Tired and stressed: direct holographic quasi-static stretching of aging echinocytes and discocytes in plasma using optical tweezers [Invited].

Red blood cells (RBCs) undergo a progressive morphological transformation from smooth biconcave discocytes into rounder echinocytes with spicules on their surface during cold storage. The echinocytic morphology impacts RBCs' ability to flow through narrow sections of the circulation and therefore transfusion of RBC units with a high echinocytic content are thought to have a reduced efficiency. We use an optical tweezers-based technique where we directly trap and measure linear stiffness of RBCs under stress without the use of attached spherical probe particles or microfluidic flow to induce shear.

Deep learning in light-matter interactions.

The deep-learning revolution is providing enticing new opportunities to manipulate and harness light at all scales. By building models of light-matter interactions from large experimental or simulated datasets, deep learning has already improved the design of nanophotonic devices and the acquisition and analysis of experimental data, even in situations where the underlying theory is not sufficiently established or too complex to be of practical use. Beyond these early success stories, deep learning also poses several challenges.

Enhanced Signal-to-Noise and Fast Calibration of Optical Tweezers Using Single Trapping Events.

The trap stiffness us the key property in using optical tweezers as a force transducer. Force reconstruction via maximum-likelihood-estimator analysis (FORMA) determines the optical trap stiffness based on estimation of the particle velocity from statistical trajectories. Using a modification of this technique, we determine the trap stiffness for a two micron particle within 2 ms to a precision of ∼10% using camera measurements at 10 kfps with the contribution of pixel noise to the signal being larger the level Brownian motion.

Strong Transient Flows Generated by Thermoplasmonic Bubble Nucleation.

The challenge of inducing and controlling localized fluid flows for generic force actuation and for achieving efficient mass transport in microfluidics is key to the development of next-generation miniaturized systems for chemistry and life sciences. Here we demonstrate a methodology for the robust generation and precise quantification of extremely strong flow transients driven by vapor bubble nucleation on spatially isolated plasmonic nanoantennas excited by light. The system is capable of producing peak flow speeds of the order mm/s at modulation rates up to ∼100 Hz in water, thus allowing for a variety of high-throughput applications.

High-speed transverse and axial optical force measurements using amplitude filter masks.

Direct optical force measurement is a versatile method used in optical tweezers experiments, providing accurate measurements of forces for a wide range of particles and trapping beams. It is based on the detection of the change of the momentum of light scattered by a trapped object. A digital micromirror device can be used to selectively reflect light in different directions using an appropriately defined mask.

Measuring local properties inside a cell-mimicking structure using rotating optical tweezers.

Exploring the rheological properties of intracellular materials is essential for understanding cellular and subcellular processes. Optical traps have been widely used for physical manipulation of micro and nano objects within fluids enabling studies of biological systems. However, experiments remain challenging as it is unclear how the probe particle's mobility is influenced by the nearby membranes and organelles.

Calibration of force detection for arbitrarily shaped particles in optical tweezers.

Force measurement with an optical trap requires calibration of it. With a suitable detector, such as a position-sensitive detector (PSD), it is possible to calibrate the detector so that the force can be measured for arbitrary particles and arbitrary beams without further calibration; such a calibration can be called an "absolute calibration". Here, we present a simple method for the absolute calibration of a PSD.

Impact of complex surfaces on biomicrorheological measurements using optical tweezers.

The characterisation of physical properties in biologically relevant processes and the development of novel microfluidic devices for this purpose are experiencing a great resurgence at present. In many of measurements of this type where a probe in a fluid is used, the strong influence of the boundaries of the volume used is a serious problem. In these geometries the proximity of a probe to a wall can severely influence the measurement.

Optical trapping of otoliths drives vestibular behaviours in larval zebrafish.

The vestibular system, which detects gravity and motion, is crucial to survival, but the neural circuits processing vestibular information remain incompletely characterised. In part, this is because the movement needed to stimulate the vestibular system hampers traditional neuroscientific methods. Optical trapping uses focussed light to apply forces to targeted objects, typically ranging from nanometres to a few microns across.

Active rotational and translational microrheology beyond the linear spring regime.

Active particle tracking microrheometers have the potential to perform accurate broadband measurements of viscoelasticity within microscopic systems. Generally, their largest possible precision is limited by Brownian motion and low frequency changes to the system. The signal to noise ratio is usually improved by increasing the size of the driven motion compared to the Brownian as well as averaging over repeated measurements.

Determination of motility forces on isolated chromosomes with laser tweezers.

Quantitative determination of the motility forces of chromosomes during cell division is fundamental to understanding a process that is universal among eukaryotic organisms. Using an optical tweezers system, isolated mammalian chromosomes were held in a 1064 nm laser trap. The minimum force required to move a single chromosome was determined to be ≈ 0.

Driving corrugated donut rotors with Laguerre-Gauss beams.

Tightly-focused laser beams that carry angular momentum have been used to trap and rotate microrotors. In particular, a Laguerre-Gauss mode laser beam can be used to transfer its orbital angular momentum to drive microrotors. We increase the torque efficiency by a factor of about 2 by designing the rotor such that its geometry is compatible with the driving beam, when driving the rotation with the optimum beam, rather than beams of higher or lower orbital angular momentum.

Comparison of T-matrix calculation methods for scattering by cylinders in optical tweezers.

The T-matrix method, or the T-matrix formulation of scattering, is a framework for mathematically describing the scattering properties of an object as a linear relationship between expansion coefficients of the incident and scattering fields in a basis of vector spherical wave functions (VSWFs). A variety of methods can be used to calculate the T-matrix. We explore the applicability of the extended boundary condition method (EBCM) and point matching (PM) method to calculate the T-matrix for scattering by cylinders in optical tweezers and hence the optical force acting on them.

Equilibrium orientations and positions of non-spherical particles in optical traps.

Dynamic simulation is a powerful tool to observe the behavior of arbitrary shaped particles trapped in a focused laser beam. Here we develop a method to find equilibrium positions and orientations using dynamic simulation. This general method is applied to micro- and nano-cylinders as a demonstration of its predictive power.

Constant power optical tweezers with controllable torque.

We describe a means for controlling the spin angular-momentum flux of a laser beam at constant power, without introducing any elliptical or linear polarization. This allows a controllable torque, acting to spin the particle uniformly, to be exerted on a birefringent particle in optical tweezers. The constant power means that transverse and axial trapping, and heating due to absorption, are unaffected by changing the torque.

The effect of Mie resonances on trapping in optical tweezers.

We calculate trapping forces, trap stiffness and interference effects for spherical particles in optical tweezers using electromagnetic theory. We show the dependence of these on relative refractive index and particle size. We investigate resonance effects, especially in high refractive index particles where interference effects are expected to be strongest.