Graphene oxide functionalized with L-asparagine applied to crystal violet dye removal from water and wastewater.

The efficiency of graphene oxide functionalized with L-asparagine (GO@L-Asn) as adsorbent for crystal violet (CV) dye removal from water and wastewater was investigated. The surface and textural properties of this new nanomaterial were characterized by pH at point of zero charge, Fourier-transform infrared spectroscopy, scanning electron microscopy, X-ray diffraction, and Brunauer-Emmet-Teller technique. The main experimental variables involved in dye adsorption process were evaluated and optimized.

Effective removal of textile dye via synergy of adsorption and photocatalysis over ZnS nanoparticles: Synthesis, modeling, and mechanism.

In this work, we prepared sulfur-zinc nanoparticles (ZnS-TGA) functionalized with thioglycolic acid by a hydrothermal method and tested their photodegradation ability by solar irradiation. ZnS-TGA were characterized by Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), high-resolution transmission electron microscope (HR-TEM), UV-Vis spectrophotometer and photoluminescence spectroscopy. In the characterization of these nanoparticles, thioglycolic acid proved to be a strong capping ligand, with a specific surface area of 36.

Evaluation and analysis of the adsorption mechanism of three emerging pharmaceutical pollutants on a phosphorised carbon-based adsorbent: Application of advanced analytical models to overcome the limitation of classical models.

The double layer adsorption of sulfamethoxazole, ketoprofen and carbamazepine on a phosphorus carbon-based adsorbent was analyzed using statistical physics models. The objective of this research was to provide a physicochemical analysis of the adsorption mechanism of these organic compounds via the calculation of both steric and energetic parameters. Results showed that the adsorption mechanism of these pharmaceuticals was multimolecular where the presence of molecular aggregates (mainly dimers) could be expected in the aqueous solution.

In-depth study of adsorption mechanisms and interactions in the removal of pharmaceutical contaminants via activated carbon: a physicochemical analysis.

This study presents a theoretical analysis of the adsorption process of pharmaceutical pollutants, specifically acetaminophen (ATP) and diclofenac (DFC), onto activated carbon (AC) derived from avocado biomass waste. The adsorption isotherms of ATP and DFC were analyzed using a multilayer model, which revealed the formation of two to four adsorption layers depending on the temperature of the aqueous solution. The saturation adsorption capacities for ATP and DFC were 52.

Sustainable removal of caffeine and acetaminophen from water using biomass waste-derived activated carbon: Synthesis, characterization, and modelling.

The removal of caffeine (CFN) and acetaminophen (ACT) from water using low-cost activated carbons prepared from artichoke leaves (AAC) and pomegranate peels (PAC) was reported in this paper. These activated carbons were characterized using various analytical techniques. The results showed that AAC and PAC had surface areas of 1203 and 1095 m g, respectively.

Physicochemical assessment of ammonium adsorption using a palm shell-based adsorbent activated with acetic acid: experimental and theoretical studies.

The adsorption of ammonium from water was studied on an activated carbon obtained using raw oil palm shell and activated with acetic acid. The performance of this adsorbent was tested at different operating conditions including the solution pH, adsorbent dosage, and initial ammonium concentration. Kinetic and equilibrium studies were carried out, and their results were analyzed with different models.

A Network of Processes for Biorefining Burdock Seeds and Roots.

In this work, a novel sustainable approach was proposed for the integral valorisation of (burdock) seeds and roots. Firstly, a preliminary recovery of bioactive compounds, including unsaturated fatty acids, was performed. Then, simple sugars (i.

An Integrated Process Analysis for Producing Glycerol Carbonate from CO and Glycerol.

Glycerol carbonate (GC) is one of the most attractive green chemicals involved in several applications such as polymer synthesis, e. g., the production of polyurethanes and polycarbonates.

Environmental remediation of the norfloxacin in water by adsorption: Advances, current status and prospects.

