Tailoring the Li Intercalation Energy of Carbon Nanocage Anodes Via Atomic Al-Doping for High-Performance Lithium-Ion Batteries.

Graphitic carbon materials are widely used in lithium-ion batteries (LIBs) due to their stability and high conductivity. However, graphite anodes have low specific capacity and degrade over time, limiting their application. To meet advanced energy storage needs, high-performance graphitic carbon materials are required.

Waveguide-Coupled Light Photodetector Based on Two-Dimensional Molybdenum Disulfide.

The integration of transition metal dichalcogenides with photonic structures such as sol-gel SiO:TiO optical waveguides (WGs) makes possible the fabrication of photonic devices with the desired characteristics in the visible spectral range. In this study, we propose and experimentally demonstrate a MoS-based photodetector integrated with a sol-gel SiO:TiO WG. Based on the spectroscopic measurements performed for our device, we concluded that the light entering the WG is almost completely channeled out from the WG and absorbed by the MoS flake, which is deposited on the WG.

High yield and wide lateral size growth of α-MoC: exploring the boundaries of CVD growth of bare MXene analogues.

Synthesis of MoC bare MXenes, without surface terminations groups, via chemical vapor deposition (CVD) on metal foils is scientifically a very intriguing crystal growth process, and there are still challenges and limited fundamental understanding to overcome to obtain high yield and wide crystal size lateral growth. Achieving large area coverage via direct growth is scientifically vital to utilize the full potential of their unique properties in different applications. In this study, we sought to expand the boundaries of the current CVD growth approach for MoC MXenes and gain insights into the possibilities and limitations of large area growth, with a particular focus on controlling Mo concentration.

Stability of mechanically exfoliated layered monochalcogenides under ambient conditions.

Monochalcogenides of groups III (GaS, GaSe) and VI (GeS, GeSe, SnS, and SnSe) are materials with interesting thickness-dependent characteristics, which have been applied in many areas. However, the stability of layered monochalcogenides (LMs) is a real problem in semiconductor devices that contain these materials. Therefore, it is an important issue that needs to be explored.

Sol-Gel Derived Silica-Titania Waveguide Films for Applications in Evanescent Wave Sensors-Comprehensive Study.

Composite silica-titania waveguide films of refractive index ca. 1.8 are fabricated on glass substrates using a sol-gel method and dip-coating technique.

Optical Thin Films Fabrication Techniques-Towards a Low-Cost Solution for the Integrated Photonic Platform: A Review of the Current Status.

In the past few decades, several methods concerning optical thin films have been established to facilitate the development of integrated optics. This paper provides a brief depiction of different techniques for implementing optical waveguide thin films that involve chemical, physical, and refractive index modification methods. Recent advances in these fabrication methods are also been presented.

Eliminating Graphite Exfoliation with an Artificial Solid Electrolyte Interphase for Stable Lithium-Ion Batteries.

Although graphite materials with desirable comprehensive properties dominate the anode market of commercial lithium-ion batteries (LIBs), their low capacity during fast charging precludes further commercialization. In the present work, natural graphite (G) is reported not only to suffer from low capacity during fast charging, but also from charge failure after many charging cycles. Using different characterization techniques, severe graphite exfoliation, and continuously increasing solid electrolyte interphase (SEI) are demonstrated as reasons for the failure of G samples.

Applications of Carbon Nanotubes in the Internet of Things Era.

The post-Moore's era has boosted the progress in carbon nanotube-based transistors. Indeed, the 5G communication and cloud computing stimulate the research in applications of carbon nanotubes in electronic devices. In this perspective, we deliver the readers with the latest trends in carbon nanotube research, including high-frequency transistors, biomedical sensors and actuators, brain-machine interfaces, and flexible logic devices and energy storages.

In Situ Fabrication of Freestanding Single-Atom-Thick 2D Metal/Metallene and 2D Metal/ Metallene Oxide Membranes: Recent Developments.

In recent years, two-dimensional (2D) materials have attracted a lot of research interest as they exhibit several fascinating properties. However, outside of 2D materials derived from van der Waals layered bulk materials only a few other such materials are realized, and it remains difficult to confirm their 2D freestanding structure. Despite that, many metals are predicted to exist as 2D systems.

A Facile and Efficient Bromination of Multi-Walled Carbon Nanotubes.

The bromination of multi-walled carbon nanotubes (MWCNT) was performed with vapor bromine in a closed vessel, and they were subjected to intensive stirring with a magnetic stirrer for up to 14 days. The efficiency of bromination was compared depending upon duration. The structure and surface of the crude and purified products were characterized by detailed physicochemical analyses, such as SEM/EDS, TEM, XRD, TGA, Raman, and XPS spectroscopies.

Tailoring the stoichiometry of CN nanosheets under electron beam irradiation.

Two-dimensional polymeric graphitic carbon nitride (g-C3N4) is a low-cost material with versatile properties that can be enhanced by the introduction of dopant atoms and by changing the degree of polymerization/stoichiometry, which offers significant benefits for numerous applications. Herein, we investigate the stability of g-C3N4 under electron beam irradiation inside a transmission electron microscope operating at different electron acceleration voltages. Our findings indicate that the degradation of g-C3N4 occurs with N species preferentially removed over C species.

Facile production of ultra-fine silicon nanoparticles.

