Aspects of glass and hybridization protocols for bonding of fiber posts to root dentine.

This study evaluated bond strength of glass fiber posts to root dentin using push-out (PO) and diametral compression (DC), testing glycolic acid as a conditioner and varying dentin moisture. An additional aim was to test whether DC can be an alternative test to PO for bond strength assessment. Eighty bovine teeth were divided into eight groups (n = 10) defined by the use of either 37% glycolic acid or 37% phosphoric acid (PA) on moist or wet dentin before bonding with either Adapter SingleBond/RelyX ARC or One Step Plus/Duo-Link Bisco.

Influence of photodynamic therapy, different final irrigants, and ultrasonic activation on the bond strength of glass fiber posts to root dentin.

Objective: To evaluate the influence of photodynamic therapy (PDT), different final irrigants, and ultrasonic activation (US) on the bond strength of glass fiber posts (GFP) to root dentin.

Methods: One hundred twenty bovine roots were divided into 12 groups according to PDT application, the type of final endodontic irrigant, and US. The samples were divided into 12 groups (n = 10): G1-DW(distilled water); G2-DW+US; G3-17% EDTA; G4-17% EDTA+US; G5-17% GA (glycolic acid); G6-17% GA+US; G7-PDT+DW; G8-PDT+DW+US; G9-PDT+17% EDTA; G10-PDT+17% EDTA+US; G11-PDT+17% GA; G12-PDT+17% GA+US.

Effect of glycolic acid and EDTA on dentin mechanical properties.

The aim of this study was to evaluate the effect of glycolic acid (GA) and EDTA on dentin mechanical properties. For the cohesive strength, flexural strength and fracture strength tests, the hourglass of root dentin, dentin sticks and roots standardised to 1 mm thickness were used respectively. ANOVA and Tukey tests were used for statistical analysis (P < 0.

Influence of the apical limit of instrumentation and photodynamic therapy on the postoperative pain of lower molars with asymptomatic apical periodontitis.

Introduction: The aim of present study was to evaluate the influence of apical limit of instrumentation and PDT on the postoperative pain of lower molars with asymptomatic apical periodontitis.

Methods: Forty patients were included in the present study and were divided into 4 groups (n=10), according to apical limit of instrumentation and use of PDT: instrumentation at 0.0 measurement; instrumentation at 0.

Removal of water binding proteins from dentin increases the adhesion strength of low-hydrophilicity dental resins.

Objectives: To investigate the role of proteoglycans (PGs) on the physical properties of the dentin matrix and the bond strength of methacrylate resins with varying hydrophilicities.

Methods: Dentin were obtained from crowns of human molars. Enzymatic removal of PGs followed a standard protocol using 1 mg/mL trypsin (Try) for 24 h.

Effect of a new irrigant solution containing glycolic acid on smear layer removal and chemical/mechanical properties of dentin.

The objective of this study was to evaluate the effects of glycolic acid (GA) (with pH 1.2 and 5) and ethylenediaminetetraacetic acid (EDTA) on the chemical and mechanical properties of dentin to investigate the potential use of GA as final irrigant in the root canal therapy. Specifically, changes in microhardness, smear layer removal, erosion, mineral content distribution, apatite/collagen ratio and flexural strength of mineralized dentin treated with GA were assessed.

Antibacterial Efficacy of the Grape Seed Extract as an Irrigant for Root Canal Preparation.

Objective: The purpose of this research was to compare relative effectiveness of sodium hypochlorite 5.25% (NaOCl), 2% chlorhexidine gel (CHX) and 6.5 % grape seed extract (GSE) against Enterococcus faecalis using instrument Reciproc R25 in root canal preparation.

Association of calcium hypochlorite, reciprocating instrumentation and photodynamic therapy: Antimicrobial analysis and effects on root dentin structure.

Introduction: This study aimed to evaluate the antimicrobial action of calcium hypochlorite(Ca[OCl]) and sodium hypochlorite (NaOCl) with reciprocating instrumentation and photodynamic therapy(PDT), and its influence on root dentin structure.

Methods: One hundred and ten human teeth were used to antimicrobial evaluation, inoculated with Enterococcus faecalis and divided into 11 groups (n = 10): G1 - distilled water(control); G2-1 % NaOCl; G3-5.25 % NaOCl; G4-1 % Ca(OCl); G5-5.

Antimicrobial activity of glycolic acid as a final irrigant solution for root canal preparation.

