Imaging deformation of adherent cells due to shear stress using quantitative phase imaging.

We present a platform for detecting cellular deformations from mechanical stimuli, such as fluid shear stress, using rapid quantitative phase imaging. Rapid quantitative phase imaging was used to analyze changes in the optical path length of adherent skin cancer cells during mechanical displacement. Both the whole-cell phase displacement and the resultant shift of the cellular center of mass were calculated over the duration of the stimulus.

Quantitative phase imaging with molecular sensitivity using photoacoustic microscopy with a miniature ring transducer.

We present a dual-modality system for both structural and molecular cell imaging based on coregistered quantitative phase imaging (QPI) and photoacoustic microscopy (PAM). The QPI system was based on off-axis holography, whereas the PAM system comprised a sinusoidally modulated optical source for excitation and a narrow-band low profile and low-cost ring ultrasonic transducer for detection. This approach facilitated a simple confocal alignment of the excitation beams of both modalities and the ultrasonic detector.

Fast wide-field photothermal and quantitative phase cell imaging with optical lock-in detection.

We present a fast, wide-field holography system for detecting photothermally excited gold nanospheres with combined quantitative phase imaging. An interferometric photothermal optical lock-in approach (POLI) is shown to improve SNR for detecting nanoparticles (NPs) on multiple substrates, including a monolayer of NPs on a silanized coverslip, and NPs bound to live cells. Furthermore, the set up allowed for co-registered quantitative phase imaging (QPI) to be acquired in an off-axis holographic set-up.

Photoacoustic thermal diffusion flowmetry.

Thermal Diffusion Flowmetry (TDF) (also called Heat Clearance Method or Thermal Clearance Method) is a longstanding technique for measuring blood flow or blood perfusion in living tissues. Typically, temperature transients and/or gradients are induced in a volume of interest and the temporal and/or spatial temperature variations which follow are measured and used for calculation of the flow. In this work a new method for implementing TDF is studied theoretically and experimentally.

Simultaneous spatial and spectral mapping of flow using photoacoustic Doppler measurement.

We demonstrate the use of tone-burst excitation and time-gated spectral analysis for photoacoustic Doppler mapping of flow in an unperturbed vessel phantom and in a vessel with a spatially varying lumen. The method, which mimics pulsed Doppler ultrasound, enables simultaneous measurement of axial position and flow as well as complete characterization of the Doppler spectrum over a wide range of mean velocities (3.5 to 200 mm∕s).

Photoacoustic Doppler measurement of flow using tone burst excitation.

In this paper a novel technique for flow measurement which is based on the photoacoustic (PA) Doppler effect is described. A significant feature of the proposed approach is that it can be implemented using tone burst optical excitation thus enabling simultaneous measurement of both velocity and position. The technique, which is based on external modulation and heterodyne detection, was experimentally demonstrated by measurement of the flow of a suspension of carbon particles in a silicon tube and successfully determined the particles mean velocity up to values of 130 mm/sec, which is about 10 times higher than previously reported PA Doppler set-ups.

The use of pulse synthesis for optimization of photoacoustic measurements.

In this paper the use of pulse shaping in photoacoustic (PA) measurements is presented. The benefits of this approach are demonstrated by utilizing it for optimization of either the responsivity or the sensitivity of PA measurements. The optimization is based on the observation that the temporal properties of the PA effect can be represented as a linear system which can be fully characterized by its impulse response.