find Full Text PDFThis work assessed the effect of adding different concentrations of nitrate (50-300 mg NO ·L) on the removal of dissolved and gaseous sulfide in an anaerobic reactor treating synthetic effluent containing sulfate (100 mg SO ·L) and organic matter (1 g COD·L). Autotrophic denitrification, stimulated by the addition of nitrate, was demonstrated to be a very effective approach for removal of dissolved sulfide even in the presence of a high concentration of organic matter (complete removal with 50 mg NO mg·L). However, it had a minor effect on HS.
View Article and Find Full Text PDFBioprocess Biosyst Eng
February 2021
Carboxylic acids (CA) are considered high added-value compounds, and their production from wastes has gained economic and environmental notoriety. However, the CA production and kinetic modeling using some agro-industrial wastewaters, such as bovine slaughterhouse wastewater (SHW), are not well reported in the literature. Therefore, the objective of this work was to evaluate the CA production potential using SHW as a substrate under acidogenic conditions and to apply mathematical models to estimate the kinetic parameters of particulate organic matter hydrolysis, soluble organic matter consumption, and CA production.
View Article and Find Full Text PDFThe engineering and microbiological aspects involved in the production of alginate-like exopolysaccharides (ALE) and tryptophan (TRY) in aerobic granular sludge systems were evaluated. The inclusion of short anoxic phase (A/O/A cycle-anaerobic, oxic, and anoxic phase) and the control of sludge retention time (SRT ≈ 10 days) proved to be an important strategy to increase the content of these bioproducts in granules. The substrate concentration also has a relevant impact on the production of ALE and TRY.
View Article and Find Full Text PDFThis paper aimed to assess the impact of the cycle type on aerobic granular sludge (AGS) formation, stability and system performance. Six AGS reactors were operated either on A/O cycles (anaerobic followed by oxic phase) or A/O/A cycles (anaerobic, followed by oxic and anoxic phases), changing only the phase time distribution. Reactors with high percentage of aerobic phase (65% of the total cycle time) generated granules with better settleability and resistance, however denitrification was impaired.
View Article and Find Full Text PDFThis work aimed to evaluate the potential of anaerobic carboxylic acids (CA) production from swine wastewater (SW), perform modeling studies of the acidogenic process and estimate the kinetic parameters. Tests were carried out in four batch reactors with 250 mL reaction volume, with brewery sludge as inoculum and using chloroform (0.05%, v/v) for methanogenesis inhibition.
View Article and Find Full Text PDFJ Environ Manage
February 2020
This work investigated the effect of Ca (100 mg L) addition on the formation and maintenance of aerobic granular sludge in a simultaneous fill/draw mode sequencing batch reactor (SBR), operated with a low liquid upflow velocity (0.92 m h), in order to verify if Ca presence compensates the low selection pressure imposed. Additionally, carbon and nutrients removals, granules characteristics and microbial community were evaluated.
View Article and Find Full Text PDFThis work aimed to compare the dynamics, biokinetics, and microbial diversity between activated sludge flocs (ASF) and aerobic granular sludge (AGS) whose systems were operated under similar experimental conditions in terms of inoculum, feeding, substrate source, etc. Therefore, the kinetic parameters involved in the organic matter removal, nitrification, denitrification, and dephosphatation were determined, as well as the microbial changes were assessed by metagenomics analysis. Regarding the kinetic parameter yield coefficient (Y), values of 0.
View Article and Find Full Text PDFBioresour Technol
April 2019
Three aerobic granular sludge systems were operated as sequencing batch reactors (SBR) with acetate, ethanol and glucose as carbon source. The SBR cycle was 6 h, with an anaerobic phase followed by an aerobic phase. The acetate granules (>1.
View Article and Find Full Text PDFThe effect of different microaeration flow rates and dosing points, and of effluent recirculation, on microaerobic BTEX degradation in an anaerobic bioreactor was assessed. Additionally, a sensitivity and recovery analysis for this system was performed during microaeration failure simulations. Under anaerobic conditions, BTEX removal efficiencies between 55 and 82% were achieved depending on the compound, being benzene the most recalcitrant one.