The objective of this study was to evaluate the antimicrobial capacity of glycolic acid (GA) at different concentrations as a final irrigant during the preparation of root canals. The sample consisted of 77 extracted single-rooted human teeth with complete root formation, no previous endodontic treatment, and a root length of at least 14 mm. The root canals were prepared in a standardized manner with a rotary file system.

Glycolic acid: Characterization of a new final irrigant and effects on flexural strength and structural integrity of dentin.

The aim of this study was to characterize glycolic acid (GA) and examine its effects on powder and flexural strength of dentin. Particle size and energy-dispersive EDS in GA powder was performed for chemical analysis. Surface tension and pH levels of ethylenediaminetetraacetic acid (EDTA), citric acid (CA), and GA solutions were evaluated at different times and temperatures.

Assessment of the Ability of Different Cleaning Protocols to Remove Eugenol-based Endodontic Sealer from the Root Dentin.

Aim: The aim of this study is to assess three protocols for removing a eugenol-based filling endodontic sealer from root dentin and the bond strength of fiberglass posts luted with resin cement.

Materials And Methods: Sixty single-rooted bovine teeth were prepared and filled with the Endofill endodontic sealer and gutta-percha cones. After 7 days, 9 mm of the filling was removed and divided into five groups ( = 12) according to the cleaning protocol: G1 (negative control), unfilled; G2 (positive control), saline solution; G3, 95% alcohol; G4, amyl acetate; and G5, Largo bur.

Glycolic acid as the final irrigant in endodontics: Mechanical and cytotoxic effects.

The aim of this study was to investigate the effects of glycolic acid (GA) on the microhardness, roughness, dentin mineral content distribution; smear layer removal and cytotoxicity. One hundred human teeth were randomly divided into six groups: distilled water (control group), 17% EDTA, 10% citric acid (CA), 5% GA, 10% GA, and, 17% GA. Microhardness and roughness were measured in the canal lumen.

Fracture Strength and Stress Distribution in Premolars Restored with Cast Post-and-Cores or Glass-Fiber Posts Considering the Influence of Ferule.

Objectives: The aim of this study was to evaluate the influence of ferule and the post type on the fracture strength and stress distribution in premolars.

Materials And Methods: Forty human mandibular premolars were decoronated, allocated in four groups, and restored as follows: CPC-NF: cast post-and-core and absence of ferule; CPC-F: cast post-and-core and presence of ferule; FPC-NF: glass-fiber posts and absence of ferule; FPC-F: glass-fiber posts and presence of ferule. The fracture strength (FS) and failure patterns were evaluated.

Structural and biomechanical changes to dentin extracellular matrix following chemical removal of proteoglycans.

Proteoglycans are biomacromolecules with significant biomineralization and structural roles in the dentin extracellular matrix. This study comprehensively assessed the mechanical properties and morphology of the dentin extracellular matrix following chemical removal of proteoglycans to elucidate the structural roles of proteoglycans in dentin. Dentin extracellular matrix was prepared from extracted teeth after complete tissue demineralization.

Antibacterial Efficacy of Synthetic and Natural-Derived Novel Endodontic Irrigant Solutions.

The aim of this study was to compare the efficacy of grape seed extract (GSE), calcium hypochlorite [Ca(ClO)2], and sodium hypochlorite (NaOCl) irrigant solutions with rotary or reciprocating instrumentation for disinfection of root canals inoculated with Enterococcus faecalis. The mesiobuccal root canals of mandibular molars were prepared and inoculated with Enterococcus faecalis for 21 days. The roots were then randomly divided into the following eight experimental groups (n=11) according to the instrumentation technique and disinfection protocol: ProTaper Next or Reciproc R25 with sodium chloride (control group), 6% NaOCl, 6% Ca(ClO)2, or 50% GSE used for irrigation during instrumentation.

Oral Lesions found in a Dental School in Southern Brazil.

Objective: This study aimed to perform an epidemiological survey of the cases of oral lesions diagnosed in a Brazilian dental school.

Materials And Methods: An epidemiological survey was carried out at the Faculty of Dentistry of the University of Passo Fundo (FOUPF), Rio Grande do Sul, Brazil, between March 2015 and June 2017, characterizing the patients in terms of gender, age, and ethnicity. A total of 3,200 records were evaluated, from which 716 presented information on oral lesions diagnosed and treated at the clinics of the FOUPF.

Efficacy of Natural Collagen Crosslinkers on the Compromised Adhesive Bond Strength to NaOCl-treated Pulp Chamber Dentin.

Purpose: To evaluate the efficacy of natural collagen crosslinkers on compromised adhesive bond strength to NaOCl-treated pulp chamber dentin.

