Accurate dosimetric measurement of large extended SSD fields for comparison to TPS models.

Purpose: There is little evidence in the literature which quantifies the accuracy of Treatment Planning Systems (TPSs) using large fields at extended SSD (eSSD). This paper introduces the approach taken at Christchurch Hospital, New Zealand to validate the use of the Monaco TPS for Total Body Irradiation (TBI) treatments.

Methods: A purpose-built device for allowing precise movements of block-like phantoms called a Phantom Mobility Device (PMD) was used for collecting measurements at eSSD.

Optimising the use of EPIgray for 3DCRT breast treatments.

EPIgray is an in-vivo dosimetry system which uses electronic portal images to calculate dose delivered to a point of interest (POI) and the percentage dose difference (%DDiff) from expected dose. For 3D conformal radiotherapy (3DCRT) of breasts, a small shift between patient position on treatment compared to the planning CT is often clinically accepted. However due to the use of the planning CT in the EPIgray back-projection algorithm, acceptable shifts can have undue impact on EPIgray dose so it does not reflect true POI dose.

Total body irradiation in Australia and New Zealand: results of a practice survey.

Total body irradiation (TBI) is an important treatment modality for the preparation of patients for bone marrow transplants. It is technically challenging and the actual delivery may vary from clinic to clinic. Knowledge of the pattern of practice may be helpful for clinics to determine future practice.

Optical-Radiation-Calorimeter Refinement by Virtual-Sensitivity Analysis.

Digital holographic interferometry (DHI) radiation dosimetry has been proposed as an experimental metrology technique for measuring absorbed radiation doses to water with high spatial resolution via noninvasive optical calorimetry. The process involves digitally recording consecutive interference patterns resulting from variations in the refractive index as a function of the radiation-absorbed dose. Experiments conducted on prototype optical systems revealed the approach to be feasible but strongly dependent on environmental-influence quantities and setup configuration.