Supramolecular structure, relaxation behavior and free volume of bio-based poly(butylene 2,5-furandicarboxylate)--poly(caprolactone) copolyesters.

In the present study, a fully plant-based sustainable copolyester series, namely poly(butylene 2,5-furandicarboxylate)--poly(caprolactone)s (PBF--PCL)s were successfully synthesized by melt polycondensation combining butylene 2,5-furandicarboxylate with polycaprolactone diol (PCL) at different weight ratios. Differential scanning calorimetry (DSC) showed that only PBF underwent melting, crystallization from the melt, and cold crystallization. Thermogravimetric analysis (TGA) revealed outstanding thermal stability, exceeding 305 °C, with further improvement in thermal and thermo-oxidative stability with increasing PCL content.

Relaxation Dynamics of Biomass-Derived Copolymers With Promising Gas-Barrier Properties.

This article presents an experimental study on the relaxation dynamics of a series of random copolymers based on bio-friendly comonomers with interesting gas barrier properties. We analyze the relaxation response in the glassy and ultraviscous regime of poly (trimethylene furanoate/sebacate) random copolymers via dielectric spectroscopy. We report lower values of dynamic fragility [a dimensionless index introduced in 1985 (Angell, Relaxations in Complex Systems, 1985)] in comparison to popular polyesters widely used in industry, such as poly (ethylene terephthalate), suggesting that the amorphous phase of these furanoate-based polyesters adopt an efficient chain packing.

Functional Properties of Poly(Trimethylene Terephthalate)-Block-Poly(Caprolactone) Based Nanocomposites Containing Graphene Oxide (GO) and Reduced Graphene Oxide (rGO).

This work reports a study on the influence of graphene oxide (GO) and reduced graphene oxide (rGO) on the functional properties of poly(trimethylene terephthalate)-block-poly(caprolactone) (PTT--PCL-T) (75/25 wt.%/wt.%) copolymer, obtained from dimethyl terephthalate (DMT), 1,3-biopropanediol and polycaprolactone diol (PCL) via in situ polymerization.

Understanding crystallization features of P(VDF-TrFE) copolymers under confinement to optimize ferroelectricity in nanostructures.

The successful development of ferroelectric polymer devices depends on the effective fabrication of polar ferroelectric crystalline nanostructures. We demonstrate, by scanning X-ray microdiffraction using synchrotron light, the heterogeneous character of high aspect ratio one-dimensional nanoarrays of poly(vinylidene fluoride-co-trifluoroethylene) copolymers supported by a residual polymer film. They were prepared by melt and solution template wetting, using porous anodic aluminum oxide as a template.

Crystallization under one-dimensional confinement in alumina nanopores of poly(trimethylene terephthalate) and its composites with single wall carbon nanotubes.

We report the preparation of semicrystalline polymer nanorods of PTT and of its nanocomposites with SWCNTs by infiltration of the molten polymer into disordered anodic alumina membranes. An accurate study of the crystalline orientation of these systems has been accomplished by means of X-ray microdiffraction. While polymer residual film exhibits isotropic character, edge-on lamellae are formed upon approaching the polymer/membrane interface.

Restricted dynamics in oriented semicrystalline polymers: poly(vinilydene fluoride).

The effect of confinement by crystals on the α relaxation, observed by dielectric broadband spectroscopy, in isotropic as well as in oriented semicrystalline poly(vinilydene fluoride), is analyzed on the basis of a new thermodynamic model. In both samples, it has been found that the average free-energy barrier, ΔF, for conformational rearrangements is of the same order of the dispersion barrier heights, δ(ΔF), around ΔF, i.e.

Confinement-induced one-dimensional ferroelectric polymer arrays.

This work demonstrates the use of wetting nanoporous alumina template with polymer solution to produce arrays of isolated poly(vinylidene fluoride) (PVDF) ferroelectric gamma-type nanorods supported within a nonpolar alpha-structure film. The method is based upon a crystal phase transition which occurs due to PVDF confinement within alumina nanoporous. The system was studied using scanning X-ray microdiffraction (micro-XRD) that allows the solid-solid phase transition from the alpha-nonpolar crystal form (bulk) to the gamma polar ferroelectric form (nanorod array) to be spatially resolved, as well as providing crystallinity and orientation information.