3D-printed mouthpiece adapter for sampling exhaled breath in medical applications.

The growing use of 3D printing in the biomedical sciences demonstrates its utility for a wide range of research and healthcare applications, including its potential implementation in the discipline of breath analysis to overcome current limitations and substantial costs of commercial breath sampling interfaces. This technical note reports on the design and construction of a 3D-printed mouthpiece adapter for sampling exhaled breath using the commercial respiration collector for in-vitro analysis (ReCIVA) device. The paper presents the design and digital workflow transition of the adapter and its fabrication from three commercial resins (Surgical Guide, Tough v5, and BioMed Clear) using a Formlabs Form 3B stereolithography (SLA) printer.

Antiferromagnetic ordering through a hydrogen-bonded network in the molecular solid CuF2(H2O)2(3-chloropyridine).

CuF(2)(H(2)O)(2)(3-chloropyridine) possesses a five-coordinate Cu(2+) center with a slightly distorted trigonal bypyramidal coordination geometry. Strong intermolecular F···H-O hydrogen bonds enable the formation of 2D layers and provide the primary magnetic exchange path that leads to the stabilization of long-range antiferromagnetic (AFM) order below T(N) = 2.1 K.

Utilizing insulating nanoparticles as the spacer in laminated flexible polymer solar cells for improved mechanical stability.

Roll-to-roll lamination is one promising technique to produce large-area organic electronic devices such as solar cells with a large through output. One challenge in this process is the frequent electric point shorting of the cathode and anode by the excess or concentrated applied stress from many possible sources. In this paper, we report a method to avoid electric point shorting by incorporating insulating and hard barium titanate (BaTiO(3)) nanoparticles (NPs) into the active layer to work as a spacer.