Simultaneous Multidrop Creation with Superhydrophobic Wells for Field Environmental Sensing of Nanoparticles.

Facile creation of multiple drops at appropriate volumes on surfaces without the use of sophisticated instrumentation facilitates downstream evaporative preconcentration of liquid samples for analytical purposes. In this work, a superhydrophobic (SH) substrate comprising wells with a perforated mesh base was developed for simultaneous drop creation in a quick and convenient manner. In contrast to the method of pouring liquid directly over the SH wells, consistent liquid filling was readily achieved by a simple immersion approach.

Antibody drop based handling with near-superhydrophobic mesh substrates overcomes condensation sticking.

Superhydrophobic substrates facilitate low adhesion for biological liquid handling but are hampered by wetting state changes due to condensation. Here, meshed near-superhydrophobic substrates, that are easier to produce than two-tiered architecture substrates, are shown to provide good immunity to wetting state changes while imbuing high positional resistance to roll-off by tilting when tested with 5 and 10 μL volume drops (18° and 13° respectively) of human IgG antibodies in aqueous solution at both room temperature and 4 °C. Pneumatic actuation was applied to elicit horizontal drop movement over the near-SH surface without any fragmentation, wherein higher velocities can be achieved when smaller drops and higher air pressures are used (0.

Note: Biochemical samples centrifuged in-flight on drones.

The ability to conduct en-route centrifugation of samples improves quality and timeliness in the pre-analytical phase. This is demonstrated here on a quadcopter whereby the propellers were adapted to house and apply centrifugal forces to sample-containing capillary tubes instead of incorporating a centrifuge. Tests revealed the ability of the method to separate non-homogenized milk into a cream portion and a skim milk portion, and human whole blood into plasma, buffy coat, and red blood cell components.

Drone inflight mixing of biochemical samples.

Autonomous systems for sample transport to the laboratory for analysis can be improved in terms of timeliness, cost and error mitigation in the pre-analytical testing phase. Drones have been reported for outdoor sample transport but incorporating devices on them to attain homogenous mixing of reagents during flight to enhance sample processing timeliness is limited by payload issues. It is shown here that flipping maneuvers conducted with quadcopters are able to facilitate complete and gentle mixing.

Liquid-body resonance while contacting a rotating superhydrophobic surface.

We advance a scheme in which a liquid body on a stationary tip in contact with a rotating superhydrophobic surface is able to maintain resonance primarily from stick-slip events. With tip-to-surface spacing in the range 2.73 ≤ h < 2.

Plastron-Mediated Growth of Captive Bubbles on Superhydrophobic Surfaces.

Captive bubbles on a superhydrophobic (SH) surface have been shown to increase in volume via injection of air through the surrounding plastron. The experimental contact diameter against volume trends were found to follow that predicted by the Surface Evolver simulation generally but corresponded with the simulated data at contact angle (CA) = 158° when the volume was 20 μL but that at CA = 170° when the volume was increased to 180 μL. In this regime, there was a simultaneous outward movement of the contact line as well as a small reduction in the slope that the liquid-air interface makes with the horizontal as air was injected.

A direct heating model to overcome the edge effect in microplates.

Array-based tests in a microplate format are complicated by the regional variation in results of the outer against the inner wells of the plate. Analysis of the evaporation mechanics of sessile drops showed that evaporation rate increase with temperature was due to changes in the heat of vaporization, density and diffusion coefficient. In simulations of direct bottom heating of standard microplates, considerable heat transfer via conduction from the side walls was found to be responsible for lower temperatures in the liquid in wells close to the edge.