A facile procedure for the synthesis of ultra-fine silicon nanoparticles without the need for a Schlenk vacuum line is presented. The process consists of the production of a (HSiO) sol-gel precursor based on the polycondensation of low-cost trichlorosilane (HSiCl), followed by its annealing and etching. The obtained materials were thoroughly characterized after each preparation step by electron microscopy, Fourier transform and Raman spectroscopy, X-ray dispersion spectroscopy, diffraction methods and photoluminescence spectroscopy.

Large-Area Single-Crystal Graphene via Self-Organization at the Macroscale.

In 1665 Christiaan Huygens first noticed how two pendulums, regardless of their initial state, would synchronize.  It is now known that the universe is full of complex self-organizing systems, from neural networks to correlated materials. Here, graphene flakes, nucleated over a polycrystalline graphene film, synchronize during growth so as to ultimately yield a common crystal orientation at the macroscale.

2D Intrinsic Ferromagnetic MnP Single Crystals.

2D intrinsic ferromagnetic materials are highly anticipated in spintronic devices due to their coveted 2D limited magnetism. However, 2D non-layered intrinsic ferromagnets have received sporadic attention, which is largely attributed to the fact that their synthesis is still a great challenge. Significantly, manganese phosphide (MnP) is a promising non-layered intrinsic ferromagnet with excellent properties.

In Situ N-Doped Graphene and Mo Nanoribbon Formation from Mo Ti C MXene Monolayers.

Since the advent of monolayered 2D transition metal carbide and nitrides (MXenes) in 2011, the number of different monolayer systems and the study thereof have been on the rise. Mo Ti C is one of the least studied MXenes and new insights to this material are of value to the field. Here, the stability of Mo Ti C under electron irradiation is investigated.

Room temperature single-step synthesis of metal decorated boron-rich nanowires via laser ablation.

Hybrid nanostructures, such as those with nanoparticles anchored on the surface of nanowires, or decorated nanowires, have a large number of potential and tested applications such as: gas sensing, catalysis, plasmonic waveguides, supercapacitors and more. The downside of these nanostructures is their production. Generally, multi-step synthesis procedures are used, with the nanowires and the nanoparticles typically produced separately and then integrated.

Electron-Driven In Situ Transmission Electron Microscopy of 2D Transition Metal Dichalcogenides and Their 2D Heterostructures.

Investigations on monolayered transition metal dichalcogenides (TMDs) and TMD heterostructures have been steadily increasing over the past years due to their potential application in a wide variety of fields such as microelectronics, sensors, batteries, solar cells, and supercapacitors, among others. The present work focuses on the characterization of TMDs using transmission electron microscopy, which allows not only static atomic resolution but also investigations into the dynamic behavior of atoms within such materials. Herein, we present a body of recent research from the various techniques available in the transmission electron microscope to structurally and analytically characterize layered TMDs and briefly compare the advantages of TEM with other characterization techniques.

Effect of Milling and Annealing on Carbon-Silver System.

Mechanical treatment of graphite silver mixture followed by heat treatment showed morphology and structure changes of both components. Silver is being distributed over graphite flakes randomly with higher concentration on the edges and nanometric size, which was observed using scanning and transmission electron microscopy. The annealing temperature 1300 °C is higher than melting temperature of silver (961.

Applications of 2D MXenes in energy conversion and storage systems.

Transition metal carbides and nitrides (MXenes), a family of two-dimensional (2D) inorganic compounds, are materials composed of a few atomic layers of transition metal carbides, nitrides, or carbonitrides. Ti3C2, the first 2D layered MXene, was isolated in 2011. This material, which is a layered bulk material analogous to graphite, was derived from its 3D phase, Ti3AlC2 MAX.

New Frontiers in Electron Beam-Driven Chemistry in and around Graphene.

Modern aberration corrected transmission electron microscopes offer the potential for electron beam sensitive materials, such as graphene, to be examined with low energy electrons to minimize, and even avoid, damage while still affording atomic resolution, and thus providing excellent characterization. Here in this review, the exploits in which the electron beam interactions, which are often considered negative, are explored to usefully drive a wealth of chemistry in and around graphene, importantly, with no other external stimuli. After introducing the technique, this review covers carbon phase reactions between amorphous carbon, graphene, fullerenes, carbon chains, and carbon nanotubes.

In Situ Room Temperature Electron-Beam Driven Graphene Growth from Hydrocarbon Contamination in a Transmission Electron Microscope.

The excitement of graphene (as well as 2D materials in general) has generated numerous procedures for the fabrication of graphene. Here we present a mini-review on a rather less known, but attractive, in situ means to fabricate graphene inside a transmission electron microscope (TEM). This is achieved in a conventional TEM (viz.

In Situ Electron Driven Carbon Nanopillar-Fullerene Transformation through Cr Atom Mediation.

The promise of sp nanomaterials remains immense, and ways to strategically combine and manipulate these nanostructures will further enhance their potential as well as advance nanotechnology as a whole. The scale of these structures requires precision at the atomic scale. In this sense electron microscopes are attractive as they offer both atomic imaging and a means to structurally modify structures.

Self-Terminating Confinement Approach for Large-Area Uniform Monolayer Graphene Directly over Si/SiO by Chemical Vapor Deposition.

To synthesize graphene by chemical vapor deposition (CVD) both in large area and with uniform layer number directly over Si/SiO has proven challenging. The use of catalytically active metal substrates, in particular Cu, has shown far greater success and therefore is popular. That said, for electronics applications it requires a transfer procedure, which tends to damage and contaminate the graphene.