Impact of the Polymer Backbone Structure on the Separation Properties of New Stationary Phases Based on Tricyclononenes.

The main purpose of this paper is to compare the chromatographic properties of capillary columns prepared with polymers with different backbone structures and to demonstrate the possibility of polymer differentiation via inverse gas chromatography. With the use of addition and metathesis types of polymerization of tricyclononenes, two new stationary phases were prepared. The metathesis polymer contained double bonds in the polymeric backbone while the backbone of the addition polymer was fully saturated and relatively mobile.

Preparation and properties of GC capillary column with hypercrosslinked stationary phase.

For the first time, highly porous hypercrosslinked polystyrene layer was synthesized within a gas chromatography capillary column and successfully deposited onto the capillary walls generating porous layer open-tubular capillary column. Elaborated three steps synthetic procedure provides tightly bonded porous polymeric layer and ensues complete elimination of particle shedding and the needs for particle traps. Due to highly developed surface area, porous layer open-tubular column provides strong solute retention that is useful for the separation of various volatile solvents and light gas compounds including ethane, ethylene, ethyne.

Separation of polystyrenes by means of open tubular capillary chromatography.

Simulating polymer separation in flow-through channels of monolithic columns, separation of a mixture of polystyrene standards was investigated using open tubular capillary column of 2 μm inner diameter. High column efficiency was observed for polymers of molar mass ranged from few tens to few hundred kDas. Column efficiency significantly decreased for polymers with molar mass larger than 500 kDa nevertheless preserving value of few tens of thousands theoretical plates.

Enthalpy-entropy compensation effect on adsorption of light hydrocarbons on monolithic stationary phases.

Enthalpy and entropy of adsorption of light hydrocarbons C1-C4 have been measured for three monoliths of different polarity and for five different carrier gases: helium, hydrogen, nitrogen, carbon dioxide and dinitrogen oxide. Using carrier gas helium the highest values of enthalpy and entropy were observed for monolith based on ethylenedimethacrylate and the lowest values were observed for monolith based on silica, while monolith based on divinylbenzene demonstrated intermediate values. Entropy-enthalpy correlations were observed with carrier gas helium for all thee monoliths and possess similar slope indicating similar adsorption mechanism on all monoliths studied.

Comparison of nonporous silica-based ion exchangers and monolithic ion exchangers in separations of inorganic anions.

Low capacity anion exchangers for IC have been prepared by modification of nonporous uniformed silica MICRA microbeads and by modification of the organic polymeric monolithic matrixes prepared in situ in quarz capillary. Due to the small particle size (1.5 microm) high-performance adsorbents were prepared allowing to obtain up to 190,000 tp/m.

Less common applications of monoliths. III. Gas chromatography.

Porous polymer monoliths emerged about two decades ago. Despite this short time, they are finding applications in a variety of fields. In addition to the most common and certainly best known use of this new category of porous media as stationary phases in liquid chromatography, monolithic materials also found their applications in other areas.