View Article and Find Full Text PDFAs the addition of low concentrations of oxygen can favor the initial degradation of benzene, toluene, ethylbenzene, and xylenes (BTEX) compounds, this work verified the applicability of the microaerobic technology to enhance BTEX removal in an anaerobic bioreactor supplemented with high and low co-substrate (ethanol) concentrations. Additionally, structural alterations on the bioreactor microbiota were assessed throughout the experiment. The bioreactor was fed with a synthetic BTEX-contaminated water (~ 3 mg L of each compound) and operated at a hydraulic retention time of 48 h.
View Article and Find Full Text PDFWater Sci Technol
September 2014
Some species of microalgae have high productivity and lipid content, which makes them good candidates for biodiesel production. Biomass separation and cell disruption are important steps in biodiesel production from microalgae. In this work, we explored the fundamentals of electroflotation by alternating current (EFAC) with non-consumable electrodes to simultaneously harvest microalgae and disrupt cells from mixed microalgae obtained from waste stabilization ponds.
View Article and Find Full Text PDFThis paper evaluated the occurrence and removal efficiency of four estrogenic hormones in five biological wastewater treatment plants (WWTPs), located in the State of Ceará, Brazil. The five WWTPs comprised: two systems consisted of one facultative pond followed by two maturation ponds, one facultative pond, one activated sludge (AS) system followed by a chlorination step, and one upflow anaerobic sludge blanket (UASB) reactor followed by a chlorination step. Estrogen occurrence showed a wide variation among the analyzed influent and effluent samples.
View Article and Find Full Text PDFThe objective of this study was to optimize, by employing a central composite rotatable design, and validate an analytical method to detect and quantify monoaromatic compounds (benzene, toluene, ethylbenzene, and xylenes) in waters and wastewaters by using headspace extraction followed by GC coupled with photoionization detection. The extraction parameters optimized were: salinity, sample volume, incubation time, and extraction temperature. The results revealed that the sample volume was the most significant parameter in the extraction process, whereas the salinity effect was negligible, which extends the applicability of the analytical method to waters with different salinities.
View Article and Find Full Text PDFThis work assessed the application of one- and two-stage mesophilic anaerobic systems to colour removal of sulphonated mono and diazo dyes with ethanol as electron donor. The dyes Congo Red (CR), Reactive Black 5 (RB5) and Reactive Red 2 (RR2) were selected as model compounds and tested separately in seven different periods. The one-stage system (R(1)) consisted of a single up-flow anaerobic sludge blanket (UASB) reactor, whereas the two-stage system (R(2)) consisted of an acidogenic UASB reactor (R(A)), a settler and a methanogenic UASB reactor (R(M)).
View Article and Find Full Text PDFThis work assessed the impact of the redox mediator sodium anthraquinone-2,6-disulphonate (AQDS) on the reductive decolourisation of the azo dye Reactive Red 2 (RR2) in one- and two-stage anaerobic systems (R(1) and R(2), respectively). The two-stage system achieved better colour removal efficiencies (52-62%) than the single-stage system (23-33%) in the absence of AQDS. Addition of AQDS accelerated the electrons transfer from the substrate (ethanol) to the dye, which increased the colour removal efficiency of both anaerobic systems (≈ 85%).
View Article and Find Full Text PDFDecolourisation of the azo dye model compound, Congo Red (CR), and real textile wastewater, was assessed in one- and two-stage anaerobic treatment systems (R₁ and R₂, respectively). High colour removals were achieved in both treatment systems even when a very high CR concentration (1.2 mM) was applied.
View Article and Find Full Text PDFDyes are natural and xenobiotic compounds that make the world more beautiful through coloured substances. However, the release of coloured wastewaters represents a serious environmental problem and a public health concern. Colour removal, especially from textile wastewaters, has been a big challenge over the last decades, and up to now there is no single and economically attractive treatment that can effectively decolourise dyes.
View Article and Find Full Text PDF