Antibiotics are considered as the new generation water pollutants as these disturb endocrine systems if water contaminated with antibiotics is consumed. Among many antibiotics norfloxacin is present in various natural water bodies globally. This antibiotic is considered an emerging pollutant due to its low degradation in aquatic animals.

Sodium alginate-modified alkali-activated eggshell/FeO nanoparticles: A magnetic bio-based spherical adsorbent for cationic dyes adsorption.

Herein, a mixture of eggshell (ES) and magnetite nanoparticles (MNPs) was alkali-activated using NaOH/NaSiO solution and then, impregnated with sodium alginate (SA) to prepare a magnetic bio-based adsorbent (namely SAAES/SA/MNPs) for the decontamination of water containing basic dyes, in particular, methylene blue (MB) and crystal violet (CV). The physicochemical properties of magnetic spheres of SAAES/SA/MNPs were characterized using XRD, FTIR, FESEM, EDX, elemental mapping, TEM, and zeta potential techniques. Dye adsorption equilibrium was studied experimentally at pH 8.

Adsorption of perfluorooctanoic carboxylic and heptadecafluorooctane sulfonic acids via magnetic chitosan: isotherms and modeling.

This paper evaluates the adsorption mechanism of perfluorooctanoic carboxylic acid (PFCA) and heptadecafluorooctane sulfonic acid (HFOSA) on magnetic chitosan for the first time via a statistical physics modeling. Magnetic chitosan (MC-CoFeO) was produced from shrimp wastes and used in standard batch adsorption systems to remove PFCA and HFOSA. The experimental isotherms indicated that the maximum adsorption capacities ranged from 14 to 27.

Binary adsorption isotherms of methylene blue and crystal violet on mandarin peels: prediction via detailed multivariate calibration and density functional theory (DFT) calculations.

The multicomponent adsorption of synthetic dyes has great relevance in the treatment of effluents due to the complexity of the adsorbate-adsorbent interactions. Therefore, this study provides useful information about the adsorption capacity of methylene blue (MB) and crystal violet (CV) in a bioadsorbent (mandarin peels) in a single-component and competitive system using detailed multivariate calibration analysis. The PLS1 multivariate calibration model was used to quantify the adsorbates.

Lipid extraction in the primary sludge generated from urban wastewater treatment: characteristics and seasonal composition analysis.

A seasonal study of the lipid composition of a primary sludge (dry and dewatered base) obtained from an urban wastewater treatment plant located in Aguascalientes (Mexico) is reported. This study assessed the variability in sludge composition to establish its potential as a raw material for biodiesel production. Lipid recovery was achieved by extraction using two solvents.

Polymeric hydrogels-based materials for wastewater treatment.

Low-cost and reliable wastewater treatment is a relevant issue worldwide to reduce the concentration of environmental pollutants. Industrial effluents containing dyes, heavy metals, and other inorganic and organic compounds can pollute water resources; therefore, novel technologies are required to mitigate and control their release into the environment. Adsorption is one of the simplest methods for treating contaminated water in which a wide spectrum of adsorbents can be used to remove emerging compounds.

Valorization of biowastes for clean energy production, environmental depollution and soil fertility.

The mother earth is a source of natural resources that, in conjunction with anthropogenic activities, generates a wide spectrum of different biowastes. These biomaterials can be used as low-cost raw feedstock to produce bioenergy, value-added products, and other commodities. However, the improper management and disposal of these biowastes can generate relevant environmental impacts.

Effective removal of Cr(VI) and methyl orange by nano magnetite loaded starch/muscovite biocomposite: Characterization, experiments, advanced modeling, and physicochemical parameters interpretation.

Magnetite nanoparticles (MNPs) synthesized from heated basalt were used to support a biocomposite prepared from muscovite (Mus) and carbohydrate polymer starch (St). The developed Mus/St/MNPs composite was characterized by XRD, FTIR, FESEM, TGA, DSC, and Zeta potential techniques. This multifunctional composite showed outstanding adsorption properties for hexavalent chromium (Cr(VI)) and methyl orange (MO) removal at 25-55 °C and pH 3.

