Thermal Behavior of Ti-64 Primary Material in Electron Beam Melting Process.

The Electron Beam Melting (EBM) process has emerged as either an alternative or a complement to vacuum arc remelting of titanium alloys, since it is capable of enhancing the removal of exogenous inclusions by dissolution or sedimentation. The melting of the primary material is a first step of this continuous process, which has not been studied so far and is investigated experimentally and numerically in the present study. Experiments have been set up in a 100 kW laboratory furnace with the aim of analyzing the effect of melting rate on surface temperature of Ti-64 bars.

Toward Better Control of Inclusion Cleanliness in a Gas Stirred Ladle Using Multiscale Numerical Modeling.

The industrial objective of lowering the mass of mechanical structures requires continuous improvement in controlling the mechanical properties of metallic materials. Steel cleanliness and especially control of inclusion size distribution have, therefore, become major challenges. Inclusions have a detrimental effect on fatigue that strongly depends both on inclusion content and on the size of the largest inclusions.

Determination of ethylenediaminetetraacetic acid in nuclear waste by high-performance liquid chromatography coupled with electrospray mass spectrometry.

EDTA is a chelating agent that has been used in decontamination processes. Its quantification is required for nuclear waste management because it affects the mobility of radionuclides and metals in environment and, thus, can harm the safety of the storage. Ion-pair chromatography coupled with electrospray mass spectrometry detection is a convenient method for quantitative analysis of EDTA but EDTA should be present as a single anionic chelate form.

In situ synthesis of monolithic stationary phases for electrochromatographic separations: study of polymerization conditions.

Acrylate-based monolithic capillary columns were prepared from fused-silica capillaries using UV photopolymerization. The effect of the pretreatment of the capillary wall surface before polymerization was investigated and several procedures were compared. The columns were characterization by van Deemter curves and SEM imaging.