Materials And Methods: Mesial surfaces of the pulp chamber dentin of 120 extracted human molars were obtained. The dentin fragments were divided into six groups according to the protocols used: no treatment (negative control), sodium hypochlorite (NaOCl) for 30 min and final irrigation with 17% EDTA for 3 min (positive control).

Effect of different protocols of eugenol removal on the bond strength between the fibre post and root dentin.

The aim of this study was to evaluate the bond strength between the fibre post and root dentin after different cleaning protocols to remove eugenol from dentin. The residues and elemental composition of dentin were analysed using SEM and EDS. Bovine incisor roots were obturated with eugenol-based sealer.

Does adding an instrument after root preparation with Reciproc R25 increase bacterial reduction?

Aim: The aim of this study was to compare the bacterial reduction achieved with reciprocating instruments such as Reciproc R25 (VDW GMBH, Munich, Germany) and Reciproc R25 combined with rotary file Mtwo 40.04 (VDW GMBH) during root canal preparation.

Materials And Methods: Fifty mesiobuccal root canals of maxillary molars were contaminated with broth culture and then an initial bacterial sample was collected from the root canal with paper cones and plated on brain-heart infusion agar.

The effects of endodontic substances and naturally reducing agents on the bond strength of epoxy resin-based sealer to root dentin.

Aim: To evaluate the effects of sodium hypochlorite (NaOCl), chlorhexidine (CHX), and two naturally derived reducing agents on the bond strength of epoxy resin-based sealer to root dentin.

Materials And Methods: A total of 60 single-rooted human teeth were prepared using ProTaper (Dentsply Tulsa Dental Specialties, Johnson City, TN, USA) and an irrigation protocol including 5% NaOCl or 2% CHX gel, and ethylenediaminetetraacetic acid (EDTA), for smear layer removal. The following subgroups ( = 10) were also assessed according to the naturally derived reducing agent used: no agent (control group); grape seed extract (GSE); and green tea.

Role of proteoglycans on the biochemical and biomechanical properties of dentin organic matrix.

Objective: Proteoglycans (PGs) are multifunctional biomacromolecules of the extracellular matrix of collagen-based tissues. In teeth, besides a pivotal regulatory role on dentin biomineralization, PGs provide mechanical support to the mineralized tissue and compressive strength to the biosystem. This study assessed enzymatic protocols for selective PGs removal from demineralized dentin to determine the roles of these biomacromolecules in the bulk mechanical properties and biostability of type I collagen.

Effects of an endodontic auxiliary chemical substance on the bond strength of two methacrylate-based endodontic sealers to dentin.

Purpose: To evaluate the influence of irrigation protocols and drying procedures on the bond strength of two methacrylate-based sealers to dentin and the associated failure pattern using scanning electron microscopy (SEM).

Materials And Methods: Fifty single-rooted human teeth were prepared with an irrigation protocol using either 5.25% sodium hypochlorite (NaOCl) or 2% chlorhexidine (CHX) and 17% EDTA (ethylenediaminetetraacetic acid) for smear layer removal.

Fit Analysis of Different Framework Fabrication Techniques for Implant-Supported Partial Prostheses.

Purpose: This study evaluated the vertical misfit of implant-supported frameworks made using different techniques to obtain passive fit.

Materials And Methods: Thirty three-unit fixed partial dentures were fabricated in cobalt-chromium alloy (n = 10) using three fabrication methods: one-piece casting, framework cemented on prepared abutments, and laser welding. The vertical misfit between the frameworks and the abutments was evaluated with an optical microscope using the single-screw test.

Comparative evaluation of the retaining of QMix and chlorhexidine formulations on human dentin: a chemical analysis.

Objectives: The purpose of this study was to investigate, in vitro, the retaining of 2 % CHX gel, 2 % CHX liquid and QMix (an endodontic irrigant) within a root canal for 24 h, 30, 90, and 120 days by chemical analysis.

Methods: Eighty extracted human teeth were used for this study. The samples were divided into four groups (G1-G4), according to the chemical auxiliary substance used to perform the instrumentation: G1 (control): distilled water, G2: 2 % CHX gel, G3: 2 % CHX liquid, and G4: QMix.

Acid Etching and Surface Coating of Glass-Fiber Posts: Bond Strength and Interface Analysis.

The aim of this study was to evaluate the bond strength of a composite resin to glass-fiber post (GFP) treated or not with phosphoric acid, silane coupling agent, and unfilled resin. GFPs were etched or not with 37% phosphoric acid and different surface coating applied: silane coupling agent, unfilled resin, or both. Composite resin blocks were built around a 4-mm height on the GFP.