Preparation and Characterization of an Electrospun Whey Protein/Polycaprolactone Nanofiber Membrane for Chromium Removal from Water.

Chromium pollution represents a worldwide concern due to its high toxicity and bioaccumulation in organisms and ecosystems. An interesting material to remove metal ions from water is a whey-protein-based material elaborated by electrospinning, which is an emerging method to produce adsorbent membranes with diverse applications. The aim of this study was to prepare an adsorbent membrane of whey protein isolate (WPI) and polycaprolactone (PCL) by electrospinning to remove chromium ions from water.

Recent advances in aqueous virus removal technologies.

The COVID-19 outbreak has triggered a massive research, but still urgent detection and treatment of this virus seems a public concern. The spread of viruses in aqueous environments underlined efficient virus treatment processes as a hot challenge. This review critically and comprehensively enables identifying and classifying advanced biochemical, membrane-based and disinfection processes for effective treatment of virus-contaminated water and wastewater.

Synthesis and preparation of acid capped CdSe nanocrystals as successful adsorbent and photocatalyst for the removal of dyes from water and its statistical physics analysis.

In this study, mercaptosuccinic acid capped CdSe nanocrystals were successfully synthesized and used as photocatalyst for the effective removal of methylene blue (MB) inaqueous solution under visible light and sunlight irradiations including its analysis with statistical physics theory. Dye adsorption properties of these nanocrystals were investigated via experimental kinetics and equilibrium studies. These experimental data were modeled via the application of statistical physics theory to explain the corresponding adsorption mechanism and to characterize the steric and energetic parameters involved in the dye removal.

Preparation and evaluation of a coated smectite clay-based material modified with epichlorohydrin-dimethylamine for the diclofenac removal.

This study reports the analysis of diclofenac removal from aqueous solution using a novel adsorbent coating with amphoteric surface. This adsorbent coating was improved using a new amphoteric ratio to increase its performance for the removal of pharmaceuticals such as diclofenac. The adsorbent coating was formulated using acrylic polymer emulsion, smectite-based clay powder and epichlorohydrin-dimethylamine to obtain a layer form via the implementation of a facile synthesis method.

Using an enhanced multilayer model to analyze the performance of nickel alginate/graphene oxide aerogel, nickel alginate aerogel/activated carbon, and activated carbon in the adsorption of a textile dye pollutant.

This work describes the modeling and analysis of methylene blue molecule on different adsorbents, namely, nickel alginate/graphene oxide (NA/GO) aerogel, nickel alginate/activated carbon (NA/AC) aerogel, and Trichosanthes kirilowii maxim shell activated carbon (TKAC). A multilayer statistical physics model was used to calculate the energetic and steric parameters of the adsorption of methylene blue on these adsorbents. Based on the modeling investigation, it was concluded that the formation of multiple dye adsorbed layers on these adsorbents could be feasible where physical adsorption interactions could be involved.

Cellulose, clay and sodium alginate composites for the removal of methylene blue dye: Experimental and DFT studies.

Cellulose/clay/sodium alginate composites were prepared and employed for the removal of methylene blue (MB) dye. Cellulose was extracted from a paper mill waste and used for composite preparation with sodium alginate (Na-Alg) and clay. MB dye removal was analyzed at different operating conditions (pH, initial concentration, temperature, composite dose).

Understanding the Cu adsorption mechanism on activated carbon using advanced statistical physics modelling.

Adsorption modeling via statistical physics theory allows to understand the adsorption mechanism of heavy metal ions. Therefore, this paper reports the analysis of the mechanism of copper ion (Cu) adsorption on four activated carbons using statistical physics models. These models contain parameters that were utilized to provide new insights into the possible adsorption mechanism at the molecular scale.